Home > Whirlpool > Dryer > Whirlpool Electronic Dryer YMED8200FC0 User Manual

Whirlpool Electronic Dryer YMED8200FC0 User Manual

Here you can view all the pages of manual Whirlpool Electronic Dryer YMED8200FC0 User Manual. The Whirlpool manuals for Dryer are available online for free. You can easily download all the documents as PDF.

Page 11

11
Promptly remove garments after cycle has completed to  
reduce wrinkling.
7.  Touch and hold START/PAUSE  
to begin cycle
Touch and hold START/PAUSE to begin the cycle.
8.  Remove garments promptly  
after cycle is finished
Changing the Sensor Cycle settings  
to increase drying time
5. Adjust cycle settings, if desired
You may adjust different settings, depending on whether you have 
selected a Sensor Cycle, Timed Cycle, or Steam Cycle (on some 
models). See the “Cycle Guide” for detailed...

Page 12

12
ADDITIONAL FEATURES
2. Align the two hooks on the front of the drying rack with the 
holes in the dryer door opening and press down fully into 
holes. Rest the rear support on the dryer back ledge.  
USING THE DRYING RACK
To purchase a drying rack for your dryer, order by calling  
1-877-944-7566. You will need your model and serial number 
and the purchase date. Remove and discard any packing  
material before use. 
Use the Drying Rack for items that you do not want to tumble 
dry, such as sweaters...

Page 13

13
CLEANING THE LINT SCREEN
Every load cleaning
The lint screen is located in the door opening of the dryer.  
The control panel has an indicator light to remind you to clean 
the lint screen after each load. When the light is flashing, clean 
the lint screen. A screen blocked by lint can increase  
drying time.
To clean:
1. Pull the lint screen straight up. Roll lint off the screen with 
your fingers. Do not rinse or wash screen to remove lint. 
Wet lint is hard to remove.
2.  Push the lint screen...

Page 14

14
SPECIAL INSTRUCTIONS FOR STEAM MODELS
Water Inlet Hose
Replace inlet hose and hose screen after 5 years of use to 
reduce the risk of hose failure. Periodically inspect and replace 
inlet hose if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hose, record the date of  replacement.
To Winterize the Dryer
1.  Unplug dryer or disconnect power.
2.  Shut off water faucet.
3.  Disconnect water inlet hose from faucet and drain.
To Use the Dryer Again
1. Flush water pipes. Reconnect...

Page 15

15
First try the solutions suggested here or visit our website at www.maytag.com/product_help –In Canada www.maytag.ca for assistance and to possibly avoid a service call. 
If you experience Possible Causes
Solution
Door not closed completely.Make sure the dryer door is closed completely.
Touch and hold START/PAUSE 2–5 seconds.
Household fuse is blown or circuit 
breaker has tripped.There may be 2 household fuses or circuit breakers for the dryer. 
Check that both fuses are intact and tight, or that both...

Page 16

16
Possible CausesSolution
Dryer Results (cont.)
The dryer is located in a room with 
temperature below 45ºF (7ºC).Proper operation of dryer cycles requires temperatures above 
45ºF (7ºC).
The dryer is located in a closet.
Closet doors must have ventilation openings at the top  
and bottom of the door. The front of the dryer requires a minimum 
of 1" (25 mm) of airspace, and, for most installations, the rear of 
the dryer requires 5" (127 mm). See the Installation Instructions.
Cycle time is too...

Page 17

17
Possible Causes
Solution
The drying cycle has been 
interrupted by a power failure.Touch and hold START/PAUSE to restart the dryer. NOTE: The 
Control Lock function may be enabled when recovering from a 
power failure. To unlock the control, touch and hold CONTROL 
LOCK for at least 3 seconds.
There may be a problem with your 
home power supply, keeping the 
dryer’s heater from turning on. The dryer will continue to run when this diagnostic code is present. 
Touch any setting or option name to clear...

Page 18

18
MAYTAG® LAUNDRY  
LIMITED WARRANTY
ATTACH YOUR RECEIPT HERE. PROOF OF PURCHASE IS  REQUIRED TO OBTAIN \fARRANTY SERVICE.
Ple\bse h\bve the followin\Ng inform\btion \bv\bil\bble \Nwhen you c\bll the 
Customer eXperience Center:
n  N\bme, \bddress, \bnd tel\Nephone number
n Model number \bnd ser\Ni\bl numbern A cle\br, det\biled description of th\Ne problemn Proof of purch\bse including de\bler o\Nr ret\biler n\bme \bnd \bddress
FIRST YEAR LIMITED WARRANTY  
(PARTS AND LABOR)
For one ye\br from the\N...

Page 19

19
SÉCURITÉ DE LA SÉCHEUSE  

Page 20

20
IMPORTANT : Pour mettre l’ancienne sécheuse au rebut ou pour la remiser, enlever la porte.  
Start reading Whirlpool Electronic Dryer YMED8200FC0 User Manual

Related Manuals for Whirlpool Electronic Dryer YMED8200FC0 User Manual

All Whirlpool manuals