ViewSonic Nd4210w Users Guide

							ViewSonic ND4210w43
COMPLIANCE AND SAFETY NOTICES
FCC C
LASS A COMPLIANCE NOTICE (UNITED STATES)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at user’s own
expense.
You can determine whether your equipment is causing interference by turning it off. If the
interference stops, it was probably caused by this equipment or one of its peripheral devices. If
the equipment causes interference to radio or television reception, try to correct the interference
by using one or more of the following measures:
 Turn the television or radio antenna until the interference stops.
 Move the equipment to one side or the other of the television or radio.
 Move the equipment farther away from the television or radio.
 Plug the equipment into an outlet that is on a different circuit from the television or radio.
(That is, make certain the equipment and the television or radios are on circuits controlled
by different circuit breakers or fuses.)
Modifying the equipment without proper authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right
to use the equipment may be limited by FCC regulations, and you may be required to correct any
interference to radio or television communications at your own expense.
MERCURY WARNING
This product contains mercury. Dispose of in accordance to local, state and federal laws.
 
						

							44ViewSonic ND4210w
CANADIAN COMPLIANCE NOTICE
English: This digital apparatus does not exceed the Canada ICES-003 Class A limits for radio
noise emissions from digital apparatus as set out in the radio interference regulations of the
Canadian Department of Communications.
French: Le present appareil numerique nemet pas de bruits radioelectriques depassant les
limites applicables aux appareils numeriques de Canada ICES-003 Class A prescrites dans le
reglement sur le brouillage radioelectrique edicte par le Ministere des Communications du
Canada.
WARNINGThis is a Class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
GOST-R CERTIFICATION
This product is GOST-R certified.
 
						

							ViewSonic ND4210w45
EUROPEAN COMPLIANCE NOTICE
Products with the CE Marking comply with both the EMC Directive (89/336/EEC)
and the Low Voltage Directive (73/23/EEC) issued by the Commission of the
European Community. Compliance with these directives implies conformity to the
following European Norms:
 EN55022 (CISPR 22) Class A Radio Frequency Interference
 EN55024 (IEC61000-4-2, -4-4, -4-5, -4-6, -4-11)
 EN60950 (IEC950) Product Safety
WARNINGThis is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
For EU-member states only as follows
The mark shown to the right is in compliance with the Waste Electrical and
Electronic Equipment Directive 2002/96/EC (WEEE). The mark indicates the
requirement NOT to dispose the equipment as unsorted municipal waste, but
use the return and collection systems according to local law.
 
						

							46ViewSonic ND4210w
FOR TAIWAN AND OTHER TRADITIONAL CHINESE MARKETS
WARNINGThis is a Class A Information Product, when used in residential
environment, it may cause radio frequency interference, under such
circumstances, the user may be requested to take appropriate
countermeasures. Note: Product BSMI approval license number is on the
product label outside the system enclosure.
CHINA CCC MARK
WARNINGThis is a Class A Device. It may cause radio frequency interferences if used 
in residential environment, in this case, it may be required to have 
countermeasures.
CCC Class A Declaration
 
						

							ViewSonic ND4210w47
DECLARATION OF ROHS COMPLIANCE
This product has been designed and manufactured in compliance with
Directive 2002/95/EC of the European Parliament and the Council on
restriction of the use of certain hazardous substances in electrical and
electronic equipment (RoHS Directive) and is deemed to comply with
the maximum concentration values issued by the European Technical
Adaptation Committee (TAC) as shown below:
Certain components of products as stated above are exempted under the Annex of the RoHS 
Directives as noted below. Examples of exempted components are:
1. Mercury in compact fluorescent lamps not exceeding 5 mg per lamp and in other lamps not 
specifically mentioned in the Annex of RoHS Directive
2. Lead in glass of cathode ray tubes, electronic components, fluorescent tubes, and electronic 
ceramic parts (e.g. piezoelectronic devices)
3. Lead in high temperature type solders (i.e. lead-based alloys containing 85% by weight or 
more lead)
4. Lead as an allotting element in steel containing up to 0.35% lead by weight, aluminium 
containing up to 0.4% lead by weight and as a cooper alloy containing up to 4% lead by 
weight.
SubstanceProposed Maximum 
ConcentrationActual
Concentration
Lead (Pb 0.1% 
						

