Zanussi Zi 9225 Instruction Booklet

11
ZI 9155 ZI 9225
POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz 220-240 V / 50 Hz
TOTAL POWER ABSORBED 100 W 140 W
AVERAGE DAILY UNITS ELECTRICITY
(*)0,49 kWh 0,53 kWh
GROSS CAPACITY 158 l 230 l
NET CAPACITY 154 l 228 l
(*) This figure is based on standard test results in accordance with European Standard EN153. Actual
consumption will depend on how the appliance is used and where it is located.
Technical specifications
Warning
IF YOU ARE  DISCARDING AN  OLD
APPLIANCE THAT HAS A LOCK OR CATCH
ON...

12
Door reversal
The applianceÕs door has been locked in position for
transport by means of pins on both sides. According
to the door opening direction, remove relevant pins
at the top and at the bottom.
Attention
After completion of the door reversing
operation, check that the door gasket adheres
to the cabinet. If the ambient temperature is
cold (i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate
this process by...

13
If you fit your own plug, the colours of the wires in the
mains lead of your appliance, may not correspond
with the markings identifying the terminals in your
plug, proceed as follows:
Connect the Green and the Yellow (earth) wire to the
terminal in the plug which is marked with the letter
ÇEÈ or the earth symbol  , or coloured green and
yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter ÇNÈ or coloured
black.
Connect the brown (live) wire to the...

Dimensions of the recess
ZI 9155ZI 9225
Height of housing (1) mm  8801225
Depth of housing (2) mm  550 550
Width of housing (3) mm  560 560
It is necessary that the cabinet has a ventilation
recess with the following dimensions:
Depth 50 mm Width 540 mm
Building in
PR0
540
50
3
21
For appropriate venting, follow indications in the
figure.
50 mm
min.
200 cm2
200 cm
2
min.
D526
D022
1
2
1.Push the appliance into the housing until stop strip
touches the kitchen unit.
14
2.Press in the joint covers between...

15
PR266
AB
C
D
6.Place guide (A) on the inside part of the furniture
door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws
supplied.
20mm
A
50mm
PR166
PR33/2
C
A
8.Open the appliance door and the furniture door at
90¡. Insert the small square (B) into guide (A). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure. 
Remove the squares and drill holes with ¯ 2 mm
at 8 mm...

© Electrolux plc 2004923631675 / 923527614