Yamaha Tyros 1 User Manual

Style Creator (Digital Recording)
Reference
121TYROS Owner’s Manual119
 SOURCE ROOT/CHORD
These settings determine the original key of the source pattern (i.e., the key used when recording the pattern). The default 
setting of CM7 (with a Source Root of “C” and a Source Type of “M7”), is automatically selected whenever the preset 
data is deleted prior to recording a new style, regardless of the Source Root and Chord included in the preset data. When 
you change Source Root / Chord from the default CM7...

Style Creator (Digital Recording)
Reference
122TYROS Owner’s Manual120
 HIGH KEY
This sets the highest key (upper octave limit) of the note transposition for the chord root change. Any notes calculated to be higher than 
the highest key are transposed down to the next lowest octave. This setting is available only when the NTR parameter (page 121) is set 
to “Root Trans.”
 NOTE LIMIT
This sets the note range (highest and lowest notes) for voices recorded to the style channels. By judicious setting of...

Style Creator (Digital Recording)
Reference
123TYROS Owner’s Manual121
• The Initial Setup area from 1|2|000 through 1|4|479 is used 
for voice and effect settings. Do not include note event data. 
• The Main A data begins at 2|1|000. Any number of measures 
from 1 to 255 can be used.
• Fill In AA begins from the top of the measure following the last 
measure of the Main A pattern. In the chart this is 4|1|00, but this 
is only an example and the actual timing will depend on the 
length of Main A. Please...

Reference
124TYROS Owner’s Manual122
Quick Guide on page 38The Multi Pads
Basic information about how to play the Multi Pads is explained in the “Quick Guide.” This section covers how the Multi 
Pad data is managed on the Open/Save display and how to create (record) Multi Pad data.
Multi Pad Editing using the Open/Save display
Multi Pads are grouped in Banks or four each and handled as files from the Open/Save display.
Multi Pad Creating/Editing (Digital Recording)
The Multi Pad Creator lets you create...

The Multi Pads
Reference
125TYROS Owner’s Manual123
 Multi Pad Realtime Recording............................................................................................
The explanations here apply when you call up the RECORD page in step #4 of the Basic Procedure on 
page 124.
 Repeat On/Off
If the Repeat parameter is on for the selected pad, playback of the corresponding pad will continue 
until the MULTI PAD [STOP] button is pressed. When you press the Multi Pads of which the Repeat 
is turned...

Reference
126TYROS Owner’s Manual124
Quick Guide on page 40Music Finder
This section briefly shows how to create and edit Music Finder records, and gives information about the structure and 
organization of Music Finder data.  For basic instructions on using Music Finder, see the “Quick Guide.”
Music Finder Record Editing
From the [MUSIC FINDER] → RECORD EDIT display, you can call up existing records and edit them to suit your preferences. 
You can even use this to create your own Music Finder records...

Music Finder
Reference
127TYROS Owner’s Manual125
 Restoring the Factory-programmed Music Finder.....................................................
The operation below lets you restore the TYROS’ Music Finder to its original factory settings. 
 Calling up Music Finder files saved to User or Disk drive.....................................
You can call up Music Finder data saved to any of the installed drives by the following procedure.
LP FUNCTIONSOUNCREAMENU
23
4
1
Press the [FUNC-
TION] button....

Reference
128TYROS Owner’s Manual126
Quick Guide on page 51Registration Memory
Basic instructions on using the Registration Memory are explained in the “Quick Guide.” This section gives detailed 
information on the Freeze and Registration Sequence functions not covered in the “Quick Guide.”
 About User Voices and Registration Memory.......................................................................................
When you memorize a panel setup to Registration Memory that uses a User voice (on the...

Registration Memory
Reference
129TYROS Owner’s Manual127
3Program the Registration Sequence. 
4After setting the REGISTRATION SEQUENCE ENABLE to on, press the [EXIT] button 
to return to the Main display and confirm whether the Registration Memory numbers 
are called up according to the sequence programmed above.
• Use the [NEXT] button to call up the Registration Memory numbers in the order of the sequence, 
or use the [BACK] button to call them up in reverse order.  The [BACK]/[NEXT] buttons can only...

Reference
130TYROS Owner’s Manual128
Quick Guide on page 46Using a Microphone
Connect a microphone to the TYROS and take advantage of the following features:
 Song Score and Lyrics display (pages 88, 90) — for ease in following along with a song.
 Guide (page 48) — for practicing your singing and learning the proper pitches.
 Vocal Harmony (page 47) — for automatically adding harmony vocals to your voice.
 Talk (page 132) — for instantly changing the microphone settings, for making announcements...