Whirlpool ARC 0060 Manual

10
GBINSTRUCTIONS FOR USE
PRODUCT DESCRIPTIONPAGE11
REPLACING BULBSPAGE11
BEFORE USING THE REFRIGERATORPAGE12
SAFEGUARDING THE ENVIRONMENTPAGE12
PRECAUTIONS AND GENERAL 
RECOMMENDATIONS
PAGE12
HOW TO OPERATE THE REFRIGERATOR 
COMPARTMENT
PAGE13
HOW TO DEFROST THE REFRIGERATORPAGE14
CARE AND MAINTENANCEPAGE14
TROUBLESHOOTING GUIDEPAGE15
AFTER-SALES SERVICEPAGE15
INSTALLATIONPAGE15
ELECTRICAL CONNECTIONPAGE16
6gb33012.fm5  Page 10  Thursday, February 8, 2001  5:47 PM
 

11 A Low temperature compartment
B Low temperature compartment door
C Water collection tray
D Adjustable shelves and grids
E Crisper drawer 
F Temperature adjustment thermostat
G Rating plate (at the side of the cripser drawer)
H Adjustable foot
I Door seal spacers for transport purposes (remove and discard)
Replacing bulbs
1.Press as shown in the figure.
2.Pull towards the inside of the 
appliance.
3.Replace the bulb (max 15W).
PRODUCT DESCRIPTION
REPLACING BULBS
6gb33012.fm5  Page 11  Thursday,...

12 •Your new appliance is exclusively for 
domestic use.
•The low temperature compartment can be 
used to make ice cubes.
• Defrosting is a manual or semi-automatic 
procedure. The refrigerator compartment 
is designed for the storage of fresh food and 
beverages.
•To get the most out of your new appliance, 
read the user handbook thoroughly. The 
handbook contains a description of the 
appliance and useful tips for storing food.
•Discard the door seal spacer shown at point 
I of the figure.•Keep this...

13
Switching on the appliance
Starting up the appliance
•Plug in the appliance. 
•The inside light, where provided, switches on 
when the refrigerator door is opened.
Adjusting the temperature
Ensure the water collection tray, located 
below the low temperature compartment, 
touches the rear wall of the refrigerator unit.
The thermostat, located on the right hand side of 
the refrigerator compartment, is used to adjust 
the internal temperature.
To adjust the temperature in the refrigerator 
compartment,...

14 Defrost the appliance when the ice on the walls 
reaches a thickness of about 3 mm.
Ensure the water collection tray is empty and 
properly positioned below the low temperature 
compartment.
Semi-automatic defrost (Fig. 1)
•Press the button (A) in the middle of the 
thermostat knob and close the door. Once all 
the ice has melted, the button will return to its 
original position and the refrigerator will 
automatically start functioning again.
Manual defrost (Fig. 2)
For appliances without defrost...

15 1. The appliance is not working.
•Is there a power failure?
•Is the power cord in perfect condition?
•Is the plug properly inserted in the socket?
•Has the fuse blown?
•Is the thermostat set to z (Stop) or  
(defrost)?
2. Temperature inside the compartments is 
not low enough.
•Is the door shut properly?
•Is there an excessive frost build-up in the low 
temperature compartment ?
•Is the appliance installed near a heat source?
•Is the thermostat setting correct?
•Are the air circulation vents blocked?...

16
For Great Britain only
Warning - this appliance must be 
earthed
Fuse replacement
If the mains lead of this appliance is fitted with a 
BS 1363A 13amp fused plug, to change a fuse in 
this type of plug use an A.S.T.A. approved fuse 
to BS 1362 type and proceed as follows:
1.Remove the fuse cover (A) and fuse (B).
2.Fit replacement 13A fuse into fuse cover.
3.Refit both into plug.
Important:
The fuse cover must be refitted when changing a 
fuse and if the fuse cover is lost the plug must not 
be used...