Vidikron Projector Vision Model 30 User Manual

11Vidikron Vision Model 30 Owner’s Operating Manual

Overview
1.  Built-in Control Panel
  See “Built-in Control Panel” on 
 
        page 14.
2.  Connector Panel
  See “Connector Panel” on page 14.
3.  AC Power IN Socket
4.  AC Power Switch
5.  Cable Access Door
  Open to access connectors.
  See “Connector Panel” on page 14.
6.  Door Release Button 7.  Cable Opening
  Pass cables through this opening.
8.  Lamp Module Cover
  Remove this cover when replacing    
  the lamp. See “Lamp Replacement”...

12Vidikron Vision Model 30 Owner’s Operating Manual

OverviewThis page is intentionally left blank. 

13Vidikron Vision Model 30 Owner’s Operating Manual

1.  FOCUS RING
  Adjust the focus of the image
  - Rotate the focus ring right or left to  
  focus the image.
2.  ZOOM RING
  Adjust the size of the image
  - Rotate right to enlarge the image.
 
  - Rotate left to reduce the image. 
3.  LAMP LED
  Indicates the status of the lamp
  - Red when the lamp has exceeded
  its usage life or developed a problem.  
  Please contact your Vidikron  Dealer    
  for assistance.
  - Flashing Red when the fans...

14Vidikron Vision Model 30 Owner’s Operating Manual

Connector Panel
Controls and Functions
To access the connector panel, press the 
door release button so it pops out. Turn 
the knob clockwise or counter-clockwise 
and pull firmly on it to open the door.
1.  S-Video (mini DIN 4-pin) Y/C (S-video) signal input
2.  12v Trigger (mini jack, diameter 5.5 mm outside, 2.5 mm inside)
  +12V output, active when the projector is turned on
3.  Video (RCA Jack)
  Composite video signal input
4.  Component (RCA...

15Vidikron Vision Model 30 Owner’s Operating Manual

EXIT
L-BOX
I-WIDECINEMAC-FILL
MEM1ISFNTISFDAYDEF
123
456
7 8
9
0
PIP PIP+
PIP-
ACTIVE
PBPVAC
LIGHT
MENU
ONOFF
COMP 1
COMP 2
S-VIDVIDEO
RGB HDHDMI
ANA4X3

Vidikron LogoThe Vidikron logo on the front of the projector can 
be rotated to match a floor or ceiling installation. To 
rotate the logo, grip it at the sides, pull it away from 
the projector and rotate it 180 degrees. Controls and Functions
Remote Control
OFF
Press to turn off the 
projector.
ON...

16Vidikron Vision Model 30 Owner’s Operating Manual

EXIT
L-BOX
I-WIDECINEMAC-FILL
MEM1ISFNTISFDAYDEF
123
456
7 8
9
0
PIP PIP+
PIP-
ACTIVE
PBPVAC
LIGHT
MENU
ONOFF
COMP 1
COMP 2
S-VIDVIDEO
RGB HDHDMI
ANA4X3

Controls and Functions
ANA (Anamorphic)
For 16:9 DVDs.
4X3 (Standard 4:3)
The input signal will be scaled 
to fit 4:3 display mode in the 
center of the screen.
L-BOX (Letterbox)
Image in letterbox format is 
enlarged to fit 16:9 full screen 
display and the upper/ lower 
portions are “blanked off.”...

17Vidikron Vision Model 30 Owner’s Operating Manual

Control Panel / 
Remote Control 
Functions Compared The following illustration shows remote control buttons that are duplicated on the control 
panel. Some of the functions such as power ON/OFF are combined in one button on the 
control panel, however, the function is the same. This user manual describes the functions 
based on the remote control.
EXIT
L-BOX
I-WIDECINEMAC-FILL
MEM1ISFNTISFDAYDEF
MENU
ONOFF
COMP 1
COMP 2
S-VIDVIDEO
RGB HDHDMI
ANA4X3...

18Vidikron Vision Model 30 Owner’s Operating Manual

This page is intentionally left blank.
Controls and Functions 

19Vidikron Vision Model 30 Owner’s Operating Manual

Installation
Remote ControlTo remove the battery cover, press in then pull up the small plastic clip holding it in place. 
Install the two AAA batteries with the correct polarity and then replace the cover.
About the Batteries
•  Make sure that the battery polarities are correct when installing the batteries.
•  Do not mix an old battery with a new one or different types of batteries.
•  If you will not use the remote control for a long time, remove...

20Vidikron Vision Model 30 Owner’s Operating Manual

Installation
Installation Type
Installation 
Considerations
Screen Type and SizeProper  installation  of  your  projector  will  ensure  the  quality  of  your  display.  Whether  you 
are  installing  a  projector  temporarily  or  permanently,  you  should  take  the  following  into 
account to ensure your projector performs optimally.
Choose the installation type that best suits your needs: front or rear screen, floor mount 
or inverted...