Yamaha Ysp1 Service Manual

YSP-1
11
YSP-1
Installation of Driver (Tweeter)
Caution : Make sure that all the removed Driver (tweeter)
parts are reinstalled at specified positions.
(Fig. B)
µÐ”§”âÇ¿Ä¢À ”»”£w	

YSP-1
12
YSP-1
DD
E E
B B
CC CC
Side Cover L
± Å§Ì”-
Side Cover R
± Å§Ì”3
Plate Side
Óè”Ä—± Å Plate Side
Óè”Ä—± Å Plate Cover
Óè”Ä—§Ì”
Plate Cover
Óè”Ä—§Ì” Front Grille
ÑéïĬæçDriver, Woofer

Driver, Woofer

7. Removal of Driver (Woofer)
a. Remove 4 screws (B). (Fig. 12)
b. Remove the Side covers L/R.
c. Remove the Plate/Cover.
d. Remove 4 screws (C). (Fig. 12)
e. Remove the Plate/Side.
f. Remove 18 screws (D). (Fig. 12)
g. Remove the Front grille.
h....

YSP-1
13
YSP-1
~34$

YSP-1
14
YSP-1
Ô 
â^MO
$16w	Ôù
 1$tMBTI4UBFYF

YSP-1
15
YSP-1


YSP-1
16
YSP-1
 For DSP
1. Install spDownloader_2_0_7_xxx.exe into the PC.
2. Before turning on the power to YSP-1 and PC, connect
between RS232C ports with the RS232C cable (cross
cable). (Fig. 1)
3. Connect the power cable of YSP-1 to the AC outlet.
While pressing the “VOL+” key and “VOL-” key of the
YSP-1, press the “STANDBY/ON” key of the remote
controller to activate the DIAG function.
1Using the “UP” or “DOWN” key of the remote
controller, select the DIAG menu in the figure below.

%41w	

YSP-1
17
YSP-1
Select the port of RS-232C

€`oM”34$ٔě
¬R`‡b
Select SPCM Protocol
41$.Óéįç›
¬R`‡b
5. Select the data to be transmitted and port.
· COM Port
Select the port of RS-232C.
· D/load Protocol
Select “SPCM Protocol” 

YSP-1
18
YSP-1
Confirm “OK”
 0,¡pK”\q›¬Ý`‡b
3After downloading sccessfully, “Download ‘*****’ OK”
is appeared.
Confirm “DLOAD OK” on the Serial Log window.3
	{V

YSP-1
19
YSP-1
1Using the “UP” or “DOWN” key of the remote
controller, select the DIAG menu in the figure below.

YSP-1
20
YSP-1
SELF DIAGNOSIS FUNCTION (DIAG) / ×~

…;ó¢¼ ž¬£
There are 14 DIAG menu items, each of which has sub-
menu items. Listed in the table below are menu items and
sub-menu items.