Home > Zanussi > Washing Machine > Zanussi Zwf 1238 User Manual

Zanussi Zwf 1238 User Manual

Here you can view all the pages of manual Zanussi Zwf 1238 User Manual. The Zanussi manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.

Page 21

After removing all the
packaging, carefully lay
machine on its back to re-
move the polystyrene
base from the bottom.Remove the power supply
cable and the hoses from
the hose holders on the
rear of the appliance.
Unscrew the three bolts.Slide out the relevant plas-
tic spacers.
Open the porthole and re-
move the polystyrene
block fitted on the door
seal.Fill the smaller upper
hole and the two large
ones with the correspond-
ing plastic plug caps sup-
plied in the bag contain-
ing the instruction book-...

Page 22

The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the
hose to the left or right depending on the position of
your water tap. Set the hose correctly by loosening
the ring nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent leaks.
Caution!  The inlet hose must not be lengthened.
If it is too short and you do not wish to move the
tap, you will have to purchase a new, longer...

Page 23

If the outlet spigot has
not been used before, re-
move any blanking plug
that may be in place.Push the drain hose onto
the spigot and secure
with a clip, ensure a loop
is formed in the drain
hose (see above) to pre-
vent waste from the sink
entering the appliance.
If you intend to drain the hose from the machine into
a sink, make sure that the sink is empty and the plug
hole is not blocked. Use the plastic “U - Piece” sup-
plied.
Special conditions
If the floor is carpeted or covered with crumbly or...

Page 24

1
234
1Green & Yellow
2Brown
3Cord clamp
4Blue
The wire coloured green and yellow must be connected
to the terminal marked with the letter «E» or by the
earth symbol 
 or coloured green and yellow.
The wire coloured blue must be connected to the termi-
nal «N» or coloured black.
The wire coloured brown must be connected to the ter-
minal marked «L» or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
the outer sheath.
Warning!  A...

Page 25

 25
 

Page 26

26
 
 

Page 27

 27
 

Page 28

 www.zanussi.com/shop
   
192994972 - 00 - 182010
 
Start reading Zanussi Zwf 1238 User Manual

Related Manuals for Zanussi Zwf 1238 User Manual

All Zanussi manuals