Yamaha As701 Manual

OWNER’S MANUAL
MANUAL DE INSTRUCCIONES
Integrated Amplifier
RL 

CAUTION: READ THIS BEFORE OPERATING YOUR UNIT.
i En
1 To assure the finest performance, please read this manual 
carefully. Keep it in a safe place for future reference.
2 Install this sound system in a well ventilated, cool, dry,  clean place - away from direct sunlight, heat sources, 
vibration, dust, moisture , and/or cold. For proper 
ventilation, allow the following minimum clearances 
around this unit.
Top: 30 cm, Rear: 20 cm, Sides: 20 cm
3 Locate this unit away from  other electrical appliances,...

1 En
EnglishUSEFUL FEATURES ................................... 1
SUPPLIED ACCESSORIES......................... 1
CONTROLS AND FUNCTIONS ................. 2
Front panel ........................................................2
Rear panel .........................................................4
Remote control ..................................................6
CONNECTIONS ............................................ 9
Connecting speakers and source components ...9
Connecting power...

2 En
1A (power) switch
Turns on and off the power of this unit.
Even when this unit  is turned off, this unit consumes a small 
amount of power.
2 Power indicator
3 Remote control sensor
Receives infrared signals  from the remote control. 4
PHONES jack
Connect your headphones.
5 SPEAKERS selector
6 BASS control
Increases or decreases  the low frequency response.
The 0 position produces  a flat response.
Control range: –10 dB to +10 dB
7 TREBLE control
Increases or decreases the high frequency response....

CONTROLS AND FUNCTIONS
3 En
English
8BALANCE control
Adjusts the sound output balanc e of the left and right 
speakers to compensate  for sound imbalances.
If you rotate the BALANCE contro l to the end of L (left) or 
R (right), the opposite side of channel is muted.
9 LOUDNESS control
Retain a full tonal range at any volume level 
(see page 12).
0 INPUT selector and indicators
Selects the input source you want to listen to. The 
input source indicators light up when the 
corresponding input s ources are...

CONTROLS AND FUNCTIONS
4 En
1CD input jacks
Used to connect a CD player (see page 9).
2 PHONO jacks and GND terminal
Used to connect a turntable  that uses an MM cartridge, 
and to ground the terminal (see page 9).
3 Audio input/output jacks
Used to connect external co mponents, such as a tuner, 
etc (see page 9).
4 DIGITAL (OPTICAL) jack
Used to connect a componen t with a digital optical 
output (see page 9).
5 DIGITAL (COAXIAL) jack
Used to connect a componen t with a digital coaxial 
output (see page...

CONTROLS AND FUNCTIONS
5 En
English
0VOLTAGE SELECTOR (Gen eral model only)
Used to set to your local main voltage (see page 10).
A IMPEDANCE SELECTOR switch
Do not change the IMPEDANCE SELECTOR switch 
while the power is turned on,  as doing so may damage 
the unit.
If the IMPEDANCE SELECTOR switch may not be 
fully slid to either positi on, remove the power cable 
and slide the switch all the way to either position.
Select the switch position  according to the impedance 
of the speakers. B
AC IN...

CONTROLS AND FUNCTIONS
6 En
1Infrared signal  transmitter
Sends infrared signals.
2
A AMP
Turns this unit on, or sets it to standby mode.
3  OPEN/CLOSE
Opens/closes the disc tray of the Yamaha CD player.
Refer to the owner’s manual of your CD player for 
details.
Even when using a Yamaha CD  player, certain components 
and features may not be available.
4A CD
Turns the Yamaha CD player on, or sets it to standby 
mode. Refer to the owner’s  manual of your CD player 
for details.
Even when using a Yamaha...

CONTROLS AND FUNCTIONS
7 En
English
7VO LU ME  +/ –
Increases or decrease s the sound output level.
8 MUTE
Reduces the current volume  level by approximately 
20 dB. Press again to restore the audio output to the 
previous volume level.  Pressing the VOLUME +/– 
also cancels muting.
The input indicator on the front panel for the current 
input source blinks while the output is muted.
9 PURE DIRECT
Reproduces any input source in the purest sound 
possible (see page 12).
0 Yamaha tuner control buttons
The...

CONTROLS AND FUNCTIONS
8 En
■Installing batteries ■Operation range
Point the remote control at the remote control sensor on 
this unit and remain within  the operating range shown 
below.
■ Notes on remote co ntrol and batteries
 The area between the remote control and th is unit must be clear of large obstacles.
 Be careful not to spill water or ot her liquids on the remote control.
 Be careful not to drop the remote control.
 Do not leave or store the remote control in the following conditions:
–...