Yamaha Projector Dpx 1300 User Manual

57
Reference
11
English
◆DVI Format  (RGB signals input from the DVI jack)
◆PC Format(Analog RGB PC signals received at the INPUT A or B jack)
(*1) VESA is a registered trademark of the Video Electronics Standards Association.
(*2) Macintosh is a registered trademark of the Apple Computer corporation.
1280
720
f (H)
(kHz)f (V)
(Hz)Component typeSignal typeV active
(lines)H active
(pixels)
31.46959.940RGBVGA/60Hz480640
37.87960.317RGBSVGA/60Hz600800
48.36360.004RGBXGA/60Hz7681024
SXGA/60Hz
480p...

58
Maintenance
◆ Regular care
Be sure to disconnect the power cable before doing any maintenance.

Wipe with a soft cloth. Use a damp cloth with a mild detergent and then wipe with a dry cloth again if the unit is heavily soiled. Do not use
strong solvents such as thinner or alcohol as they may damage the unit casing.

Use commercially available blowers or lens tissue to remove any dirt from the lens.

If dust accumulates on the ventilation port filter, the internal temperature of the unit rises, which...

59
Reference
11
English
◆ Replacing the lamp
The lamp used as a light source in the DPX-1300 is a consumable item which will gradually lose its brightness during the course of use. It is
advisable to replace the lamp when running time has exceeded 2000 hours.
You can check the lamp running time in the [Lamp Running Time] in the [Initial] menu group of the Menu screen. The LAMP warning
indicator will blink when running time exceeds 2000 hours.
There will also be a message displayed on the screen. In this...

60
Troubleshooting
Troubleshooting
CauseRemedyProblem
Image is unstable.
The image becomes
cloudy.
Cannot adjust focus or
zoom, or the vertical
position of the lens.
There is condensation on the DPX-1300.
[Lens Adjustment Lock] in the menu is set
to ON.
Switch the DPX-1300 power off until the
condensation disappears.
Set correctly.
Set [Lens Adjustment Lock] to off.
Press the MENU button to display the menu
and select [Setup] 
 [Lens Adjustment
Lock].
The connection cables are not correctly
attached to...

61
Reference
11
English
CauseRemedyProblem
FAN warning indicator
lights up.
TEMP warning indicator
lights up.
COVER warning
indicator lights up.
LAMP warning
indicator lights up or
blinks.
The fan is broken.
The temperature inside the DPX-1300 is
extremely high.
The filter cover is not correctly attached.
The lamp cover is not correctly attached.
Lamp running time has exceeded 2000
hours.
The lamp has burned out.
Contact the store where the DPX-1300 was
purchased.
Check that the ventilation slots are...

62
Message display
MessageCondition
No Signal
Memory 1—6 Now Processing
The lamps has reached its recommended
replacement time. Please replace with a new
one.
Invalid Operation
Lens Adjustment is locked.
INPUT A (Component) (Example)
Auto Sync...
Out Of Range
Unknown Format
Press again to enter standby.
The memory setting number is displayed for two seconds.
This message is displayed when the power switch is turned on if the lamp running time
exceeds 2000 hours. Press the ESCAPE button to remove the...

63
Reference
11
English
LED indicator meanings
(*) This LED is also present on the front panel of the main unit.
LED indicatorState
Unlit
Lit red
Blinking green
Meaning
Lit green
Blinking red
Blinking red / blinking
red rapidly
Unlit
Lit red
Unlit
Lit red
Unlit
Lit red
Unlit
Lit red
Blinking red
STANDBY/ON (*)
LAMP
COVER
TEMP
FA N
Electrical fault.
Standby
Preparing for operation.
Operating
Cooling the lamp.
Blinking red: Error in the LAMP/COVER/TEMP system
Blinking red rapidly: Error in the FAN system...

64
Specifications
Usable temperature range
Usable humidity range
Power supply
Power consumption
Power consumption in standby mode
Noise level
Dimension
Weight
5 °C – 35 °C
30 % – 85 %(There should be no condensation)
AC100 – 120 V/220 – 240 V, 50/60 Hz
395 W
0.1 W – 0.2 W
30 dB(Standard mode), 28 dB(When Lamp Power Mode is set to 80)
495(W) x 192.6(H) x 465.4(D) mm
14.0 kg
• General
Wireless remote
Wired remote1 in front, 1 at rear
1 input jack, 1 output jack
Remote
TriggerRS-232C (D-sub 9 pins)
+12...

65
Reference
11
EnglishSpecifications are subject to change without notice.
•This unit may interfere with reception if placed in close proximity to a radio or television receiver. Follow the instructions in this
manual to install the unit correctly.
STANDBY/ON
SETTING
LAMP COVER TEMP FAN PATTERN
ESCAPE MENU
INPUTDIGITAL CINEMA PROJECTOR DPX-1000ASPECT
HDMI DVI
G/Y B/P
B/CBR/PR/CRINPUT A
HD/SYNC
VDOUT IN
REMOTE
TRIGGER OUT
S VIDEO
VIDEO
INPUT B
RGB/YPBPR/YCBCR
RS-232C
D4 VIDEO
465.4
18-5/16
124.6
4-7/8...

YAMAHA  ELECTRONICS  CORPORATION,  USA  6660  ORANGETHORPE  AVE.,  BUENA  PARK,  CALIF.  90620,  U.S.A.
YAMAHA  CANADA  MUSIC  LTD.  135  MILNER  AVE.,  SCARBOROUGH,  ONTARIO  M1S  3R1,  CANADA
YAMAHA  ELECTRONIK  EUROPA  G.m.b.H.  SIEMENSSTR.  22-34,  25462  RELLINGEN  BEI  HAMBURG,  GERMANY
YAMAHA  ELECTRONIQUE FRANCE  S.A.  RUE  AMBROISE  CROIZAT  BP70  CROISSY-BEAUBOURG  77312  MARNE-LA-VALLEE  CEDEX02,  FRANCE
YAMAHA  ELECTRONICS  (UK)  LTD.  YAMAHA  HOUSE,  200  RICKMANSWORTH  ROAD  WATFORD,  HERTS...