Vivitek Qumi Q6 User Manual

ii
Preface
Copyright
©2015 Vivitek. is a trademark of Delta Electronics, Inc. Other trademarks 
are the properties of their respective owners. Values, weights and dimensions are 
approximate. Specifications are subject to change without prior notice.
Disclaimer
The information in this document is subject to change without notice. The manufacturer 
makes no representations or warranties with respect to the contents here\
of and 
specifically disclaims any implied warranties of merchantability or fitness...

iii
Important Safety Information
Important: 
It is strongly recommended that you read this section carefully before u\
sing the Qumi. 
These safety and usage instructions that will make sure you enjoy many y\
ears of safe use 
of the Qumi. Keep this manual for future reference.
Symbols Used
Warning symbols are used on the unit and in this manual to alert you of hazardous 
situations.
The following styles are used in this manual to alert you to important information.
Note: 
Provides additional information...

iv
Qumi Installation Notice
• Allow at least a 50cm clearance around the exhaust vent.
Minimum 100mmMinimum 500mm
• Make sure that the intake vents do not recycle hot air from the exhaust vent.
• When operating the Qumi in an enclosed space, make sure that the surroun\
ding air 
temperature within the enclosure does not exceed operating temperature w\
hile the 
Qumi is running, and the air intake and exhaust vents are unobstructed.
• All enclosures should pass a certified thermal evaluation to make sure...

v
Power Safety
• Only use the supplied adapter.
• Do not place anything on the cord. Place the cord where it will not be in the way of 
foot traffic.
• Remove the battery from the remote control when storing or not in use for a 
prolonged period.
Cleaning the Qumi
• Unplug the cord before cleaning. See Cleaning the Qumi on page 62.
Note: 
The Qumi will be warm after usage. Allow Qumi to cool down before storing in a 
compartment.
Regulatory Warnings
Before installing and using the Qumi, read the...

vi
Table of Contents
Preface ..................................................................................................................ii
Chapter 1  At a Glance ................................................................1
Overview ................................................................................................................1
Standard Accessories ............................................................................................3
Remote Control For HDMI...

1
Chapter 1  At a Glance
Overview
Front/Top/Right View
Keypad
                
Keypad
See Keypad - On-Screen 
Display (OSD) buttons
Cooling Vent
Do not cover
Lens
Projection LensFocus ring
Focus the projected image
Cooling Vent
Do not cover
Right Cursor
Navigate and change settings in the 
OSD
Enter Cursor
Change settings in the OSD
Left Cursor
Navigate and change settings 
in the OSD
Up Cursor
Navigate and change settings 
in the OSD
Menu
Open and exit the OSD
Down Cursor
Navigate and change settings...

2
Rear/Top/Left View
Bottom View
Audio Out
Connect an audio cable to 
speakers or headphonesDC In
Connect the supplied 
power adapter
HDMI2
Connect a HDMI cable from a 
HDMI device
HDMI1/MHL
Connect a HDMI/MHL cable 
from a HDMI/MHL device
IR Receiver
Receive IR signal from the 
remote control
USB
Connect an USB drive
Rubber Foot Pad
Stability and maintain cooling 
ventilation
Cooling Vent
Do not cover
Tripod Connecting Slot
Tripod not included 
(Remove the sticker before use)  

3
Standard Accessories
Along with the Qumi, the following accessories are included:
Remote Control 
(With one 3V CR2025 battery)
Regional Power Cord and Power Adapter
 
WARRAN TY
 
Documentation Kit 
(User Manual, Quick Start Guide, Warranty 
Card)
Cable Cores*
Standard HDMI Cable
HDMI/MHL cable
Carrying Case
Contact your dealer immediately if any items are missing, appear damaged, or if the unit 
does not work. It is recommended that you keep the original packing material should you 
ever need to return...

4
Remote Control For HDMI
Key DefineOSD OffOSD On
Power On/Off
When system is in standby: 
powers on projector
If Power Off menu is displayed: 
powers off projector
When system is active: 
opens Power Off menu
If other menu is displayed: exits 
menu and opens Power Off menu
UpN/AMoves OSD menu highlight
Media HomeReturns to Media Home 
PageReturns to Media Home page
LeftN/APerforms action indicated by menu
Enter / Play / 
PauseN/APerforms action indicated by menu
RightN/APerforms action indicated by...