Tecmo World Kicks Update 1 Modification To Kicker Assembly Manual

WORLD KICKS
UPDATE 1
MODIFICATION TO THE
KICKER ASSEMBLY 

Ensure that the game is working correctly, and rectify any problems
(except kicker problems) before commencing this work.
Ensure that the game is switched OFF and the power is disconnected
before removing any parts.
Seperate the Kicker and Monitor Cabinets.
1. Remove 4off hex head screws (M6x20), with spring washers.
2. Raise the level adjusters on the Kicker Cabinet and remove the adjustable feet holders
before moving it away from the Monitor Cabinet. (Failure to raise the adjusters may
cause the...

Torx security screw
(M6x20)
Torx Security screw
(M6x20)
Torx security screw
(M6x20)
Socket button
head screw
(M6x20)Hex head screw
(M10x30)
Kicker assy
Front protector
(left)
Front protector
(centre)
Front protector
(right)
Whizz nut
(M10) Fixing bracket
1. Remove 2off whizz nuts (M10) and remove the rear Fixing Bracket.
2. Remove 4off torx security screw (M6x20), 4off socket button head screw (M6x20) and
remove the Front Protectors (left and right). Remove 2off torx security screw (M6x20)
and remove the...

Spring endsSpring shaft
Full nut
(M6)
Spring
Fitting the New Nylon Washer
1. Remove 1off Full nut (M6) and remove the Spring Shaft complete with Spring, and
Spring Ends.
2. When reassembling the new Spring Shaft refit the spring ends in the opposite
positions (front spring end refitted to the back and the back spring end refitted to the
front).
3. Fit the new Nylon Washer on to the spring shaft in front of the front spring end and
refit the Spring Shaft to the Kicker Assembly.
4. Refit the shaft to the...

Re-assembly and Testing
1. Refit the Kicker Assemblies to the cabinet.
2. Refit the Front Protectors.
3. Rejoin the Kicker Cabinet to the Monitor Cabinet.
(Take care not to trap any wires when rejoining the cabinets).
4. Refit the Adjustable Feet Holders and lower the Level Adjusters.
5. Re-initialize the game.
The following operation 
must always be performed after replacing the NAOMI Game
PCB, Joystick Potentiometers or initializing the backup data..
The game will not operate correctly if these...

Switch Test
When Switch Test is selected and entered from the I/F Initaialize screen the following
screen is displayed.
I/O TEST
LINK : OFF
SWITCH TEST [ON : RED]
COIN 0 (1)
SERVICE OFF (2)
TEST OFF (3)
SELECT (UP/DOWN) OFF/OFF (4)
ENTER OFF (5)
STICK
   (L / R) 8765 7765 6765 5765 (7)
   (U / D) 8765 7765 6765 5765 (8)
BUTTON OFF OFF OFF OFF (9)
   KICK 0000 0000 0000 0000 (10)
 (FRONT / BACK) OFF/OFF OFF/OFF OFF/OFF OFF/OFF (11)
(12)
UP SELECT SW  +  ENTER SW  :  EXIT
(6)
The SWITCH TEST screen...