Smeg Sta 4845 Instruction Manual

 
User instructions   
 
 
9  
3.  Description of the controls  
3.1 Upper panel  All the dishwasher controls are grouped on the upper panel. Switch-on, 
programming, switch-off, etc. procedures are only possible when the door is 
open. 
  
 
 
The panel shown is only a guideline example: the form of the lights and 
buttons may vary depending on the model. 
 
 
1 ON/OFF BUTTON 
Press this button to switch the dishwasher on/off. 
2 
SELECTED PROGRAM INDICATOR LIGHTS 
Illumination of this light denotes the...

 User instructions    
 
10  
 
Depending on the model, this zone may contain one or more of the 
following options, identified by the relative symbols and described in 
more detail in the relevant sections of the manual. 
It is not possible to select any options when the soak program is being 
used. All options except Flexi Tabs are disabled at the end of the 
wash cycle. To disable the “Flexi Tabs” option, press the relative 
button (the light goes out).
 
 
 
Flexi Tabs 
Specifically for the use of...

 
User instructions   
 
 
11  
PROGRAMS TABLE The manual contains the programs table for several models. To find the 
table for your dishwasher, compare the program symbols at the top of the 
table with those on your control panel.  
 
 
 
  
 
 
SETTING THE WASHING PROGRAM AND SWITCHING ON After identifying the most suitable program with the aid of the programs 
table: 
 
• Press the ON/OFF button (1) and wait for the PROGRAM 
INDICATOR LIGHT (2) to illuminate; 
• Keep pressing the PROGRAM SELECTION...

 User instructions    
 
12 
PROGRAMS TABLE  
 
 
 
PROGRAMME NUMBER & SYMBOL 
LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS 
DURATION  CONSUMPTION 
MINUTES (1)  
 WATER LITRESPOWER KWh (1) 
1 SOAK 
 
Pans and dishes awaiting completion of the load Cold prewash 9 5,0 0,02 
2 LIGHT 
 
Delicate dishes with light dirt 
Wash at 45°C Cold rinse Rinse at 70°C Dry 
 
59 
 
12 0,90 
3 ECO (*) 
 EN 50242 
Dishes with normal dirt, even with dried-on residues 
Cold prewash Wash at 55°C Cold rinse Rinse at 66°C Dry...

 
User instructions   
 
 
13 
PROGRAMS TABLE  
 
  
 
PROGRAMME NUMBER & SYMBOL 
LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS 
DURATION  CONSUMPTION 
MINUTES (1)  
 WATER LITRESPOWER KWh (1) 
1 SOAK 
 
Pans and dishes awaiting completion of the load Cold prewash 9 5,0 0,02 
2 RAPID 27’ 
 
Dishes with light dirt, washed immediately after use 
Wash at 38°C Rinse at 50°C 
 
27 
 
6,5 0,70 
3 ECO (*) 
 EN 50242 
Dishes with normal dirt, even with dried-on residues 
Cold prewash Wash at 55°C Cold rinse Rinse...

 User instructions    
 
14 
PROGRAMS TABLE  
 
    
PROGRAMME NUMBER & SYMBOL 
LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS 
DURATION  CONSUMPTION  MINUTES (1)  
 WATER LITRESPOWER KWh (1) 
1 SOAK 
 
Pans and dishes awaiting completion of the load Cold prewash 9 5,0 0,02 
2 RAPID 27’ 
 
Dishes with light dirt, washed immediately after use 
Wash at 38°C Rinse at 50°C 
 
27 
 
6,5 0,70 
3 ECO (*) 
 EN 50242 
Dishes with normal dirt, even with dried-on residues 
Cold prewash Wash at 55°C Cold rinse Rinse at...

 
User instructions   
 
 
15 
 
NOTES AND REFERENCES Only run the soak program with half loads.  Options cannot be used with the soak program.  * Standard programme under EN 50242. 
**  See information sheet provided 
(1)  The cycle duration and power consumption may vary according to the water 
and room temperatures, and the type and amount of dishes. 
(2)  1 or 2 cold rinses depending on the model.  
 
REFERENCES for the ENERGY LABEL supplied with the dishwasher: 
 
-  Annual energy consumption is...

 User instructions    
 
16 
  
                 
3.2 Washing programs   
  
 Before starting a washing program make sure that: 
• The water supply tap is open. 
• The softener container contains regenerating salt. 
• The correct amount of detergent has been added to the 
dispenser. 
• The baskets have been correctly loaded. 
• The spray arms are able to rotate freely and without 
obstruction. 
• The dishwasher door is securely closed.   
 
  
 OPTION SELECTION
Options are selected by pressing the...

 
User instructions   
 
 
17  
Flexi Tabs 
 The option is optimised for use of detergents which are complete with 
salt and rinse aid, known on the market as 3 in 1, triple action, etc.  
With this option activated, any salt and rinse aid If you wish to use 
detergents which already contain salt and rinse aid already in the 
dishwasher will not be used.  
 - N.B.: even with the Flexi Tabs option selected, the 
regenerating salt/rinse aid lights will still stay on if their 
containers are empty....

 User instructions    
 
18  
PROGRAM DELAY 
 The start of the program can be delayed by 3, 6 or 9 hours. 
This allows you to set the dishwasher to work at the times of day most 
convenient to you. After setting the program, press the button to select 
the delay you require; the corresponding light will come on. When the 
door is closed, the appliance will prewash the dishes, after which the 
program delay set will come into effect. If you wish to exit the 
procedure without setting delayed start, press...