Timex Intelligent Quartz All Models User Manual

1617
TO SET THE SECOND TIME ZONE:
1. Pull crown to its middle position. The upper hand 
shows the second time zone time and the 4th center 
hand shows the minutes. 
2.  Assuming that the second time zone time has the 
same minutes value as the first time zone, the 4th 
center hand should be aligned with the minute hand.  
If the hands are not aligned, or if your second time 
zone is a different minute within the hour, press 
Button B to move the 4th center hand forward until  
it is in the desired...

1819
4. To reset the fly-back chronograph to zero position, 
press Button B (FLY-BACK/RESET).
  When the chronograph is reset, all hands move to 
zero position. After another eight seconds, the watch 
resumes normal display of the second time zone.
5.  To reset and/or restart the fly-back chronograph while 
it is running, press and hold Button B (FLY-BACK/
RESET). Release it when you wish to restart.
FLY-BACK CHRONOGRAPH
The watch provides a 4-hour fly-back chronograph.
1. 
To start, press Button A...

2021
INDICATOR HAND (4TH CENTER HAND) ADJUSTMENT
To readjust a misaligned indicator hand:
1. Pull the crown to its outer position. The upper and 
lower hands reset to the ends of their sweeps 
automatically.
2.  The 4th center hand should point to 12 o’clock. If it 
does not within 5 seconds of pulling the crown to 
its outer position, press A or B to move the hand 
counterclockwise or clockwise, respectively, until it 
points to 12 o’clock.
3.  Push the crown in when done.FLY-BACK CHRONOGRAPH...

2223
2. Press B to move the 4th center hand forward. Hold the 
button to move the hand quickly. The upper and 4th 
center hands move together; as the 4th center hand 
makes one revolution, the upper hand moves one 
hour. Assuming that the second time zone time has 
the same minutes value as your first time zone, the 
4th center and minute hands should be aligned.
3.  Press A to move the upper hand forward in one-hour 
increments. Hold the button to move the hand quickly.
4.  Push the crown in when...

2425
2. To stop, press A again (START/STOP). All hands freeze.
3.  To resume, press A (START/STOP) again, or to reset the 
chronograph to zero, press B (FLY-BACK/RESET). 
  When the chronograph is reset, all hands move to 
zero. After eight seconds, the watch resumes the 
normal display of the second time zone time.
4.  You may also reset and/or restart the chronograph 
while it is running. To do so, press and hold B (FLY-
BACK/RESET) to zero the chronograph and release it 
when you wish to restart. You...

2627
COMPASS CALIBRATION
Before use, the compass must be calibrated.
Since a compass uses the earth’s magnetic field, you 
must be aware of large metallic objects, such as vehicles 
or bridges, or objects that give off electromagnetic 
radiation, such as televisions or computers, which 
could affect the magnetic field around the watch. If the 
compass is calibrated near such objects, it will only 
work properly in that same location. If the compass 
is calibrated away from such objects, it will not work...

2829
5. If you do not wish to set the magnetic declination, 
push the crown in. Otherwise, to have watch 
automatically compensate for the declination angle, 
turn the compass ring until north is at 12 o’clock.
6.  Press A or B to move the 4th center hand west (-) 
or east (+), respectively, to point to your location’s 
declination angle using the declination scale. Hold a 
button to move the hand quickly. See the figure below 
for an example. 
7.  Push the crown in when done. 
A
B
Magnetic declination...

3031
available through buttons A (START/STOP) and B (FLY-
BACK/RESET).
NOTE: During compass operation, the second hand 
moves in two-second increments. Also, when the 
compass is activated, the upper and lower hands may 
shift position slightly, returning to their proper positions 
when the compass is deactivated. This operation is 
normal and yields the most accurate compass reading.
COMPASS OPERATION
Normally, the compass is inactive, with the 4th center 
hand pointing to 12 o’clock or showing the...

3233
LINEAR CHRONOGRAPH OVERVIEWLINEAR AND 4TH CENTER HAND ADJUSTMENT 
To readjust a misaligned 4th center hand: 
1. 
Pull the crown to its outer position. The lower hand 
resets to the end of its sweep automatically. 
2.  4th center hand should point to 12 o’clock. If within 
5 seconds of pulling the crown to its outer position the 
4th center hand does not point to 12 o’clock, press 
Button A to move the hand clockwise until it points to 
12 o’clock.
3.  If the chronograph has been reset and the linear...

3435
SECOND TIME ZONE
The lower hand 
shows the time for 
the second time zone. 
Note that the scale 
is 24-hours, with 
midnight at either 
end and noon in the 
middle. Most often, 
time zones differ in 
hour increments. 
In such cases, the 
minute value of the second time zone will be the same as 
that displayed by the watch’s minute hand. TO SET THE SECOND TIME ZONE: 
1.  
Pull crown to its middle position. The lower hand 
shows the second time zone time and the 4th center 
hand shows the minutes.
2....