Smeg Sa990xr8 Manual

22
Instructions for the user
8.4  Hot-air grilling
8.5  Defrosting
  
FUNCTION SELECTOR    
THERMOSTAT200
Ensures uniform heating with greater heat penetration into the food. Food
will be lightly browned on the outside and remain soft inside. 
Keep the oven door closed during cooking. Heating up time must not
exceed 60 minutes.
     
FUNCTION SELECTOR   
THERMOSTAT IN POSITION0
The movement of air ensured by the fan causes the food to defrost faster.
The air circulating inside the oven is at room...

23
Instructions for the user
8.6  Rotisserie cooking
 
FUNCTION SELECTOR        
THERMOSTAT IN POSITION200
Prepare the rotisserie rod with the food, tightening the screws A of the
prongs. Fit the frames B into the holes of the drip tray F. Position the
rotisserie rod so that the pulley E is still in the guides on the cavity of
frame B on the right side. Insert the drip tray into the oven as far as it will
go until the tip of the rod is in line with the hole C. Now rock the frames B
to insert the tip of...

24
Instructions for the user
8.7  Table of recommended cooking settings
Cooking times, especially for meat, vary according to the thickness,
quality of the food and to consumer taste. Cooking times are given for a
pre-heated oven.
TRADITIONAL COOKING                
RUNNER POSITION
FROM BOTTOMTEMPERATURE
(°C)TIME
IN MINUTES (*)
FIRST COURSES
OVEN-BAKED PASTA2 200 30-35
MEATS
ROAST VEAL
ROAST PORK
CHICKEN
DUCK
RABBIT2
2
2
2
2200
225
200
200
20060-65
70-75
60-65
120-125
90-95
FISH 2 200 ACCORDING TO...

25
Instructions for the user
HOT-AIR COOKING               
RUNNER POSITION
FROM BOTTOMTEMPERATURE
(°C)TIME
IN MINUTES (*)
FIRST COURSES
OVEN-BAKED PASTA2 175 30-35
MEATS
ROAST VEAL
ROAST PORK
CHICKEN
DUCK
RABBIT2
2
2
2
2175
200
200
175
17560-65
70-75
60-65
120-125
90-95
FISH 2 175 ACCORDING TO 
DIMENSIONS
PIZZA 2 225 15-20
DESSERTS
MERINGUES
BISCUITS
SHORT PASTRY
RING CAKE
FRUIT CAKE2
2
1
2
1125
175
175
175
17555-60
20-25
25-30
35-45
30-35 

26
Instructions for the user
9.  CLEANING AND MAINTENANCE
9.1 Cleaning stainless steel
9.1.1  Ordinary daily cleaning
To clean and preserve stainless steel surfaces, always use only specific
products that do not contain abrasives or chlorine-based acids.
How to use: pour the product onto a damp cloth and wipe the surface,
rinse thoroughly and dry with a soft cloth or chamois leather.
9.1.2  Food stains or residues
NEVER USE A JET OF STEAM FOR CLEANING THE APPLIANCE.
Before any intervention that requires...

27
Instructions for the user
9.2  Cleaning the oven
9.3  Door glass
The glass in the door should always be kept thoroughly clean. Use
absorbent kitchen roll; in case of stubborn dirt remove with a damp
sponge and an ordinary detergent.
For the best oven upkeep, clean it regularly after having allowed it to cool.
Take out all removable parts.
 Clean the oven rack and side runners with warm water and non-
abrasive detergent. Rinse and dry.
 For easier cleaning, the door can be removed (see point 8.2)
 The...

28
Instructions for the user
10.  EXTRAORDINARY MAINTENANCE
The oven may require extraordinary maintenance or replacement of parts
subject to wear such as seals, bulbs, and so on. The following instructions
describe how to carry out these minor maintenance operations.
10.1  Replacing the light bulb
Remove the bulb protector A by turning it anti-clockwise and change bulb
B (in the 8-function model with front glass panel change the halogen bulb
C) with a similar one. Re-fit bulb protector A.
Before any...

29
Instructions for the user
10.2 Removing the door
Lift the levers B until they touch the hinges A and take hold of the two
sides of the doors with both hands close to the hinges. Raise the door to
an angle of about 45° and remove it. To reassemble, fit the hinges A  into
their grooves, then lower the door into place, ensuring that it remains fitted
into the grooves C, then release the levers B. 

30
Instructions for the user
10.3  Oven door seals
To permit thorough cleaning of the oven, the seal may
be removed. Before removing the seal, take off the
oven door as described above. Once the door has
been taken off, lift the tabs at the corners as shown in
the figure.
When cleaning is completed replace the seal, holding
the longest side horizontally, and insert the tabs into
their respective holes, starting with the top ones.
914774362/ A