Toshiba Satellite C55ta Manual

							Chapter 7
Appendix
Specifications This section summarizes the computer’s technical specifications.
Physical Dimensions Physical Dimensions shown below do not include parts that extend beyondthe main body. The physical dimensions may vary depending on the model
you purchased.
SizeApproximately 380 (w) x 242 (d) x 28.4/33.35 (h)
millimeters
Approximately 380 (w) x 242 (d) x 32.38/35.25 (h)
millimeters
(not including parts that extend beyond the main body).
Environmental Requirements
ConditionsAmbient temperatureRelative humidityOperating5°C (41°F) to 35°C
(95°F)20% to 80%
(noncondensing)Non-operating-20°C (-4°F) to 60°C
(140°F)10% to 90%
(noncondensing)Wet-bulb temperature29°C maximumConditionsAltitude (from sea
level)Operating-60 to 3,000 metersNon-operating-60 to 10,000 meters
maximum
Power Requirements
AC adaptor100-240V AC
50 or 60 Hz (cycles per second)
User's Manual 7-1 
						

							Computer19V DC  
External RGB monitor port pin assignment
PinSignal NameDescriptionI/O1CRVRed Video SignalO2CGVGreen Video SignalO3CBVBlue Video SignalO4ReservedReserved 5GNDGround 6GNDGround 7GNDGround 8GNDGround 9+5VPower Supply 10GNDGround 11ReservedReserved 12SDAData SignalI/O13HSYNCHorizontal Sync SignalO14VSYNCVertical Sync SignalO15SCLData Clock SignalO
I/O (I): Input to computer
I/O (O): Output from computer
AC Power Cord and Connectors The power cord’s AC input plug must be compatible with the variousinternational AC power outlets and the cord must meet the standards for
the country/region in which it is used. All cords must meet the following
specifications:
Wire size:Minimum 0.75 mm 2
User's Manual
7-2
610
15
1511  
						

							Current rating:Minimum 2.5 amperes  
Certification agencies
China:CQCU.S. and Canada:UL listed and CSA certified
No. 18 AWG, Type SVT or SPT-2Australia:ASJapan:DENANHOEurope:Austria:OVEItaly:IMQBelgium:CEBECThe Netherlands:KEMADenmark:DEMKONorway:NEMKOFinland:FIMKOSweden:SEMKOFrance:LCIESwitzerland:SEVGermany:VDEUnited Kingdom:BSI    
In Europe, two conductors power cord must be VDE type, H05VVH2-F or
H03VVH2-F and for three conductors power cord must be VDE type, H05VV-F.
For the United States and Canada, two pin plug configuration must be a 2-15P (250V) or 1-15P (125V) and three pin plug configuration must be6-15P (250V) or 5-15P (125V) as designated in the U.S. National Electricalcode handbook and the Canadian Electrical Code Part II.
The following illustrations show the plug shapes for the U.S.A. and
Canada, the United Kingdom, Australia, Europe and China.
USA
UL approved
United Kingdom
BS approved
User's Manual 7-3   
						

							Australia
AS approved
Europe
Approved by the appropriateagency
Canada
CSA approved
China
CCC approved
Information for Wireless Devices
Wireless Technology Interoperability
The Wireless LAN is compatible with other LAN systems Direct Sequence
Spread Spectrum (DSSS) /Orthogonal Frequency Division Multiplexing (OFDM) radio technology, and is compliant to:
The IEEE 802.11 Standard on Wireless LANs (Revision a/b/g/n or b/g/
n), as defined and approved by the Institute of Electrical and
Electronics Engineers.
Bluetooth ®
 Cards are designed to be interoperable with any product with
Bluetooth wireless technology that is based on Frequency Hopping Spread
Spectrum (FHSS) radio technology, and is compliant to:
Bluetooth Specification (depending on the model you purchased), as
defined and approved by the Bluetooth Special Interest Group.
Logo certification with Bluetooth wireless technology as defined by the Bluetooth Special interest Group.
This Bluetooth product is not compatible with devices using Bluetooth
Version 1.0B specifications.
The wireless devices have not completed verification of connection and
operation with all devices which are using the Wireless LAN or Bluetoothradio technology.
Bluetooth and Wireless LAN devices operate within the same radio
frequency range and may interfere with one another. If you use Bluetooth
and Wireless LAN devices simultaneously, you may occasionally
experience a less than optimal network performance or even lose your network connection.
If you should experience any such problem, immediately turn off either one
of your Bluetooth or Wireless LAN.User's Manual 7-4     
						

