Toshiba Satellite 1800 Maintenance Manual

							1. Remove two mask seals at the bottom corners of the 
    display assembly to expose two screws securing the     display mask.2. Remove two M2.5x6 black screws securing the display
    mask.3. There are 23 latches securing the display mask.
    Carefully insert your fingers between the display mask
    and the LCD module and pry open the latches starting 
    from the seven bottom latches, to the five latches on 
    the right and left sides, ending with the six top latches.FL INVERTER AND 13.3” LCD REMOVAL1. Peel off the glass tape securing the FL cable.
2. Remove one M2x5 brass screw securing FL inverter
    board.3. Carefully lift up the FL inverter board and disconnect
    the LCD/FL cable from CN1 and the FL cable
    from CN2.
4. Remove four mask seals to expose four screws
    securing the left and right LCD brackets.
5  Remove four M2X5 silver screws securing both
    brackets.6. Carefully rotate out  the top of the LCD module
    enough to access the display cable.
7. Peel off the tape securing the LCD/FL cable and
    disconnect the cable.8. Remove four M2x3 silver screws securing the left 
    and right LCD brackets.FIELD REPLACEABLE UNIT DOCUMENTATION  SatelliteTM1800 Series
TOSHIBA
Tough Enough for Today’s World13.3” DISPLAY MASK REMOVALLCD moduleFL inverter boardLCD/FL cableFL cableM2x3
silverscrewsM2x5 
silver screwsM2x5 brass
screwLatchMask sealsDisplay
maskLCDGlass tape 
						

							1. Remove two mask seals at the bottom corners of the
    display assembly to expose two screws securing the     display mask.2. Remove two M2.5x6 black screws securing the display
    mask.3. There are 23 latches securing the display mask.
    Carefully insert your fingers between the display mask
    and the LCD module and pry open the latches starting 
    from the bottom seven latches, to the five latches on 
    the right      and left sides, ending with the six top latches.FL INVERTER AND 14” LCD REMOVAL1. Peel off the glass tape securing the FL cable.
2. Remove one M2x5 brass screw securing FL inverter
    board.3. Carefully lift up the FL inverter board and disconnect
    the LCD/FL cable from CN1 and the FL cable 
    from CN2.
4. Remove four mask seals to expose four screws 
    securing the LCD module5. Remove four M2x5.5 silver screws securing the
    LCD module.6. Carefully rotate out the top of the LCD module 
    enough to access the display cable.
7. Peel off the tape securing the LCD/FL cable from the
    LCD module and disconnect the cable..FIELD REPLACEABLE UNIT DOCUMENTATION  SatelliteTM1800 Series
TOSHIBA
Tough Enough for Today’s World14” DISPLAY MASK REMOVALLatchMask sealsDisplay
maskLCDLCD moduleM2x5 brass screwFL inverter boardLCD/
FL cableFL cableM2x5.5 
silver screwsGlass tapeMask 
sealsMask 
sealsM2x5.5
silverscrews