Smeg Sa20xmfr 7 User Manual

							
 
 
Instructions for the user 
 
44  
7.2  Cleaning of the oven    For best oven upkeep clean regularly after having allowed to cool. Take 
out all removable parts.  
   
 •   Clean the oven grill and side guides with hot water and non-abrasive 
detergent. Rinse and dry. 
•  The oven should be operated at t he maximum temperature for about 
15/20 minutes after using specific products, to eliminate the residues 
deposited inside the oven. 
•   For easier cleaning, the door can be removed (see P. 8.2) 
 
7.3 Door glass 
The door glass should always be kept clean. Use absorbent kitchen 
paper to clean. In case of tough  spots, clean with a damp sponge using 
regular detergent. 
 
Do not use metallic sponges or sharp scrapers: they will damage the  
surface.  
  
  
						

							
 
Instructions for the user  
  
8. EXTRAORDINARY MAINTENANCE 
 
The oven may require extraordinary maintenance or replacement of parts 
subject to wear such as seals, bulbs, and so on. The following 
instructions describe how to carry out these minor maintenance 
operations. 
   Before any intervention, disconnect  the power supply of the device. 
   
8.1 Replacement of light bulb 
Remove the bulb protector  A by turning anticlockwise and change bulb  B 
(in the 8-function model with front glass panel change the halogen bulb 
C ) with a similar one. Re-fit the bulb protector  A. 
 
         Only use oven bulbs (T 300°C). 
   
 
45  
						

							
 
 
Instructions for the user 
 
46 
8.2  Removing 
Hold the door on both sides with both hands near hinges  A and raise levers 
B . Lift up the door forming an angle of about 45° and remove. To refit, slide 
the hinges  A in the grooves, drop the door and release levers  B. 
 
 
  
 
 
 
8.3  Oven door seal 
To permit thorough cleaning of the oven, the seal 
may be removed. Before re moving the seal, take off 
the door as described above. Once the door has 
been taken off, lift the tabs  at the corners as shown 
in the figure. 
After cleaning, refit the seal with the longer side 
horizontal and insert the tabs into the appropriate 
holes starting from the top ones.