							Please visit http://www.pc.support.global.toshiba.com, if you have any
questions about using Wireless LAN or Bluetooth Card from TOSHIBA.
In Europe visit http://www.toshiba-europe.com/computers/tnt/bluetooth.htm
Wireless Devices and your health
Wireless products, like other radio devices, emit radio frequencyelectromagnetic energy. The level of energy emitted by Wireless productshowever is far much less than the electromagnetic energy emitted by
wireless devices like for example mobile phones.
Because Wireless products operate within the guidelines found in radio
frequency safety standards and recommendations, TOSHIBA believes
Wireless products are safe for use by consumers. These standards and
recommendations reflect the consensus of the scientific community and
result from deliberations of panels and committees of scientists who
continually review and interpret the extensive research literature.
In some situations or environments, the use of Wireless products may be
restricted by the proprietor of the building or responsible representatives of the organization. These situations may for example include:
Using the Wireless products equipment on board of airplanes, or
In any other environment where the risk of interference to other
devices or services is perceived or identified as harmful.
If you are uncertain of the policy that applies on the use of wireless devices
in a specific organization or environment (e.g. airports), you are encouraged to ask for authorization to use the Wireless device prior to
turning on the equipment.
Wireless LAN Technology The computer’s wireless communication function supports some wirelesscommunication devices.
Only some models are equipped with both Wireless LAN and Bluetooth
functions.
Do not use the Wireless LAN (Wi-Fi) or Bluetooth functionalities near a
microwave oven or in areas subject to radio interference or magnetic fields. Interference from a microwave oven or other source can disruptWi-Fi or Bluetooth operation.
Turn all wireless functionalities off when near a person who may have
a cardiac pacemaker implant or other medical electric device. Radio waves may affect pacemaker or medical device operation, possibly
resulting in serious injury. Follow the instruction for your medical
device when using any wireless functionality.
User's Manual 7-5 
						

							Always turn off wireless functionality if the computer is near automaticcontrol equipment or appliances such as automatic doors or firedetectors. Radio waves can cause malfunction of such equipment,
possibly resulting in serious injury.
It may not be possible to make a network connection to a specified network name using the ad hoc network function. If this occurs, thenew network (*) will have to be configured for all computers connected
to the same network in order to re-enable network connections.
* Please be sure to use new network name.
Security
TOSHIBA strongly recommend that you enable encryption
functionality, otherwise your computer will be open to illegal access by
an outsider using a wireless connection. If this occurs, the outsider may illegally access your system, eavesdrop, or cause the loss ordestruction of stored data.
TOSHIBA is not liable for the loss of data due to eavesdropping or
illegal access through the wireless LAN and the damage thereof.
Card Specifications
Form FactorPCI Express Mini CardCompatibilityIEEE 802.11 Standard for Wireless LANsNetwork Operating
SystemMicrosoft Windows NetworkingMedia Access
ProtocolCSMA/CA (Collision Avoidance) with
Acknowledgment (ACK)
Radio Characteristics
Radio Characteristics of Wireless LAN module may vary according to:
Country/region where the product was purchased
Type of product
Wireless communication is often subject to local radio regulations.
Although Wireless LAN wireless networking products have been designed
for operation in the license-free 2.4GHz and 5GHz band, local radio
regulations may impose a number of limitations to the use of wireless
communication equipment.
Radio FrequencyBand 5GHz (5150-5850 MHz) (Revision a
and n)
Band 2.4GHz (2400-2483.5 MHz) (Revision
b/g and n)
User's Manual 7-6 
						

