Sony Rht G11 Operating Instructions

31GB
Advanced Settings
Changing the display setting 
(DISPLAY)
You can change the display behavior of the front 
panel display.
1Select “SYSTEM” in the AMP menu, 
then press   or c.
2Select “ DISPLAY,” then press   or c.
3Select the setting.
 ON:  The display stays turned on.
 OFF: The display appears for a few 
seconds when you operate the stand.
 The display shows the kinds of input signal (digital 
input only) when you press DISPLAY, even if you set 
“DISPLAY” to “OFF.”
 The display stays turned on...

32GB
If you experience any of the following 
difficulties while using the stand, use this 
troubleshooting guide to help remedy the 
problem before requesting repairs. Should any 
problem persist, consult your nearest Sony 
dealer.
POWER
The power is not turned on.
 Check that the AC power cord (mains lead) 
is connected securely.
The stand is not turned on when the TV is 
turned on.
 Check the TV speaker settings. The TV 
speaker settings control how the stand is 
automatically turned on with the TV....

33GB
Additional Information
No sound or only a very low-level sound of the 
connected component is heard from the stand.
 Press VOLUME + and check the volume 
level.
 Press MUTING or VOLUME + to cancel the 
muting function.
 Check that the input source is correctly 
selected.
 Check that all the cables and cords of the 
stand and the connected components are 
fully inserted.
 Check the HDMI setting of the connected 
components.
No sound is output from specific speakers.
 Depending on the sound source...

34GB
 If you connect the audio output of the video 
component and the stand using other than an 
HDMI cable, no sound may be output 
because of “BRAVIA” Sync. In this case, set 
“CTRL HDMI” to “OFF” (page 25) or 
connect the audio output jack directly to the 
TV instead of the stand.
If “PROTECTOR” and “PUSH POWER” appear 
alternately in the front panel display.
Press ?/1 to turn off the stand, and check the 
following item after “STANDBY” disappears.
 Is anything blocking the ventilation holes of 
the...

35GB
Additional Information
Formats supported by this 
stand
Digital input formats supported by this stand are 
as follows.
* Linear PCM accepts sampling frequencies of no 
more than 48 kHz.
Amplifier section
Rated Output Power
Stereo mode 75 W + 75 W, 4 ohms, 
1 kHz, THD less than 1 %
Reference Output Power
Surround mode 
(per channel) Front: 100 W + 100 W, 
4 ohms
Center: 100 W, 4 ohms
Subwoofer: 130 W, 
3 ohms, 100 Hz
Inputs (Analog)
AUDIO Sensitivity: 450 mV
Impedance: 30 kohms
Inputs (Digital)
TV,...

36GB
General
Power requirements  220 – 240 V, 50/60 Hz
Power consumption
On: 100 W
Active Standby (Power consumption increases 
when the HDMI function is activated and the 
TV connected to the stand is turned on, even if 
the stand is turned off.): 3.5 W or less
Standby: 0.3 W or less
Dimensions (approx.) 1,130 mm × 480 mm × 
452 mm (w/h/d)
Mass (approx.) 48 kg
Design and specifications are subject to change without 
notice.
 Standby power consumption: 0.3 W or less
 Halogenated flame retardants are not...

37GB
Additional Information
A
A/V SYNC 29
AMP menu
 28
AUDIO DRC
 29
AU TO  ST B Y
 31
B
BASS 29
“BRAVIA” Sync
 24
C
CNT LEVEL 29
Connecting
Blu-ray Disc player
 10
cable television tuner
 12
DIGITAL MEDIA PORT adapter
 13
DVD player
 10, 13
FM wire antenna (aerial)
 13
PlayStation 2
 13
PlayStation 3
 10
satellite tuner
 12
TV
 10
video cassette recorder
 13
D
Digital optical cord 10, 12
DIMMER
 30
DISPLAY
 21, 31
DUAL MONO
 30
I
INPUT MODE 30
INPUT SELECTOR
 15, 17
N
NIGHT MODE 30
P
Preventing the TV...

Sony Corporation   Printed in Malaysia
(1)