Zanussi Zkg 2125 User Manual

Oil based paint: moisten with benzine stain remover, lay
the garment on a soft cloth and dab the stain; treat several
times.
Dried grease stains: moisten with turpentine, lay the gar-
ment on a soft surface and dab the stain with the fingertips
and a cotton cloth.
Rust: oxalic acid dissolved in hot water or a rust removing
product used cold. Be careful with rust stains which are
not recent since the cellulose structure will already have
been damaged and the fabric tends to hole.
Mould stains: treat with...

Before starting the drying programme, reduce the loads
of washed laundry, in order to obtain good performances.
Laundry not suitable for drying
• Particularly delicate items such as synthetic curtains,
woollen and silk, garments with metal inserts, nylon
stockings, bulky garments such as anoraks, bed cov-
ers, quilts, sleeping bags and duvets must not be ma-
chine dried.
• Avoid drying dark clothes with light coloured fluffy
items such as towels as these can attract the fluff.
• Remove the laundry when...

there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
and not to worry that children might be injured by or cause
damage to the appliance. This function remains enabled
also when the washing machine is not working.
There are two different ways to set this option:
1. Before pressing button 7 : it will be impossible to start
the machine.
2. After pressing button 7 : it will be impossible to...

If you have chosen a delayed start, the machine will begin
the countdown.
Important!  If an incorrect option is selected, the message
Err  is displayed for a few seconds and the red pilot light
of this button blinks 3 times.
Select the Delay Start by pressing button 8
Before you start the programme, if you wish to delay the
start, press this button to select the desired delay.
The selected delay time value will appear on the display
for a few seconds, then the duration of the programme
will appear...

Stand By : If your laundry is not removed within 10 mi-
nutes after the programme is finished, the back light of
the display switches off and the energy saving system will
be enabled. Only the pilot light of the button 7 is blinkingto indicate that the appliance has to be switched off. By
pressing any button the appliance will come out from the
energy saving status and you can set another programme
or switch the appliance off.
Use - Drying
Drying only
The recommended load size is 3 kg for cottons and...

6. Start the programme by pressing button 7 . After the
programme has started, the time remaining is upda-
ted every minute.
7. At the end of the programme the buzzer sounds. A
flashing zero « 
 » appear on the display. At this
point of the programme, starts an anti-crease phase
which lasts about 10 minutes. During this time the
door is locked and the display keeps showing the
flashing zero «  ». (If you wish to open the door
before or during the anti-crease phase, please follow
the instructions given in...

Place a bowl with a small
edge close to the pump to
collect any spillage.
Pull out the emergency
emptying cap from the fil-
ter cover, using a pliers.
12
When no more water
comes out, unscrew the
pump cover, using a pli-
ers, and remove the filter.
Always keep a rag nearby
to dry up spillage of water
when removing the cover.
Remove any objects from
the pump impeller by ro-
tating it.
Replace the filter into the pump paying attention to in-
sert it properly. When done, screw it firmly.
Replace the...

• Unscrew the hose from the machine. Keep a rug
nearby because some water may flow.
• Clean the filter in the valve with a stiff brush or with
the piece of cloth.
35°
45°
• Screw the hose back to the machine and make sure
the connection is tight.
• Turn on the water tap.
Frost precaution
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the inlet hose in a bowl placed on the
floor, open the...

ProblemPossible cause/Solution
The machine does not start:
The door has not been closed. 
• Close the door firmly.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the button 7 has not been
pressed.
• Please turn the selector dial and press the button 7 again.
The delay start has...

ProblemPossible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent (creates too much foam) has been
used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fittings. It is not
always easy to see this as the water runs down the hose; check to see if it is
damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Replace it with a new one.
The emergency emptying cap has not been...