							The range of the wireless signal is related to the transmit rate of the
wireless communication. Communications at lower transmit range may travel larger distances.
The range of your wireless devices can be affected when the
antennas are placed near metal surfaces and solid high-density materials.
Range is also impacted due to "obstacles" in the signal path of the
radio that may either absorb or reflect the radio signal.
Bluetooth wireless technology Some computers in this series have Bluetooth wireless communication
function which eliminates the need for cables between electronic devices such as computers, printers and mobile phones. When it is enabled,
Bluetooth provides the wireless personal area network environment which
is safe and trustworthy, that is quick and easy.
You cannot use the computer's built-in Bluetooth functions and an externalBluetooth adaptor simultaneously. For reference, Bluetooth wireless
technology has the following features:
Security
Two advanced security mechanisms ensure a high level of security:
Authentication prevents access to critical data and makes it impossible
to falsify the origin of a message.
Encryption prevents eavesdropping and maintains link privacy.
Worldwide operation
The Bluetooth radio transmitter and receiver operate in the 2.4GHz band,
which is license-free and compatible with radio systems in most countries in the world.
Radio links
You can easily establish links between two or more devices, with these links being maintained even if the devices are not within a line-of-sight ofeach other.
Radio Frequency Interference Requirements
This device is restricted to indoor use due to its operation in the 5.15 to
5.25GHz frequency range.
Radio Regulatory Information The Wireless device must be installed and used in strict accordance withthe manufacturer’s instructions as described in the user documentation that
comes with the product. This product complies with the following radio
frequency and safety standards.
User's Manual 7-7 
						

							EuropeRestrictions for Use of 2400.0-2483.5MHz Frequencies in EuropeFrance:Outdoor use
limited to 10mW
e.i.r.p. within the
band
2454-2483.5MHzMilitary Radiolocation
use.Refarming of the 2.4GHz band
has been ongoing in recent years to
allow current relaxed regulation Full
implementation planned 2012.Italy:-For private use, a general
authorization is required if WAS/
RLAN’s are used outside own
premises. For public use, a general
authorization is required.Luxembourg:ImplementedGeneral authorization required for network and service supply.Norway:ImplementedThis subsection does not apply for
the geographical area within a
radius of 20 km from the centre of
Ny-Alesund.Russian
Federation:-Only for indoor applications.   
Restrictions for Use of 5150-5350MHz Frequencies in Europe
Italy:-For private use, a general
authorization is required if WAS/
RLAN’s are used outside own
premises.Luxembourg:ImplementedGeneral authorization required for
network and service supply.
User's Manual 7-8 
						

							Russian
Federation:Limitede.i.r.p 100mW. Permitted to use only for indoor applications, closed
industrial and warehouse areas,
and on board aircraft.
1. Permitted to use for local networks of aircraft crew
service communications on
board aircraft in area of the
airport and at all stages of
flight.
2. Permitted to use for public wireless access local networks
on board aircraft during a flight
at the altitude not less than
3000m.   
Restrictions for Use of 5470-5725MHz Frequencies in Europe
Italy:-For private use, a general
authorization is required if WAS/
RLAN’s are used outside own
premises.Luxembourg:ImplementedGeneral authorization required for
network and service supplyRussian
Federation:Limitede.i.r.p 100mW. Permitted to use
only for indoor applications, closed
industrial and warehouse areas,
and on board aircraft.
1. Permitted to use for local networks of aircraft crew
service communications on
board aircraft in area of the
airport and at all stages of
flight.
2. Permitted to use for public wireless access local networks
on board aircraft during a flight
at the altitude not less than
3000m.   
To remain in conformance with European spectrum usage laws for
Wireless LAN operation, the above 2.4GHz and 5GHz channel limitations
apply for outdoor usage. The user should use the wireless LAN utility to
User's Manual 7-9 
						

							check the current channel of operation. If operation is occurring outside ofthe allowable frequencies for outdoor use, as listed above, the user must contact the applicable national spectrum regulator to request a license foroutdoor operation.
Canada - Industry Canada (IC)
This device complies with RSS 210 of Industry Canada. Operation is
subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of this device.
The term “IC” before the equipment certification number only signifies that
the Industry Canada technical specifications were met.
USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation.
Refer to the FCC information section for the detailed information.
The radiated output power of the Wireless device is far below the FCC
radio frequency exposure limits. Nevertheless, the Wireless device shall be
used in such a manner that the potential for human contact during normal
operation is minimized.
In the usual operating configuration, the distance between the antenna and
the user should not be less than 20cm. Please refer to the computer user’s manual for the details regarding antenna location.
The installer of this radio equipment must ensure that the antenna is
located or pointed such that it does not emit RF field in excess of Health
Canada limits for the general population; consult Safety Code 6, obtainable
from Health Canada’s website www.hc-sc.gc.ca
Taiwan
Article 12Without permission granted by the NCC, any
company, enterprise, or user is not allowed to
change frequency, enhance transmitting power or
alter original characteristic as well as performance to an approved low power radio frequency devices.
User's Manual 7-10