Toshiba Tecra 9000fru Maintenance Manual

							1. Remove two mask seals at the bottom corners of the
    display assembly using a pair of fine-tipped tweezers.2. Remove two M2.5x6 flat head brass screws securing 
    the display mask.3. There are 23  latches securing the display mask.
    Carefully insert your fingers between the mask and the    LCD panel and pry open the latches starting from the    six top latches, to the five latches on each right  
    and left sides, ending with the bottom seven latches.FL INVERTER AND 14.1” LCD REMOVAL1. Remove one M2x2.8 silver screw securing the 
    FL inverter board.2. Carefully lift up the FL inverter board and 
    disconnect the LCD/FL cable from CN1 and the
    FL cable from CN2.
3. Remove four mask seals to expose four screws 
    securing the LCD module assembly.4. Remove four M2X2.8 brass screws securing the 
    LCD module assembly.
5. Carefully rotate out the top of the LCD module
    enough to access the display cable6. Peel off the tape securing the LCD/FL cable and    disconnect the cable.7. Remove four M2x2.8 silver screws securing the 
    right and left LCD brackets.14.1” DISPLAY MASK REMOVALTOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION  TecraTM9000 Series
Latch
Mask seals
Display
mask
LCDLCD/
FL cableLCD moduleFL inverter boardM2x4
brassscrewsM2x4 
brassscrewsMask
sealsMask
sealsFL cableM2x3 silver screw