Siemens Sn 66t052 Operating Instructions

en
21
A regular inspection and maintenance of  
your machine will help to prevent faults. 
This saves time and prevents problems.
Overall condition of the machine
– Check spray arm for grease and 
limescale deposits.
If you find such deposits: 
– Fill detergent dispenser with detergent.  Start the appliance without utensils in  
the programme with the highest rinsing  
temperature.
Clean the appliance with detergents/ 
appliance cleaners which are particularly  
suitable for use with dishwashers. 
–...

en
22
Spray arms
Limescale and contaminants in the rinsing  
water may block nozzles and bearings on 
the spray arms 1: and  1Z.
– Check outlet nozzles on the spray arms  for blockages.
– Unscrew the upper spray arm  1:.
– Remove the lower spray arm  1Z 
upwards.
– Clean spray arms under running water. 
– Re-engage or screw on spray arms. The majority of  faults which could occur in  
daily operation can be rectified by the 
user. This ensures that the appliance is  
quickly available for use again. The...

en
23
Waste water pump
Large food remnants or foreign objects  
which were not captured by the filters may 
block the waste water pump. The rinsing 
water will then be above the filter.  
In this case: 
– First always disconnect the appliance from the power supply.
– Take out top basket  1* and bottom 
basket  9*.
– Remove the filters  1j.
– Scoop out water, use a sponge if  required.
– Prise out the white pump cover  (as illustrated) using a spoon. Grip the  
cover on the crosspiece and lift...

en
24
–
Filter in the water supply blocked. 
– Switch off the appliance and pull 
out the mains plug. 
–Turnoff thetap.  
– Clean filter in the supply hose.  
– Reconnect power supply.  
– Turn on the tap. 
–Switchon theappli ance.
– Water is left in the appliance  
at the end of the programme. 
–(“ :ƒ… ) Waste water hose 
is blocked or kinked. 
Filters blocked.
– (“ :ƒ† ) Waste water pump blocked, 
cover on the waste water pump  
is not locked in position  
(see Waste water pump).
–Fi lters blocked.
–...

en
25
White stains on the utensils/glasses  
remain milky. 
If phosphate-free detergents are used with  
hard tap water, white deposits may be 
deposited more easily on utensils and 
the container walls.  
– Too little/unsuitable detergent. 
– Too weak programme selected. 
– No/too little rinse aid. 
– No/too little special salt. 
– Water softening system set to the 
wrong value.
– Salt dispenser lock not fastened.
Contact the detergent manufacturer,  
in particular if:  
– the utensils are very wet at...

en
26
The dishwasher must be connected  
correctly, otherwise it will not function 
properly. The specifications for the inlet  
and outlet as well as the electrical  
connected loads must correspond with the 
required criteria as specified in the 
following paragraphs or in the installation  
instructions. 
Install the appliance in the correct  
sequence: 
– Checking appliance on delivery 
– Installing the appliance 
– Waste water connection 
–Fr
esh water connection
– Electrical connection
Safety...

en
27
Installation
The required installation dimensions can  
be found in the installation instructions. 
Level the appliance with the aid of the 
height-adjustable feet. Ensure that the  
appliance is situated securely on the floor. 
– A built-under or integrated appliance which is installed subsequently as a  
free-standing appliance must be  
secured to prevent it from overturning,  
e.g. by screwing it to the wall or by 
installing it under a continuous worktop 
which is screwed to adjacent...

en
28
Electrical connection
– Connect the appliance to an alternating current only, ranging from  
220 V to 240 V and 50 Hz or 60 Hz 
via a correctly installed socket with  
protective earth conductor. See rating  
plate for required fusing  9J.
– The socket must be near the appliance  and freely accessible following  
installation. 
If the plug is not freely accessible, an  
allpole disconnector with a contact  
opening of at least 3 mm must be  
fitted on the installation side to satisfy 
the relevant...

en
29
Both the packaging of new appliances and  
the old appliances themselves contain 
valuable raw materials and recyclable  
materials. 
Please dispose of the individual parts  
separated according to type. 
Please ask your dealer or inquire at your  
local authority about current means of 
disposal.
Packaging
All plastic parts of the appliance are  
identified with internationally standardised  
abbreviations (e.g. >PS< polystyrene). 
Therefore, plastic waste can be sorted out  
when the appliance is...