Toshiba Projector Tdp B1 User Manual

							i
TABLE OF CONTENTS
Safety Instructions  iii
Introduction 1
Image Resolution  1
Compatibility 1
Unpacking the Projector  1
Usage Guidelines  3
If You Need Assistance  4
Warranty 4
Setting up the Projector  5
Connecting a Computer  7
Connecting a Video Player  9
Powering up the Projector and Adjusting the Image  11
Turning Off the Projector  12
Using the Projector  13
Basic Image Adjustment  13
Using the Remote Control  13
Adjusting the Projector  15
Using the Keypad and Remote Buttons  16
Using the On-Screen Menus  18
Display Menu  19
Audio Menu  20
Image Menu  21
Controls Menu  23
Language Menu
 25
Status Menu  26
Maintenance & Troubleshooting  27
Cleaning the Lens  27
Replacing the Projection Lamp  27
Replacing the Batteries in the Remote Control  30
Using the Kensington Lock  30
Troubleshooting 31 
						

							ii
Ta b l e  o f  C o n t e n t s
Appendix 35
Specifications 35
Accessories 36
Portable Computer Activation Chart  38
Using Video Mirroring with a PowerBook Computer  43
Projected Image Size  44
Index 45 
						

							iii
SAFETY INSTRUCTIONS
Please read and follow all safety instructions provided BEFORE
 
using your new projector. Failure to comply with safety instruc-
tions may result in fire, electrical shock, or personal injury and 
may damage or impair protection provided by equipment. Please 
save all safety instructions.
Safety Definitions:

Wa r n i n g : Statements identify conditions or practices that 
could result in personal injury.
Caution: Statements identify conditions or practices that could 
result in damage to your equipment.
Safety Symbols:
Attention:
 For information about usage of a feature, please 
refer to the User ’s Guide.
Wa r n i n g : Hot surface. Do not touch.
An arrow pointing to the lamp door on the projector.
Safety Terms:

Wa r n i n g : Don’t look directly into the lens when the lamp is 
turned on.
Wa r n i n g : To replace the lamp, turn the projector off by 
unplugging the power cord. To avoid burns, wait 30 
minutes before opening the lamp door. Follow all instructions 
provided in this User ’s Guide.
Wa r n i n g : Please use the power cord provided. Connect 
the power cord to a receptacle with a protective safety 
(earth) ground terminal.
Wa r n i n g : Refer all service to qualified service personnel. Ser-
vicing your own projector will void the warranty. See the fol-
lowing page for the customer service contact information.
Caution: Don’t block ventilation openings. 
						

							iv
Safety Instructions

Caution: Don’t set liquids on the projector. Spilled liquids may 
damage your projector.
Caution: Don’t place the projector on a hot surface or in direct 
sunlight.
Caution: Do not drop the projector. Transport the projector in a 
vendor-approved case; refer to your Toshiba dealer or 
projectors.toshiba.com for more information.
Important Operating Considerations
Do not place the projector on a tablecloth or other soft covering 
that may block the vents. In the unlikely event of the bulb ruptur-
ing, thoroughly clean the area behind the projector and discard 
any edible items placed in that area.
Customer Service
If you need assistance, contact Toshiba Technical Support.
In North America, call Toshiba’s toll-free customer service 
& technical support at 
800-457-7777 (available 24 hours a 
day, 7 days a week). 
For web-based or other electronic technical support, please 
visit Toshiba at
 support.toshiba.com.
Do not place objects in
this area behind the projector
2 
ft 
(.
6m
) 
						

