Singer Professional 5 Manual
Here you can view all the pages of manual Singer Professional 5 Manual. The Singer manuals for Sewing Machine are available online for free. You can easily download all the documents as PDF.
Page 51
Three-Thread Overlock (narrow) page 4
Page 52
Page 53
Page 54
Two-Thread Overedge (narrow) page 7
Page 55
3. Thread the top cover thread guide by pulling the thread towards the left until
it slips under the guide. Then pull the thread along the right side of the
button as illustrated.
4. While holding the thread, firmly pull the thread between the tension disks.
5. Turn the handwheel toward you until the lower looper extends 5-10mm
(approximately ½”) from the needle plate edge.
6. Thread the looper area of the machine...
Page 56
7. Thread the hole in the Upper Looper from front to back k. Pull about 4
inches of thread through the looper and place to the back of the
throat plate.
Page 57
4. While holding the thread, firmly pull the thread between the tension disks.
5. Turn the handwheel toward you until the lower looper extends 5-10mm
(approximately ½”) from the needle plate edge.
6. Thread the looper area of the machine following the red color coded
thread guides 4-10.
7. Place the thread slighty from left and
to the right of threading guide f.
8. Place the thread slightly from the...
Page 58
Three-Thread Overlock (narrow) page 11
10. Thread the looper eye (A) from front to back. Pull about 4 inches of thread.
Position thread into V cutout (B) on threader. Firmly hold thread tail with left
hand and pull Threader Lever (C) up into place (D).
NOTE: Make sure the Upper Looper thread is
behind the Lower Looper thread.
Threader Lever
“V” cutout
Page 59
Page 60
5. Continue to thread points 4-8. Slip the thread into the rear slot of the
thread guide g. Go over the take up lever h. Continue by slipping the
thread into the right slot of the thread guides i and j.
8. Before threading the eye of the needle, make sure the thread is
behind
the thread guide located on the bottom of the needle clamp.
9. Draw about 4 inches of the thread through the needle eye towards the...