Spirit ATTendant Connect/r Owners Manual

							NOTE: Use only a UL Listed wall plug-in
power transformer 
that has Class 2
outputs and the following characteristics:
Input rating:
99-127 V AC rms 60 llz
150  mA maximum
0utput rating:27-35 V DC at 200 mA
14-18 V DC at 200 mA
The power transformer supplied with the
ConntecT/R has these characteristics.
Step 3 — Test the equipment.
After the SPIRIT Attendant ConnecT/R is
Installed, test the 
SPIRIT Attendant by placing a
call to be answered by the SPIRIT Attendant.
NOTE: If the caller requests the SPIRIT
Attendant to transfer a call to an extension
number that is between the valid pro-
gramed lowest and highest extension but
there is no station set plugged into that
station port, the caller will be placed on
hold and the SPIRIT Attendant will not bc
able to retrieve the call. To help prevent
this from occuring, careful attention
should be given to setting the lowest/
highest extension numbers and try to avoid
skipping over extension numbers while
assigning them.
If you have any problems, see the Troubleshoot-
ing section of this manual for more information.
7 
						

							8
Troubleshooting
This section should help you determine thedevice operates. Call the AT&T Helpline at
cause of problems you might encounter and
1-800-628-2888 if you need assistance.
help you resolve them.
Remember that the way your SPIRIT System
was customized may influence how a particular
Operational DifficultyWhat  to Check
Ringing
SPIRIT Attendant doesn’t respond to outside callsNight Service customization*
Do Not Disturb active
Delayed Ringing active*
Abbreviated 
Ringing active*
No Ringing active*
No Access active*
Status of lines assigned to SPIRIT Attendant
station port (i.e., are all  the Iines on hold?)
SPIRIT  Attendant  doesn’t  respond to intercom  callsCall Forward active
SPIRIT Attendant ConnecT/R is very warm to the touchThis is normal,  especially if the SPIRIT Atten-
dant ConnecT/R as been covered by papers or
other materials, or if the room temperature is
warmer than average.
Check with the person in your organization responsible for the SPIRIT System. 
						

							Appendix A —Wiring Requirements
Note the following cabling requirements before104386545).  In addition, you will need a
connecting the equipment. If these limits (whichBuilding Entrance Protector, which can
are the same ones that apply to our currenthouse up to six 4C1S Block Protectors.
SPIRIT System) are exceeded, 
the SPIRITOrder Model 110ANA1-06 (comcode
Attendant ConnecT/R may not work properly.105736482). Contact your AT&T representa-
tive for additional information.
l     The total wire length from the controller to
 the SPIRIT Attendant cannot exceed a total
 of 1000 feet of 24- gauge DIW (twisted-pair
 copper) wire or22-gauge D station wire,
 plus 25 feet of 4-wire line cord.
l     If the SPIRIT Attendant ConnecT/R is
installed outside the building where the
controller is located, using exposed wiring
In-Range/Out-of-Building protectors (IROB
TII Model 371 or ITW Model  SP69073, AT&T
order number 31304) must be installed by a
qualified technician. Contact your AT&T
representative for additional information.
l     If the SPIRIT Attendant will be in a building
other than where the SPIRIT Attendant
ConnecT/R is located, a Block Protector
must be installed by a qualified technician.
Order an AT&T Model 4ClS (comcode
9 
						

							Appendix B —Limited Product Warranty and Limitation of Liability
AT&T warrants that the product will be free from
defects in material and workmanship for one year
from the date of purchase. If the product becomes
defective and such defect reported to AT&T
within the one-year warranty period, AT&T will
repair or replace the product, at its option, without
charge. Any repair or replacement parts or pro-
ducts may be new, remanufactured or refurbished at
the option of AT&T.  If AT&T determines that the
product cannot be repaired or replaced, AT&T will
refund the purchase price of the product.  All work
under the warranty will be performed by AT&T or
its agents during AT&T’s normal business hours
within a reasonable time after notice to AT&T of a
defect.
The limited warranty provided above does not
cover damages, defects, malfunctions or product
failures caused by:
l   Failure to follow AT&Ts  installation, operation
or maintenance instructions.
l         Product abuse, misuse or the negligent acts of
persons not under the reasonable control of
AT&T.
EXCEPT AS SPECIFICALLY SET FORTH ABOVE,
AT&T,  ITS AFFILIATES, SUPPLIERS AND DEAL-
ERS MAKE NO WARRANTIES, EXPRESS OR
IMPLIED, AND SPECIFICALLY DISCLAIM ANY
WARRANTY OF MERCHANTABILITY OR FIT-
NESS FOR A PARTICULAR PURPOSE.
Except for damages for personal injury, the liability
of AT&T, its affiliates, suppliers and dealers for any
loss or damage resulting from any product defect or
performance under this warranty and regardless of
the form of action shall be limited to repair or
rcplacement of the product or a refund of the
product’s purchase price. In no event shall AT&T, its
affiliates, suppliers and dealers be liable for indirect,
reliance, incidental or consequential damage or loss
(including loss of profits) caused or alleged to have
been caused by the product.
l   Unauthorized modification or alteration of the
product. 
						

							Index
AT&T Helpline  8 
Controller   1
CTRLR jack 6
Installation    3
Connect the ConnecT/R  5
Connect the SPIRIT Attendant    6
Mount the ConnecT/R 4
Test the equipment  7
POWER jack  6
Power Transformer 6
Safety Instructions 3
SPIRIT Attendant  1
STATION jack 5
TEL DEVICE jack   6
Troubleshooting 8 
						

							FCC Warning Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules.  These limits are designed to provide reasonable protection against harmful Interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio fre-
quency energy and, if not installed and used in accordance with this Owner’s Manual, may cause harmful interfer-
ence to radio communications. Operation of this  equipment in a residential area is likely to cause harmful interfer-
ence in which the user will be required to correct the interference at his or her own expense.
CAUTlON: Changes or modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment.
Comcode 106455868
Issue 1, January 1991
Graphics © AT&T 1990 
						

							518-453-712