Siemens Sn 25e270 Operating Instructions

en
11
Small accessories holder *Sma
ll a
ccessor
ie
s
 h
o
ld
er
* depending on model 
Light-weight plastic accessories, e.g. cups,  
lids, etc. can be held securely in the small  
accessories holder.
Adjusting the height of the basket
The height of the upper utensils basket  
1*  can be adjusted in 3 stages to create 
more space either in the upper or lower  
basket. 
Appliance height 81.5 cm 
Appliance height 86.5 cm 
– Pull out the top basket  1* out.  –To 
lower the basket, press in the left 
and...

en
12
You can use tablets as well as powder  
or liquid detergents for dishwashers, but 
never use washing up liquid. The dosage  
can be individually adjusted with powder  
or a liquid detergent according 
to the degree of soiling. Tablets contain 
an adequately large amount of active  
ingredients for all cleaning tasks. Modern,  
pow erful detergents predominantly 
use a low-alkaline formulation with  
phosphate and enzymes. Phosphates  
bond the lime in the water. Enzymes break 
down starch and...

en
13
Tip 
If the utensils are only lightly soiled, slightly  
less than the indicated amount 
of detergent is usually adequate.  
Suitable detergents and care products  
can be purchased online via our website 
or via customer service (see back page). 
Combination detergent
Apart from conventional detergents (Solo), 
a number of products are offered with 
additional functions. These products 
contain not only the detergent but also  
rinse-aid and salt replacement substances  
(3in1) and, depending on...

en
14
The max. possible number of programmes is illustrated 
in this overview. 
The corresponding programmes for your appliance can be  found on the fascia.
Programme selection
You can select a suitable programme  
according to the type of utensils and  
degree of soiling.
Information for test institutes
Test institutes can request the conditions  
for running comparison tests by sending  
an e-mail to  
[email protected].  
Quote the appliance number (E­Nr.) 
and the production date (FD)...

en
15
* depending on model 
Additional options can be set with the  
buttons 
X.
Express
 W
ash
/ S
peed
 P
e
rf
ec
t (
Var
io
Speed)Ÿ  Express Wash/ Speed Perfect/
(VarioSpeed) *
This function can reduce the running time  
by approx. 20% to 50% depending on the  
selected rinse programme. The change in  
the running time is indicated on the digital 
display H. To obtain optimum cleaning 
results at a reduced running time, water  
and energy consumption are increased.
Ha
lf lo
ad§  Half load *
If you...

en
16
T
im
er
 p
rogramm
in
gTimer programming *
* depending on model 
You can delay the start of the programme  
in 1-hour steps up to 24 hours. 
– Close the door. 
–Switch on ON/OF F switch ( .
– Press button  P until the digital 
display  H jumps to  œ:‹‚ .  
– Press button  P until the displayed 
time corresponds with your  
requirements.
– Press START button  @, timer 
programming is activated.
– To delete the preselected starting time,  press the button  P until  œ is 
indicated on the digital...

en
17
Changing the programme
When the START button @ has been 
pressed, the programme cannot be  
changed. 
The only way a programme can be  
changed is by Cancel programme (Reset).
Intensive drying
The final rinse uses a higher temperature 
which improves the drying result. The 
running time may increase slightly.  
(Caution if utensils are delicate!) 
– Close the door. 
–Switch on ON/OF F switch ( .
– Press and hold down the START button  @ .
– Rotate programme selector 8 
until š:‹‹  is indicated on...

en
18
Filters
The filters 1R keep large foreign objects 
in the rinsing water away from the pump.  
These foreign objects may occasionally 
block the filters. 
The filter system consists of a coarse filter,  
a flat fine filter and a microfilter. 
– After each washing cycle check the  filters for residue.
– Unscrew filter cylinder as illustrated  and take out filter system.
– Remove any residue and clean filters  under running water.
– Re-install filter system in reverse  sequence and ensure that the...

en
19
The majority of  faults which could occur in  
daily operation can be rectified by the 
user. This ensures that the appliance is  
quickly available for use again. The  
following overview will help you locating 
the causes and gives helpful advise to 
eliminate them. 
Note 
If the appliance stops during dishwashing  
or does not start for no obvious reason, 
first run the Abort programme function 
(Reset).  
(See chapter entitled “Dishwashing”)
ã=Warning
If on the digital display  H an error code...

en
20
... when the appliance is  
switched on
The appliance does not start.
– The mains fuse has tripped. 
– The appliance plug has not been inserted.
– The appliance door has not been shut  properly.
... on the appliance
Lower spray arm rotates sluggishly. 
– Spray arm blocked. 
The door is difficult to open. * 
– Child-proof lock is activated. The deactivation instructions are at the  
back in the envelope. 
* depending on model
Door cannot be closed. 
– D o o r  l o c k  h a s  b e e n  a c t iv a t e...