							48ViewSonic ND4210w
Important Safety Instructions
1. Read these instructions completely before using the equipment.
2. Keep these instructions in a safe place.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this equipment near water.
6. Clean with a soft, dry cloth. If further cleaning is required, see Cleaning the device in this guide for 
further instructions.
7. Do not block any ventilation openings. Install the equipment in accordance with the  manufacturers 
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other devices 
(including amplifiers) that produce heat.
9. Do not attempt to circumvent the safety provisions of the polarized or grounding-type plug. A polarized 
plug has two blades with one wider than the other. A grounding type plug has two blades and a third 
grounding prong. The wide blade and the third prong are provided for your safety. If the plug does not fit 
into your outlet, consult an electrician for replacement of the outlet.
10. Protect the power cord from being tread upon or pinched, particularly at the plug, and the point where 
if emerges from the equipment. Be sure that the power outlet is located near the equipment so that it 
is easily accessible.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or 
sold with the equipment. When a cart is used, use caution when moving the cart/
equipment combination to avoid injury from tipping over.
13. Unplug this equipment when it will be unused for long periods of time.
14. Refer all servicing to qualified service personnel. Service is required when the unit has been 
damaged in any way, such as: if the power-supply cord or plug is damaged, if liquid is spilled onto or 
objects fall into the unit, if the unit is exposed to rain or moisture, or if the unit does not operate 
normally or has been dropped.
15. To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. 
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids, such as 
vases, shall be placed on the apparatus.
16. Do not open it, or there may be risk of electric shock.
17. The socket-outlet shall be installed near the equipment and shall be easily accessible.
 
						

							ViewSonic ND4210w49
CLEANING THE DEVICE
1. Make sure the device is turned off.
2. Wipe the device with a clean, soft, lint-free cloth. This removes dust and other particles. If still
not clean, apply a small amount of glass cleaner with no alcohol, ammonia, benzene, paint
thinner, gasoline, or acetone onto a clean, soft, lint-free cloth, and wipe the device. NEVER
SPRAY OR POUR ANY LIQUID DIRECTLY ONTO THE DEVICE!
Disclaimer: ViewSonic is not liable for damage resulting from using any ammonia or
alcohol-based cleaners. 
DATA LOSS DISCLAIMER
Before sending the device out for service, be sure to backup all data and remove all third party software,
features, parts, options, alterations, and attachments not warranted by ViewSonic prior to sending the
product to ViewSonic for service. ViewSonic is not liable for any loss or damage to these items.
With respect to all service provided, it is your responsibility to backup the contents of your device,
including any data you have stored or software you have installed on the device. It is likely that
the contents of your device will be lost in the course of service and ViewSonic will not be
responsible for any damage to or loss of any programs, data or other information stored on any
media or any part of any Product serviced hereunder. 
IF DURING THE REPAIR OF THE PRODUCT THE CONTENTS OF THE DEVICE ARE
ALTERED, DELETED, OR IN ANY WAY MODIFIED, VIEWSONIC IS NOT RESPONSIBLE
WHATSOEVER. YOUR PRODUCT WILL BE RETURNED TO YOU CONFIGURED AS
ORIGINALLY PURCHASED (SUBJECT TO AVAILABILITY OF SOFTWARE).
 
						

							50ViewSonic ND4210w
SPECIFICATIONS
Specifications are subject to change without notice. Corporate names and trademarks stated 
herein are the property of their respective companies. 
Default resolution 1366 x 768 @ 60 Hz WXGA
Dimensions48” W) x 29” (H) x 12” (D) with stand
1243 mm (W) x 739 mm (H) x 304 mm (D) with stand
Display area 42" diagonal LCD screen
930.25 mm (H) x 523.01 mm(V)
Weight72.6 lbs (net) 90.2 lbs (gross)
33 kg (net) 41 kg (gross)
ConnectivityNetwork
RJ-45 x 2 for Daisy Chain feature
10/100 Ethernet
Audio
Audio output: 2 x RCA stereo analog
Internal analog stereo to power amp
Communication
USB x 2
Streaming protocol types HTTP, UDP, RTP, IP/TV, Local file playback
Video decoding formats MPEG-1, MPEG-2, MPEG-4, 
Macromedia Flash
Audio decoding formats MPEG-1 (Layers 1 & 2) MP3, WAV
Image file formats JPEG, PNG
Memory (RAM) 128 MB
Memory (FLASH) 64 MB
Number of colors 16.7 million (8-bit)
Power consumption 240 watts (Max.)
Power input AC 100 ~ 240 V (max) @ 50/60 Hz
Contrast ratio 1600:1 (Typical), 1200:1 (Min.)
Viewing angle Over 178° 
Operating temperature 0 ~ 40° C (32 ~ 104° F)
Regulatory approvals FCC-15A, IC, cETLus, CE, C-Tick, NOM, TUV-S Mark, CB, SASO, SABS, CCC, 
BSMI, PSB, GOST-R, RoHS
Optional accessories Wall mount kit
 
						

							ViewSonic ND4210w51
LIMITED WARRANTY
Please go to the Customer Support table in this guide for the ViewSonic website in your region to 
get warranty information.