Vidikron Projector Vision Model 50 User Manual

11Vidikron Vision Model 50 Owner’s Operating Manual

Overview
1.  Connector Panel
  See “Connector Panel” on page 14.
2.  AC Power IN Socket
3.  AC Power Switch
4.  Built-in Control Panel
  See “Built-in Control Panel” on 
 
        page 14. 
5.  Cable Access Door
  Open to access connectors.
  See “Connector Panel” on page 14.
6.  Door Release Button 7.  Cable Opening
  Pass cables through this opening.
8.  Lamp Module Cover
  Remove this cover when replacing    
  the lamp. See “Lamp Replacement”...

12Vidikron Vision Model 50 Owner’s Operating Manual

OverviewThis page is intentionally left blank. 

13Vidikron Vision Model 50 Owner’s Operating Manual

1.  LAMP LED
  Indicates the status of the lamp
  - Red when the lamp has exceeded
  its usage life or developed a problem.  
  Please contact your Vidikron  Dealer    
  for assistance.
  - Flashing Red when the fans are
  not working or the lamp cover is    
  open. Please contact your Vidikron    
  Dealer for assistance.
2.  POWER LED
  Indicates the status of the power
  - Orange when the AC power cord    
  is plugged into a wall outlet (standby...

14Vidikron Vision Model 50 Owner’s Operating Manual

Connector Panel
Controls and Functions
(G) Y(G) Y(B)PB/CBBPB/CB(R)PR/CR12V
OUT12V
OUT(R)PR/CRHHVV
To access the connector panel, press the 
door release button so it pops out. Turn 
the knob clockwise or counter-clockwise 
and pull firmly on it to open the door.
1.  HDMI (High-Definition Multimedia Interface) Input
  Digital video signal input
2.  Component (RCA Jacks)
  480i Component ( Y/CB/CR) video signal input
3.  Video (RCA Jack)
  Composite...

15Vidikron Vision Model 50 Owner’s Operating Manual

Vidikron LogoThe Vidikron logo on the front of the projector can 
be rotated to match a floor or ceiling installation. To 
rotate the logo, grip it at the sides, pull it away from 
the projector and rotate it 180 degrees.Controls and Functions
Remote Control
OFF
Press to turn off the 
projector.
ON
Press to turn on the 
projector.
COMP1 (Component 1)
Component Y/C
B/CR input.
S-VID (S-Video)
S-Video signal input.
VIDEO
Composite video signal 
input....

16Vidikron Vision Model 50 Owner’s Operating Manual

Controls and Functions
ANA (Anamorphic)
For 16:9 DVDs.
4X3 (Standard 4:3)
The input signal will be scaled 
to fit 4:3 display mode in the 
center of the screen.
L-BOX (Letterbox)
Image in letterbox format is 
enlarged to fit 16:9 full screen 
display and the upper/ lower 
portions are “blanked off.”
I-WIDE (IntelliWide)
4:3 image is enlarged NON-
linearly in horizontal direction 
to fit 16:9 full screen display.
CINEMA
Image in Letterbox mode is...

17Vidikron Vision Model 50 Owner’s Operating Manual

Control Panel / 
Remote Control 
Functions Compared The following illustration shows remote control buttons that are duplicated on the control 
panel. Some of the functions such as power ON/OFF are combined in one button on the 
control panel, however, the function is the same. This user manual describes the functions 
based on the remote control.
FOCUS+
6
9
8
74
5
1
2
3
1
892
6/87/9
4
6
7
3
2
ZOOM+
ZOOM+
FOCUS-
FOCUS-
FOCUS+
ZOOM-
ZOOM-
POWER
POWER...

18Vidikron Vision Model 50 Owner’s Operating Manual

This page is intentionally left blank.
Controls and Functions 

19Vidikron Vision Model 50 Owner’s Operating Manual

Installation
Remote ControlTo remove the battery cover, press in then pull up the small plastic clip holding the cover in 
place. Install the two AAA batteries with the correct polarity and then replace the cover.
About the Batteries
•  Make sure that the battery polarities are correct when installing the batteries.
•  Do not mix an old battery with a new one or different types of batteries.
•  If you will not use the remote control for a long time,...

20Vidikron Vision Model 50 Owner’s Operating Manual

Installation
Installation Type
Installation 
Considerations
Screen Type and Size
Proper installation of your projector will ensure the quality of your display. Whether you 
are installing a projector temporarily or permanently, you should take the following into 
account to ensure your projector per forms optimally.
Choose the installation type that best suits your needs: front or rear screen, floor mount 
or inverted mount.
Front Screen, Floor...