Siemens Sn 25e810 Operating Instructions

Fault, what to do?en
31
Rust spots on the cutlery. Cutlery not adequately rust-
resistant. Knife blades are  
frequently more severely 
affected. Use corrosion-resistant cutlery.
Cutlery will also rust if rusting 
parts are rinsed at the same time  
(pan handles, damaged utensil  
baskets, etc.). Do not wash rusting parts.
Salt content in the rinsing water 
too high, as salt dispenser lock  
not fastened firmly or salt was  
spilled while being refilled. Fasten salt dispenser lock firmly or remove...

enFault, what to do?
32
 
Appliance stops  
in the programme or  
programme is interrupted.
Door not closed properly. Close the door. 
Do not place utensils or fragrance  
dispenser in the tablet collecting  
tray. 
Top basket presses against inner  
door and prevents door from 
being closed securely. Check whether rear panel is being pressed 
in, e.g. by socket or by hose holder which  
has not been removed.
Power and/or water supply  
interrupted. Restore power and/or water supply.
Filling valves...

Customer serviceen
33
4 Customer serviceCustomer service
If you are unable to rectify the fault,  
please contact your customer service. 
We always find a suitable solution, even  
to avoid unnecessary visits  
by technicians. Contact information  
for your nearest customer service can  
be found on the back of these  
instructions for use or on the enclosed 
customer service list. When calling,  
please state the appliance number (E- 
Nr. = 1) and the production number 
(FD = 2) which can be found on...

enInstallation and connection
34
Delivery 
Your dishwasher has been checked  
thoroughly in the factory to ensure that it  
is in working order. This may cause 
small water stains. These will disappear  
after the first wash cycle. 
Technical specifications 
Weig ht: 
max. 60 kg 
Voltage:
220–240 V, 50 Hz or 60 Hz
Connected load:
2.0–2.4 kW
Fuse: 
10/16 A (UK 13A) 
Power input:
switched off 0.1 W
not switched off 0.1 W
Water pressure:
at least 0.05 MPa (0.5 bar), maximum  
1 MPa (10 bar). At a higher...

Installation and connectionen
35
Water pressure: 
at least 0.05 MPa (0.5 bar), maximum  
1 MPa (10 bar). At a higher water  
pressure: connect pressure-reducing  
valve ahead. 
Inlet rate:
minimum 10 litres/minute
Water temperature: 
Note printing on the water inlet hose!  
If models are marked with 25°,  
the water temperature may be max.  
25 °C (cold water).  
For all other models:  
cold water preferred; hot water max.  
temperature 60 °C.
Warm water connection
Warm
 wate
r c onnec
tio n
* depending...

enInstallation and connection
36
Electrical connection


      



   



DownloadedfromDishWasherManualcomManuals  

 


 
 




 



 


 
 
 








 



 
  
 

*9000779459* 
9000779459
 en (9210-1) 640EG