Toshiba Satellite Pro Te2300 Manual

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-2TOSHIBA TE2300 
PC cards 
The computer is equipped with a PC card expansion slot that can 
accommodate two 5 mm Type II cards or one 10.5 mm Type III card. Any 
PC card that meets industry standards (manufactured by TOSHIBA or 
other vendor) can be installed. The slots support 16-bit PC cards, 
including PC card 16’s multifunction card and CardBus PC cards.  
CardBus...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-3TOSHIBA TE2300 
Removing a PC card 
To remove the PC card, follow the steps below. 
 1.  Open the Safety Remove Hardware icon on the system tray and 
disable the PC card. 
  2.  Press the eject button of the PC card you want to remove to extend 
the button.  
  3.  Press the extended eject button to pop the card out slightly. 
  4.  Grasp the PC card and remove it....

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-4TOSHIBA TE2300 
 
1.  If you use the computer for a long time, the memory modules will 
become hot. In this case, let the memory modules cool to room temperature before you replace them. 
2.  Do not try to install a memory module with the computer turned on or 
turned off in Standby and Hibernation mode. You can damage the computer and the memory module. 
3.  If you...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-5TOSHIBA TE2300 
 
Inserting the memory module 
  8.  Seat the cover and secure it with one screw. 
  9.  When you turn the computer on, it should automatically recognize 
the total memory capacity. Use the HW Setup program to verify that 
the added memory is recognized. If it is not recognized, check the 
module’s connection. 
Removing memory module 
To remove the...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-6TOSHIBA TE2300 
 
Removing the memory module 
  7.  Seat the cover and secure it with one screw. 
Additional battery pack 
You can increase the portability of the computer with additional battery 
packs (PA3286*). If you’re away from an AC power source, you can 
replace a low battery with a fully charged one. See Chapter 6, Power and 
Power-Up Modes.  
Slim Select Bay...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-7TOSHIBA TE2300 
 
Opening the lid 
  2.  Insert the HDD and push forward to ensure a firm connection. 
 
Installing the HDD 
  3.  Close the lid and slide the lock to the lock position.  

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-8TOSHIBA TE2300 
 
Closing the lid 
For details on installing the Slim Select Bay HDD adaptor in the Slim 
Select Bay, refer to Chapter 4, Operating Basics. 
USB FDD Kit 
The 3 1/2 external FDD drive module can be connected to the USB port. 
For details on connecting the 3 1/2 external diskette drive module, refer 
to Chapter 4, Operating Basics. 
Advanced Port...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-9TOSHIBA TE2300 ■ Security lock slot 
■ Audio line-in, line-out jacks 
■ Universal Serial Bus (two) ports 
■ i.LINK (IEEE 1394) port (This port is not supported by the computer.) 
■ DVI port (This port is not supported by the computer.) 
 
1.  When a Port Replicator is connected to the computer, remove all 
cables connected to the computer. 
2.  The TE2300 does not...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-10TOSHIBA TE2300 
External monitor 
An external analog monitor can be connected to the external monitor port 
on the computer, Port Replicator. The computer supports VGA and Super 
VGA video modes. To connect a monitor, follow the steps below. 
 
If an external monitor is connected to the computer, do not connect the 
Port Replicator. First disconnect the external...

 
 
 
TE2300 Ve r s io n  1Last Saved on 21.05.2003 10:18
ENGLISH using TE2300_Onine.dot –– Printed on 27.05.2003 as  
Optional Devices
8-11TOSHIBA TE2300 
Television 
A television can be connected to the video out port on the computer. 
To connect a television, follow the steps below.  
  1.  Turn the computer off. 
  2.  Use a video cable (not supplied) to connect the television to the 
video out port. 
 
Connecting a television 
  3.  Turn the television on. 
  4.  Turn the computer on.  
PS/2 mouse...