ViewSonic Projector Pj1065 User Manual

ViewSonic  PJ106519
Air Filters
Cleaning Air Filters
This projector uses 2 air filters. These air filters should be 
cleaned as described below at intervals of approximately 100 
hours.
1Switch the projector power supply OFF, and remove the 
power cord from the power outlet.
2Remove the filter cover and the air filter.
3Clean the air filter with a vacuum cleaner.
4Set the air filter and the filter cover.
Replacing the Air Filter
Replace the air filter if contamination cannot be removed, or if it is...

20ViewSonic  PJ1065
TROUBLESHOOTING
OSD Message
The messages as described below may appear on the screen at power ON. Take the appropriate mea-
sures when such messages appear.
Table 9: OSD Message
NOTE: 
(*1) This message is cleared automatically after approximately three minutes, and appears every 
time power is switched ON.
(*2) The unit has a function to turn the power off which will be active when the usage time reaches 
2000 hr. However the life of lamp might be much different, so that it might...

ViewSonic  PJ106521
Indicator Message
The POWER indicator, LAMP indicator, and TEMP indicator are lit and blank as follows. Take the 
appropriate measures.
Table 10: Indicator Message
NOTE: • When the internal temperature becomes excessive, power is switched OFF automatically 
for safety reasons, and the indicator is extinguished. Set the power switch to [O] and wait for 20 
minutes until the equipment has cooled sufficiently.
POWER
indicatorLAMP
indicatorTEMP
indicatorContents
Lit 
orangeTurns off Turns...

22ViewSonic  PJ1065
Symptom
Before requesting repair, please check in the following chart. If the situation cannot be corrected, 
then contact your dealer.
Ta b l e  11 :  S y m p t o m
Symptom Possible cause Remedy Page
The power is not 
turned on.The main power switch is 
not turned on.Turn on the main power switch.
8, 9
The power cord is 
disconnected.Plug the power cord into an AC 
power outlet.
No video or audio.The input is not correctly 
set.Use the projector or remote 
control transmitter to...

ViewSonic  PJ106523
SPECIFICATIONS
Table 12: Specifications
NOTE: • These specifications are subject to change without notice.
Item Specification
Liquid crystal 
projectorPanel size 3.3 cm (1.3 type)
Drive system TFT active matrix, 1024 × 768 native
Pixels 786,432 pixels (1024 horizontal × 768 vertical)
Lens Zoom lens F = 1.7 – 2.3; f = 49.0 – 64.0 mm
Lamp 275 W UHB
Speaker 1.2 W + 1.2 W (stereo)
Power supply AC 100 – 120 V, 4.7 A / AC 220 – 240 V, 2.0 A
Power consumption 440 W
Temperature range 0 – 35°C...

24ViewSonic  PJ1065
Customer Support
For technical support or product service, see the table below or contact your reseller.
NOTE: You will need the product serial number.
Country/Region Web site T = Telephone
F = FAXEmail
United States
Canadaviewsonic.com/support
viewsonic.com/supportT:
 (800) 688-6688
F:
 (909) 468-1202
T:
 (800) 688-6688
F:
 (909) 468-1202service.us@
viewsonic.com
service.ca@
viewsonic.com
United Kingdom viewsoniceurope.comT:  
0800 833 648
F:
 (01293) 643910service.eu@...

ViewSonic  PJ106525
LIMITED   WARRANTY
VIEWSONIC Projector
What the warranty covers:
ViewSonic
® warrants its products to be free from defects in material and workmanship during the warranty period. If a 
product proves to be defective in material or workmanship during the warranty period, ViewSonic
 will at its sole option 
repair or replace the product with a like product. Replacement product or parts may include remanufactured or refurbished 
parts or components.
How long the warranty is effective:...

26ViewSonic  PJ1065
Appendix
Power Cord Safety Guidelines
Caution: 
Use a power cable that is properly grounded. Always use an AC power cord that meets your country’s safety 
standard.
AC PLUG CORD PRECAUTIONS FOR THE UNITED KINGDOM
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET THEN THE PLUG 
SHOULD BE CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED INTO AN 
APPROPRIATE...

ViewSonic  PJ106527
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency 
energy, and if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications. However, there is no...

ViewSonic Corporation