Toshiba Satellite 6000fru Maintenance Manual

							1. Remove two mask seals at the bottom corners of the
    display assembly using a pair of fine-tipped tweezers.2. Remove two M2.5x6 black flat head screws securing 
    the display mask.3. There are 23 latches securing the display mask.
    Carefully insert your fingers between the mask and the    LCD panel and pry open the latches starting from the    six top latches, to the five latches on each right  
    and left sides, ending with the bottom seven latches.FL INVERTER AND 14.1” LCD REMOVAL1. Remove one M2x4 silver screw securing the 
    FL inverter board.2. Carefully lift up the FL inverter board and 
    disconnect the LCD/FL cable from CN1 and the
    FL cable from CN2.
3. Remove four mask seals to expose four screws 
    securing the LCD module assembly.4. Remove four M2X5 silver screws securing the 
    LCD module assembly.
5. Carefully rotate out the top of the LCD module
    enough to access the display cable6. Peel off the tape securing the LCD/FL cable and    disconnect the cable.7. Remove four M2x3 silver screws securing the 
    right and left LCD brackets.14.1” DISPLAY MASK REMOVALTOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION6000 Series  Satellite ProTM
Latch
Mask seals
Display
mask
LCDLCD/
FL harnessFL inverter boardM2x5
silverscrewsM2x3
silverscrewsM2x3
silverscrewsM2x5 
silverscrewsFL cableM2x4 silver screwLCD module assy