Zanussi Zkg 2125 User Manual

ProblemPossible cause/Solution
Spinning starts late or the machine
does not spin:
The electronic unbalance detection device has cut in because the laundry is
not evenly distributed in the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several times before the unbalance
disappears and normal spinning can resume. If, after 10 minutes, the laundry
is still not evenly distributed in the drum, the machine will not spin. In this
case, redistribute the load manually and...

Electrical connection
Voltage - Overall power - FuseInformation on the electrical connection is given on the rating plate, on the
inner edge of the appliance door.
Water Supply PressureMinimum
Maximum0,05 MPa
0,8 MPa
Maximum LoadCotton6 kg
Maximum Dry LoadCotton
Cotton Big Capacity
Synthetic3 Kg
4 Kg
2 Kg
Spin SpeedMaximum1200 rpm
Consumption values
ProgrammeEnergy consumption
(KWh)Water consumption (litres)Programme duration (Mi-
nutes)
White Cottons 90°2.061
For the duration of the pro-
grammes, please...

After removing all the
packaging, carefully lay
machine on its back to re-
move the polystyrene base
from the bottom.Remove the power supply
cable and the hoses from
the hose holders on the
rear of the appliance.
Unscrew the three bolts.Slide out the relevant plas-
tic spacers.
Open the porthole and re-
move the polystyrene
block fitted on the door
seal.Fill the smaller upper hole
and the two large ones
with the corresponding
plastic plug caps supplied
in the bag containing the
instruction booklet....

The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the hose
to the left or right depending on the position of your
water tap. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to tighten
the ring nut again to prevent leaks.
Caution!  The inlet hose must not be lengthened. If
it is too short and you do not wish to move the tap,
you will have to purchase a new, longer...

If the outlet spigot has not
been used before, remove
any blanking plug that
may be in place.Push the drain hose onto
the spigot and secure with
a clip, ensure a loop is
formed in the drain hose
(see above) to prevent
waste from the sink enter-
ing the appliance.
If you intend to drain the hose from the machine into a
sink, make sure that the sink is empty and the plug hole
is not blocked. Use the plastic “U - Piece” supplied.
Special conditions
If the floor is carpeted or covered with crumbly or soft...

Environmental concerns
The symbol    on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed...

 27
 

www.zanussi.com
132951860 - 00 - 302009