							1
INTRODUCTION
The Toshiba
® TDP-B1™ is specifically designed for the mobile 
presenter. It packs XGA 1024x768 graphics with 16.7 million col-
ors into a small, 4.8 pound package. It generates crisp, clear 
images using Digital Light Processing™ (DLP) technology. The 
TDP-B1 is easy to connect, easy to use, easy to transport, and easy 
to maintain.
NOTE: The TDP-B1 automatically 
expands 640x480 and 800x600 
images to 1024x768. You can dis-
play these images at their native 
resolutions by turning off the Auto 
Resize feature. See “Auto Resize” 
on page 21 for more information.
Image Resolution
The XGA resolution of the TDP-B1’s projected image is 1024x768. 
The projector cannot compress screen resolutions above 
1024x768. If your computer ’s screen resolution is higher than 
1024x768, reset it to a lower resolution before you connect the 
projector
.
Compatibility
The projector is compatible with a wide variety of computers and 
video devices, including:
IBM-compatible computers, including portable computers, up 
to 1024x768 resolution.
Apple Macintosh and PowerBook computers up to 1024x768 
resolution.
Most standard VCRs, DVD players, camcorders and laser disc 
players.
Unpacking the Projector
The projector comes with the items shown in Figure 1. Check to 
make sure all are included. 
Contact your Toshiba dealer imme-
diately if anything is missing.
If you are experienced in setting up presentation systems, use the 
Quick Start card that was included in the shipping box. For com-
plete details on connecting and operating the projector, refer to 
this User ’s Guide. User ’s Guides are also available for download 
from our website at 
projectors.toshiba.com. 
						

							2
Introduction
NOTE: The contents of your
shipping box may vary depending
on the projector configuration
you’ve ordered.
F
IGURE 1
Shipping box contents
1. TDP-B1 projector + lens cap 6. Audio cable adapter
2. Remote control 7. Audio cable
3. Power cord 8. Composite video cable
4. User’s Guide and quick start 
card 9. PS/2 mouse cable
5.  VESA computer cable 10. USB mouse cable
1
234
5
6
78
10
9 
						

							3
FIGURE 2
Side view of projector
Usage Guidelines
 Do not look directly into the projection lens when the lamp is 
turned on. The bright light may harm your eyes.
 Do not block the grills on the projector. Restricting the air flow 
can cause it to overheat and turn off. If this happens, you must 
wait a minute before attempting to turn it back on.
 Handle the projector as you would any product with glass 
components. Be especially careful not to drop it.
 Avoid leaving the projector in direct sunlight or extreme cold 
for extended periods of time. If this happens, allow it to reach 
room temperature before use.
Transport the projector in a vendor-approved hard or soft case. 
Refer to your Toshiba dealer or 
projectors.toshiba.com for more 
information. 
connector panel speaker
focus ring
zoom ring
power
cord
connector keyp ad
Kensington Lock 
						

							4
Introduction
If You Need Assistance
The first place to look for help is in this manual. Be sure to check 
the guidelines in “Troubleshooting” on page 31. Or, check the 
Service and Support section of our website at 
support.toshiba.com. 
If those sources don’t answer your question, call your Toshiba 
dealer. You can also call Toshiba Technical Support directly. 
In North America, call Toshiba’s toll-free customer service 
& technical support at 
800-457-7777 (available 24 hours a 
day, 7 days a week). 
For web-based or other electronic technical support, please 
visit Toshiba at
 support.toshiba.com..
Warranty
This product is backed by a limited two-year warranty. The 
details of the warranty are printed at the back of this manual. A 
longer term warranty can be purchased from your Toshiba dealer. 
Refer to your Toshiba dealer or 
support.toshiba.com for more 
information. 
						

							5
SETTING UP THE PROJECTOR
1Place the projector on a flat surface.
The projector must be within 10 feet (3 m) of your power 
source and within 6 feet (1.8 m) of your computer.
If you want to project from behind a translucent screen, set 
up the projector behind your screen. See “Rear Projection” 
on page 24 to reverse the image.
2Position the projector the desired distance from the screen.
The distance from the lens of the projector to the screen and 
the zoom setting determine the size of the projected image. 
Figure 3 shows three projected image sizes. For more infor-
mation about image size, see “Projected Image Size” on 
page 44.
FIGURE 3
Projected image size at minimum zoom
3Make sure the projector is unplugged and your computer is 
turned off.
3
.2
 f
t
. 1
3.
0
 f
t
.
7
.8
 
ft
.
5 ft.12 ft.20 ft. 
						

							6
Setting up the Projector
NOTE: Before you continue,
make sure the projector is
unplugged and your equipment is
turned off. If you’re connecting a
computer, make sure the distance
between it and the projector is 6
feet or less.
F
IGURE 4
Connector panel
S-video
composite
video
Audio in
input VESA computer
mouse