ThermovisionFLIR FPTSeries Payload Installation Guide

							427-0031--00-12  Rev. 110    Payload Installation Guide 
 
11 
 6) To change the parameters, select the Devices tab (near the top center of the 
page) and then select the Infrared link from the list of devices on the left of the 
page.  
 
Figure 3:  Infrared Device Configuration 
7) Modify the FOV Degrees parameter to match the horizontal FOV of the new 
payload.  
8) If the new payload has a different resolution, modify the Frame Size X and Frame 
Size Y to match the resolution of the new payload.  
						

							427-0031--00-12  Rev. 110    Payload Installation Guide 
 
12 
 Note: Setting the Frame Size parameters does not actually change the 
resolution of the camera. The parameters are used for information purposes 
in the FLIR Sensors Manager (FSM) software. 
Saving Configuration Changes 
After making any configuration changes, it is necessary to save the changes to the 
server (there is a Save button at the bottom of each configuration page). Once you save 
configuration changes to the server, the changes do not take effect immediately. 
Generally it is also necessary to stop and restart the server for the changes to become 
effective. The server has a configuration that is in effect and running, and another 
configuration that is saved (and possibly different than the running configuration). The 
following message indicates the saved configuration is different than the configuration in 
effect (the running configuration): “You must restart the server for the changes to be 
effective”.  
 
Restarting the Server 
To restart the server, first click on the Stop button at the top of the page, and wait for 
the page to refresh. When the server is stopped and the page is refreshed, the status 
will show as “Server Stopped” and the button at the top of the page will change to Start 
rather than Stop. 
 
Click on the Start button to restart the server, and when the page refreshes, the status 
will again show as “Server Running…”. It may take up to 15 seconds to start the server, 
depending on the configuration.