Singer Professional 5 Manual
Have a look at the manual Singer Professional 5 Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 50 Singer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
3. Thread the top cover thread guide by pulling the thread towards the left until
it slips under the guide. Then pull the thread along the right side of the
button as illustrated.
4. While holding the thread firmly, pull the thread between the tension disks.
5. Turn the handwheel toward you until the lower looper extends 5-10mm
(approximately ½ inch) from the needle plate edge.
6. Thread the looper area of the machine following the green color coded
thread guides 4-9.
Three-Thread Flatlock (narrow) page 9
7. Thread the hole in the Upper Looper from front to back k. Pull about 4
inches of thread through the looper and place to the back of the
throat plate.
Three-Thread Flatlock (narrow) page 11
10. Thread the looper eye (A) from front to back. Pull about 4 inches of thread.
Position thread into V cutout (B) on threader. Firmly hold thread tail with left
hand and pull Threader lever (C) up into place (D).
NOTE: Make sure the Upper Looper thread is
behind the Lower Looper thread.
Threader Lever “V” cutout
5. Continue to thread points 4-8. Slip the thread into the rear slot of the
thread guide g. Go over the take up lever h. Continue by slipping the
thread into the right slot of the thread guides i and j.
8. Before threading the eye of the needle, make sure the thread is
behind
the thread guide located on the bottom of the needle clamp.
9. Draw about 4 inches of the thread through the needle eye towards the back
of the machine.
10. Place the thread to the back, under the Presser Foot.
Three-Thread Flatlock (narrow) page 13