Xerox Phaser 7760GX User Manual

Clearing Paper Jams
Phaser® 7760 Color Laser Printer  6-21
Jam at Finisher Cover
Follow these steps to clear the jam.
1.Lift the finisher cover (Door 5).
2. Remove the jammed paper. 
3. Close the finisher cover (Door 5). 
7760-031
5
7760-032
7760-033
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams
Phaser® 7760 Color Laser Printer  6-22
Finisher Stacker Output Tray Jammed
Follow these steps to clear the jam.
1.Pull the jammed paper out of the stacker output tray.
2. Open the finisher door. 
3. Close the finisher door. 
7760-032
7760-075
7760-003
Downloaded From ManualsPrinter.com Manuals 

Getting Help
Phaser® 7760 Color Laser Printer  6-23
Getting Help
This section includes:
■Control Panel Messages  on page 6-23
■PrintingScout Alerts on page 6-23
■PhaserSMART Technical Support  on page 6-24
■Web Links on page 6-24
Xerox provides several automatic diagnostic to ols to help you produce and maintain print 
quality.
See also: 
Xerox Support Centre  on page 1-14
Control Panel Messages
The control panel provides you with information and troubleshooting help. When an error or 
warning condition...

Getting Help
Phaser® 7760 Color Laser Printer  6-24
PhaserSMART Technical Support
PhaserSMART Technical Support is  an automated, internet-based support system that uses 
your default web browser to send diagnostic  information from your printer to the Xerox 
website for analysis. PhaserSMART Technical S upport examines the information, diagnoses 
the problem, and proposes a solution. If the  problem is not resolved with the solution, 
PhaserSMART Technical Support assists you in opening a Service...

Phaser® 7760 Color Laser PrinterA-1
Your printer and the recommended supplies have been
 designed and tested to meet strict safety 
requirements. Attention to the  following information ensures the continued safe operation of 
your printer.
Electrical Safety
■Use the power cord supplied with your printer.
■Plug the power cord directly into a properl y grounded electrical outlet. Make sure each 
end of the cord is securely connected. If you do not know if an outlet is grounded, ask an 
electrician to...

Phaser® 7760 Color Laser PrinterA-2
The power cord is attached to the printer as a pl
ug-in device at the back of the printer. If it is 
necessary to disconnect all electrical power fro m the printer, disconnect the power cord from 
the electrical outlet.
Warning: Do not remove the covers or guards that  are fastened with screws unless you are 
installing optional equipment and  are specifically instructed to do so. Power should be OFF 
when performing these installations . Except for user-installable...

Phaser® 7760 Color Laser PrinterA-3
Operational Safety
Your printer and supplies were designed and tested  to meet strict safety requirements. These 
include safety agency examina tion, approval, and compliance w ith established environmental 
standards.
Your attention to the following safety guidelines  helps to ensure the continued, safe operation 
of your printer.
Printer Location
Place the printer in a dust-free area within a te mperature range of 50° F to 90° F (10° C to 
32° C) and within the...

Phaser® 7760 Color Laser PrinterA-4
Operational Guidelines
■Do not block or cover the slots and openings on the printer. The printer may overheat 
without adequate ventilation.
■For optimum performance, use the printer at  elevations below 2,000 m (6,562 ft.).
■Do not place the printer near a heat source.
■Do not place the printer in direct sunlight to  avoid exposure of light-sensitive components 
when the doors are open.
■Do not place the printer in lin e with the cold air flow from an air...

Phaser® 7760 Color Laser PrinterA-5
Moving the Printer
Follow these guidelines to avoid injuri ng yourself or damaging the printer:
■Turn off the printer and unplug all power cables before moving the printer.
■Always use four people to lift the printer.
■Alway lift the printer from the designated lift points.
■Do not place any food or liquids on the printer.
Caution: Damage to the printer resulting from improp er moving or failure to repackage the 
printer properly for shipment,  is not covered by the...

Phaser® 7760 Color Laser PrinterA-6
Symbols Marked on Product
The following symbols may be marked on your product.
Use caution (or draws attention to a particular 
component). See the manual(s) for information. 
Avoid pinching fingers in the printer. Use caution 
to avoid personal injury.
Hot surface on or in the printer. Use caution to 
avoid personal injury.
Do not touch.
Do not burn the item.
It may take 30 minutes for the fuser to cool down.
This product contains a laser unit. See the 
manual(s) for...