Sony Projector VPL-FHZ700L User Manual

41Troubleshooting
Others
Troubleshooting
Before asking to have the projector repaired, try to diagnose the problem, following the 
instructions below.
SymptomRemedyPage
The power is not turned 
on.Check if the AC power cord is firmly connected. –
When the “Panel Key Lock” is set to “On,” you cannot turn on 
the projector using the ?/1 key on the projector.28
If the air filter cover or air filter unit is not attached securely, 
the projector cannot be turned on.43
No image. Check if the connecting cable...

42Troubleshooting
The image is dark/too 
bright.The settings for “Brightness,” “Contrast,” and “Light Output 
Mode” affect brightness of the image. Check if the value is 
appropriate.22, 29
The image will be dark when the light source is burnt out. 
Check “Light Timer,” and consult with qualified Sony 
personnel.35
“With Static Signal” is set to “On.”  30
When video signal is not input, the light is dimmed to reduce 
power consumption.30
When the temperature around the unit is high, the brightness 
will...

43Cleaning the Air Filter
Others
Cleaning the Air 
Filter
When a message appears on the projected 
image indicating time for a filter cleaning, 
clean the air filter (pages 39, 40).
If the dust cannot be removed from the air 
filter even after cleaning, replace the air filter 
with a new one.
For details on a new air filter, consult with 
qualified Sony personnel.
If you continue to use the projector even 
after the message is displayed, dust may 
accumulate, clogging it. As a result, the 
temperature...

44Cleaning the Air Filter
4Remove the four air filter cartridges 
(two in each air filter unit) from the air 
filter units and clean the air filter with 
a vacuum cleaner.
When attaching the air filter cartridge to 
the cartridge holder, push the air filter 
cartridge in fully until the tabs of the  
cartridge holder click (4 points each air 
filter cartridge, a total of 8 points).
The two air filter units are installed in the 
right and left positions.
5Return the air filter units to the 
projector.
The...

45Installing the Optional Adaptor
Others
Installing the 
Optional Adaptor
You can install the optional adaptor in 
INPUT E of the terminals section of the 
projector.
 Turn off the projector and disconnect the AC 
power cord from a wall outlet before 
installing the optional adaptor.
 Be sure to retain the slot cover removed when 
installing the optional adaptor. When 
removing the optional adaptor, attach the 
cover.
 For details on how to use, also refer to the 
operating instructions of the optional...

46Specifications
Specifications
ItemDescription
Model nameVPL-FHZ700L
Display system 3 LCD system
Display device Size of effective 
display area0.95 (24.1 mm) × 3, Aspect ratio 16:10
Number of pixels 6,912,000 (1920 × 1200 × 3) pixels
Light source Laser diode
Light output 7,000 lm
*1 (when “Light Output Mode” is set to “High”)
Displayable 
scanning 
frequency
*2
Horizontal: 14 kHz to 93 kHz, Vertical: 47 Hz to 93 Hz
Display resolution Computer signal 
inputMaximum display resolution: 1920 × 1200 dots...

47Specifications
Others
Control signal 
input/outputRS-232C terminal: D-Sub 9 pin male
LAN terminal: RJ45, 10BASE-T/100BASE-TX
CONTROL S input terminal (DC power supply): 
Stereo mini jack, 5 Vp-p, Plug in power DC 5 V
CONTROL S output terminal: Stereo mini jack
Operating 
temperature/
Operating 
humidity0 °C to 40 °C (32 °F to 104 °F)/35% to 85% (no 
condensation)
Storage 
temperature/
Storage humidity–10 °C to +60 °C (14 °F to +140 °F)/ 10% to 90% (no 
condensation)
Power required AC 100 V to 240 V,...

48Specifications
Projection Lens VPLL-FM22*5 *6: Manual focus, 
Projected image size: 40 to 300 (1.02 m to 7.62 m), 
Maximum external dimensions (W × H × D): 88 × 88 × 
169 mm (3 
15/32 × 3 15/32 × 6 21/32), Mass: Approx. 
1 kg (2.1 lb)
Projection Lens VPLL-ZM42
*5 *6: Manual focus/
zoom, Projected image size: 40 to 300 (1.02 m to 7.62 
m), Maximum external dimensions (W × H × D): 88 × 88 
× 159 mm (3
15/32 × 3 15/32 × 61/4), Mass: Approx. 
0.7 kg (1.4 lb)
Projection Lens VPLL-ZM102
*5 *6: Manual focus/...

49Specifications
Others
The values for mass and dimensions are approximate.
*1: When attaching the VPLL-Z4019.
*2: For details, refer to “Acceptable Input Signals” on page 51.
*3: Not all optional accessories are available in all countries and area. Please check with your local 
Sony Authorized Dealer.
*4: Information on accessories in this manual is current as of February 2015.
*5: To attach the projection lens to the projector, the PK-F500LA2 projection lens adapter is  
required.
*6: Before attaching...

50Specifications
Pin assignment
DVI-D terminal (DVI-D, female)RGB input terminal (Mini D-sub 15-
pin, female)
RS-232C terminal (D-Sub 9-pin, male)
1 T.M.D.S.
Data2–14 +5 V Power
2 T.M.D.S.
Data2+15 Ground (return 
for +5 V)
3 T.M.D.S.
Data2 Shield16 Hot Plug 
Detect
4 NC 17 T.M.D.S
Data0–
5 NC 18 T.M.D.S 
Data0+
6 DDC Clock 19 T.M.D.S 
Data0 Shield
7 DDC Data 20 NC
8NC 21NC
9 T.M.D.S.
Data1–22 T.M.D.S 
Clock Shield
10 T.M.D.S.
Data1+23 T.M.D.S
Clock+
11 T.M.D.S.
Data1 Shield24 T.M.D.S 
Clock–
12 NC
13...