Tascam Cd Rewritable Recorder CD-RW750 Owners Manual

4 – Recording
 TASCAM CD-RW750 Owner’s Manual 21
Sync recording (start)
The conditions under which an input signal is used as 
the trigger to start recording in the 
SYNC ALL and 
SYNC 1 modes are:
 when recording digitally from a DAT deck, a digi-
tal track start signal is detected (the signal level is 
ignored):
 when recording digitally from a CD or MD deck, a 
digital track start signal is received, and the signal 
level subsequently rises above the trigger level: when recording from any source...

4 – Recording
22 TASCAM CD-RW750 Owner’s Manual
Setting the trigger level
The trigger level is set as below:
1With a recordable disc loaded, press the 
MENU key (9 or 6) until the display shows: 
S_LVL>> -xxdB, where xx is the cur-
rent value.
2Use the MULTI JOG control B or the  SKIP 
keys 
Ito change the value between -24,  
-30, -36, -42, -48, -54, -60, -66, 
and 
-72 dB.
Low numerical values of this setting (towards –24) 
mean that it takes a louder signal to trigger the start 
of the synchronized...

4 – Recording
 TASCAM CD-RW750 Owner’s Manual 23
To enable or disable automatic track division:
1With a recordable disc inserted, and with the 
unit in record ready mode, press the 
MENU 
key (
9 or 6) repeatedly until 
A_Track>XX is shown, where XX may be 
ON or OFF.
2Tu r n  t h e  MULTI JOG control B or use the  
SKIP
 keys Ito change the value to ON or 
OFF.
The 
A-TRACK indicator at the top right of the 
display lights when the auto track function is 
enabled.
Automatic track division can be turned...

4 – Recording
24 TASCAM CD-RW750 Owner’s Manual
To set the fade times:
1Press the MENU key (9 or 6) repeatedly 
until the display shows 
Fade IN > XXS, 
where 
XX is the current fade-in time, in 
seconds.
2Tu r n  t h e  MULTI JOG control B or use the  
SKIP
 keys I to change the value of the fade-in 
time.
3Press the MENU key again so that the display 
shows 
Fade OUT> XXS, where XX is the 
current fade-out time, in seconds.
4Tu r n  t h e  MULTI JOG control or use the  SKIP 
keys to change the value of...

 TASCAM CD-RW750 Owner’s Manual 25
5 – After recording
This section deals with the actions taken after record-
ing: finalizing for CD-R and CD-RW discs, and erase 
operations for CD-RW discs.
Once finalized, CD-R discs are truly final—no more 
can be recorded on them. By contrast, CD-RW discs can be “unfinalized” using the CD-RW750, i.e. their 
TOC can be deleted, and if there is space, further 
material can be recorded on them. Even if the disc is 
full, tracks can be erased following the unfinalize...

5 – After recording
26 TASCAM CD-RW750 Owner’s Manual
Erasing tracks
It is possible to erase the last recorded track, the last 
two recorded tracks, the last three recorded tracks, 
etc. It is not, however, possible to erase tracks in the 
“middle” of the disc.
1With the disc loaded, and the unit in stop 
mode, press the 
ERASE key (G or D).
2If the display does not show ERASE XX-
XX?
, where XX is the number of the last 
track recorded on the disc, turn the 
MULTI 
JOG
 control B or use the  SKIP keys I...

5 – After recording
 TASCAM CD-RW750 Owner’s Manual 27
1With the disc loaded, and the unit in stop 
mode, press the 
ERASE key (G or D).
2Tu r n  t h e  MULTI JOG control B or use the  
SKIP
 keys I until the display shows DISC 
REFRESH
.
3To refresh the disc, press the MULTI JOG con-
trol or press the 
ENTER key 7.
NOTE
This operation cannot be undone. If you are going to 
refresh a disc, make sure that it contains only recordings 
that you really want to erase!
4If you do not want to proceed with the...

28 TASCAM CD-RW750 Owner’s Manual
6 – Reference and specifications
Troubleshooting
Specifications
Audio performance
Symptom Possible cause and remedy
No sound on playback (the disc is playing and the 
time display is incrementing)The connections from the CD-RW750 to the amplifier system have not been made properly, or the 
input source selector is not at the correct position.
No meter indication when a source is input Analog and/or digital volume (“Input selection” on page 18) is set too low. The signal...

6 – Reference and specifications
 TASCAM CD-RW750 Owner’s Manual 29
Audio specifications
Physical specifications
Dimensional drawing
ANALOG OUTPUTSUnbalanced RCA
Nominal output level–10 dBV (FS –16 dB)
Maximum output level+6 dBV
Output impedance800 Ω (unbalanced)
ANALOG INPUTSUnbalanced RCA
Nominal input level–10 dBV (FS –16 dB)
Maximum input level+ 6dBV
Input impedance33 kΩ (unbalanced)
PHONES output6 mm (1/4) stereo
Output level35 mW + 35 mW (into 32 Ω)
DIGITAL INPUT COAXIALRCA pin, IEC-60958 TYPE II...

TEAC CORPORATION Phone: +81-422-52-5082www.tascam.com 3-7-3, Nakacho, Musashino-shi, Tokyo 180-8550, Japan
TEAC AMERICA, INC.Phone: +1-323-726-0303www.tascam.com 7733 Telegraph Road, Montebello, California 90640
TEAC CANADA LTD.Phone: +1905-890-8008  Facsimile: +1905-890-9888 www.tascam.com 5939 Wallace Street, Mississauga, Ontario L4Z 1Z8, Canada
TEAC MEXICO, S.A. De C.VPhone: +52-555-581-5500www.tascam.com Campesinos No. 184, Colonia Granjes Esmeralda, Delegaacion Iztapalapa CP 09810, Mexico DF
TEAC UK...