Yamaha Lpx 510 User Manual

58
Optional Accessories
The following options are available for using with the projector. The availability of these options is subject 
to change without prior notice.
* A special method of installation is required in order to suspend the projector from the ceiling. Please 
contact the place of purchase if you would like to use this installation method.
Lamp cartridge PJL-520
Use as a replacement for spent lamps.
Ceiling mount bracket (for low ceilings) * PMT-L51
Use when installing the projector to a...

59
Appendices
List of Supported Signal Resolutions
Depending on the Overscansettings, the values given below will change slightly.
 :Aspect     Units: dots
 :Aspect     Units: dots
Component Video/RGB Video
SignalResolution
Aspect mode
NormalSqueezeZoomThroughSqueeze
 throughSmart Zoom
SDTV 
(480i, 60Hz)
(D1)640 × 480
(640 × 360)
(for zoom)960 × 720 1280 × 720 1280 × 720 596 × 446 794 × 446 1280 × 760
SDTV 
(576i, 50Hz)768 × 576
(768 × 432)
(for zoom)960 × 720 1280 × 720 1280 × 720 708 × 528 944 × 528...

List of Supported Signal Resolutions
60
Units: dots
MAC signals are only supported in analogue format.
correspond to input signals from the HDMI port.
It may be possible to project signals which are not listed in the above table. However, some functions may be limited in 
that case.
•
•• •640 × 480p @ 59.94/60Hz
•
•• •1280 × 720p @ 59.94/60Hz
•
•• •1920 × 1080i @ 59.94/60Hz
•
•• •720 × 480p @ 59.94/60Hz
•
•• •720 (1440) × 480i @ 59.94/60Hz
•
•• •1280 × 720p @ 50Hz
•
•• •1920 × 1080i @ 50Hz
•
•• •720 ×...

61
Appendices
Specifications
Product nameLPX-510 Home cinema projector
Dimensions440 (W) x 137 (H) x 321 (D) mm 
(17.3 (W) x 5.39 (H) x 12.6 (D) inches) (not including protruding parts)
Panel size17.8mm (0.7 inches)
Display methodPolysilicon TFT active matrix
Drive methodFull-line 12-phase block sequential writing
Resolution921,600 pixels (1280 (W) x 720 (H) dots) x 3
Focus adjustmentElectronic type
Zoom adjustmentElectronic type (approx. 1:1.5)
Lamp (light source)UHE lamp, 200 W, Model No.: PJL-520...

62
Appearance
G/YB / PE:/C E:
D4 VIDEO
HDMI
VIDEO
RS-232CS VIDEO
R/ PR:/C R:HD/SYNC VD
G/Y
B / PE:/C E:R/ PR:/C R:HD/SYNC VD
INPUT A
INPUT B
LEFTRIGHT
DOWN
STANDBY/ON
ESCAPE
PATTERN
ASPECT
LAMP/COVER
HOME CINEMA PROJECTOR LPX-510
TEMP/FANINPUTSETTING MENU UP
LENS SIFT
Units: mm Center of projector
Center of lensSurface 
of lens*Center of lens = Default lens shift position
175 321 68
87.5
80
440 137
156.5 256
300
7119.7 19.5
LPX-510_E.book  Page 62  Wednesday, January 21, 2004  10:58 AM 

63
Appendices
Part Names and Functions
Front/Top
Vertical lens adjustment dial
(p.12)
Moves the lens vertically.
Horizontal lens adjustment dial
(p.12)
Moves the lens horizontally.
Lens cap
Attach when not using the 
projector to prevent the lens from 
becoming dirty or damaged.
Remote control light-receiving 
area (
Setup Guide)
Receives signals from the remote control.
Air exhaust ventFront adjustable feet (p.12, 13)
Extend to adjust the projection angle so that 
the projector is horizontal when placed...

Part Names and Functions
64
Control Panel
[STANDBY/ON] button (p.7, 9)
Press to turn the projectors power on and off.
[ESCAPE] button (p.11, 16, 17, 38, 39)
When pressed while a menu or selection menu 
is being displayed, the screen changes to the 
previously-displayed menu.
[PATTERN] button (p.14)
Displays a selection menu for selecting a test 
pattern.
 /  /   /   buttons (p.11, 13, 14, 
16, 37, 38, 39)
Used to select menu commands and change 
adjustment values.
[ASPECT] button (p.19)
Displays a...

65
Appendices
Part Names and Functions
Rear
D4 VIDEO port (Setup Guide)
Connects to the component video ports or D 
port of other video equipment.
(Japan only)
INPUT A/INPUT B ports (Setup Guide)
Connects to the component video ports or RGB 
ports of other video equipment or to a 
computers video output port.
HDMI port (Setup Guide)
Connects to video equipment or a computer that 
is HDMI-compatible.
VIDEO port (Setup Guide)
Connects to general video ports of other video 
equipment.
S VIDEO port (Setup...

Part Names and Functions
66
 
Remote Control
Indicator
Illuminates when remote control signals are 
being output.
[Zoom] button (p.11)
Press to adjust the size of projected images.
[IRIS] button (p.17)
Press to adjust the brightness of images using 
the lens aperture.
[ESCAPE] button (p.38, 39)
When pressed while a menu or selection menu 
is being displayed, the screen changes to the 
previously-displayed menu.
[ASPECT] button (p.19)
Displays a selection menu for selecting the 
aspect.
[LIGHT] switch...

67
Appendices
Glossary
Following is an explanation of some of the terms used in this guide which may be unfamiliar or which were 
not explained in the manual itself. Further information can be obtained by referring to other commercially-
available publications.
Component 
videoVideo signals which have the video brightness signals and color signals separated, in order to provide 
better image quality.
In high-definition TV (HDTV), it refers to images which consist of three independent signals: Y...