Siemens Sr 25e830 Operating Instructions

Fault, what to do?en
31
Rust spots on the cutlery. Cutlery not adequately rust-
resistant. Knife blades are  
frequently more severely  
affected. Use corrosion-resistant cutlery.
Cutlery will also rust if rusting 
parts are rinsed at the same time 
(pan handles, damaged utensil  
baskets, etc.). Do not wash rusting parts.
Salt content in the rinsing water 
too high, as salt dispenser lock  
not fastened firmly or salt was 
spilled while being refilled. Fasten salt dispenser lock firmly or remove...

enCustomer service
32
 
4
Customer serviceCustomer service
If you are unable to rectify the fault,  
please contact your customer service.  
We always find a suitable solution, even  
to avoid unnecessary visits 
by technicians. Contact information  
for your nearest customer service can  
be found on the back of these 
instructions for use or on the enclosed  
customer service list. When calling,  
please state the appliance number (E-
Nr. = 1) and the production number  
(FD = 2) which can be found on...

Installation and connectionen
33
5 Installation and 
connection
Installation and connection
The dishwasher must be connected  
correctly, otherwise it will not function 
properly. The specifications for the inlet  
and outlet as well as the electrical  
connected loads must correspond with 
the required criteria as  
specified in the following paragraphs  
or in the installation instructions. 
Install the appliance in the correct  
sequence: 
1. Checking appliance on delivery
2. Installing the appliance...

enInstallation and connection
34
Installation 
The required installation dimensions can  
be found in the installation instructions.  
Level the appliance with the aid of the  
height-adjustable feet. Ensure that the 
appliance is situated securely on the  
floor.


Installation and connectionen
35
Warm water connection
W
ar m w
at e
r c onn
ec t
io n
* depending on model 
The dishwasher can be connected  
to cold or hot water up to max. 60 °C.  
Connection to hot water  
is recommended if the hot water can be  
supplied by energetically favourable  
means and from a suitable installation, 
e. g. solar heating system with  
circulation line. 
This will save energy and time. 
The hot water setting ‘:‹‚  allows you 
to adjust your appliance optimally  
to operation...

enInstallation and connection
36
Removing the appliance 
Also observe  
the sequence of worksteps here. 
1.
Disconnect the appliance from  
the power supply.
2. Turn off the water supply.
3. Disconnect the waste water  
and fresh water connections.
4. Loosen fastening screws for the  
furniture parts.
5. If fitted, remove the base panel.
6. Pull out the appliance, carefully 
pulling the hose behind.
Transportation 
Empty the dishwasher and secure loose  
parts. 
Drain the appliance according to the...

      



   



DownloadedfromDishWasherManualcomManuals 

 
 

 
 


 

 
 
 
 
 



 
 
 






 
 
 


 

 


*9000868097* 
9000868097
 en (9301) 440EG