Sony Vaio Sony Vaio Vgnt Manual

							T Series
Confidential
1)1.MS-1-D.21
LCD Section -1
2)
Remove the one screw.
* The screw secures the lug terminal.Pull out the Harness (LCD) from under the Cover (L).Screw: B6
3)
Remove the Cover (L) and the Cover (R) in the direction of the arrow 
while disengaging the detent (each one place).
Cover (L)
Cover (R)
Harness (LCD)
Cover (L)
Cover (L)
Cover (R)
Position of the detent
Remark 
						

							T Series
Confidential
LCD Section -2
1.MS-1-D.22
Remove the two screws and the LCD.
Screw: B10
5)
LCD
4)
Disconnect the Harness (LCD).
Harness (LCD) 
						

							T Series
Confidential
Mother Board -1
1) 2)1.MS-1-D.233) 4)
Remove the two screws and the Cover.
Screw: B10
Remove the three screws.
Pull out the FPC (two places) vertically.
FPC
Screw: Red-B10/ Blue-B11
Cover
Peel off the Cushion.
Cushion 
						

							T Series
Confidential
Mother Board -2
5)1.MS-1-D.24
Remove the Mother Board.
*The connector portion is engaged with the Escutcheon (L).
Escutcheon (L)
Mother Board 
						

							T Series
Confidential
Escutcheon (Front), CNX-274 Board
1)1.MS-1-D.25
Escutcheon (Front)Remove the one screw and the Escutcheon (Front).
Screw: B11
Peel off the Sheet (one place).
2)
3)
Peel off the Kapton Tape (one place) and Tape(Harness) (three places).
Sheet
Tape (Harness)
KaptonTape
Remove the CNX Board.
CNX Board
4) 
						

							T Series
Confidential
Parts of the Escutcheon (Front)
1)1.MS-1-D.26
Remove the one screw on the both side in the right and the left.
Bracket
Remove the Bracket (two places) while disengaging the 
detent (each one place).
Speaker
3)
Remove the Speaker (two places).
2)
Screw: B1 
						

							T Series
Confidential
Escutcheon (L), Connector (VGA)
1)1.MS-1-D.27
2)
3)
Remove the Escutcheon (L).
Escutcheon (L)
Connector (VGA)
Remove the Connector (VGA).
Peel off the Gasket (one place).
Gasket 
						

							T Series
Confidential
Parts of the Connector (VGA)
1)1.MS-1-D.28
2)
Bracket
Remove the Bracket.
Remove the two screws.
Screw: B5 
						

							T Series
Confidential
Parts of the Housing (Bottom) -1
1)1.MS-1-D.29
2)
3) 4)
Remove the Harness (two places).
*The adhesive tapes are attached to the rear.
Remove the Plate.
Plate
Remove the Escutcheon (R).
Escutcheon (R)
Remove the DC Jack while sliding it toward the front side.
DC Jack
Harness
Adhesive Tape 
						

							T Series
Confidential
Parts of the Housing (Bottom) -2
5)1.MS-1-D.30
Remove the Sheet.
Sheet
Gasket
Sheet
Sheet
Cushion
Sheet
SpacerRemarkThe Sheet (three places), Gasket (one place), Cushion (one place) and 
Spacer (one place) are attached to the Housing (Bottom).