Siemens Smv 40e10 Operating Instructions

en
11
Small accessories holder *Sma
ll a
ccessor
ie
s
 h
o
ld
er
* depending on model 
Light-weight plastic accessories, e.g. cups,  
lids, etc. can be held securely in the small  
accessories holder.
Knife shelf *Kn
ife
 she
lf
* depending on model 
Long knives and other utensils can be  
arranged horizontally.
Ad
ju
s
tin
g
 th
e
 h
e
ig
h
t o
f
 th
e
 b
asketAdjusting the height of the 
basket *
* depending on model 
If required, the height of the upper utensils  
basket  1 can be adjusted to provide...

en
12
Top basket with side levers
– Pull out the top basket 1 out. 
–To  lower the basket, press in the left 
and then the right lever on the outside  
of the basket. In doing so, hold the  
sides of the basket along the upper 
edge to prevent it from suddenly 
dropping.
–To  raise the basket, hold the basket on 
the sides of the upper edge and lift it  
up.
– Before re-inserting the basket again,  ensure that it is at the  same height on 
both sides. Otherwise, the appliance  
door cannot be closed and...

en
13
Adding detergent
– If the detergent dispenser 9 is still 
closed, press the lock  9* to open the 
detergent dispenser. 
Pour detergent into the dry detergent  
dispenser 9 only (insert tablet flat, 
not on its edge). 
Dosage: see manufacturer’s  
instructions on the packaging.  
The graduated detergent  
dispenser 9 helps you add the 
correct amount of powder or liquid  
detergent. 
Usually 20 ml–25 ml are adequate  
for normal soiling. If using tablets, one  
tablet is adequate.
– Close the cover...

en
14
Notes 
– You will obtain optimum rinsing 
and drying results by using solo  
detergents and applying salt and rinse 
aid separately.
– If programmes are short, tablets  may not have full cleaning effect due to  
different dissolving properties 
and there may even be undissolved 
detergent residue. It is recommended  
to use washing powder for these  
programmes.
– The Intensive programme (on some  models) requires one tab only. When  
using washing powder, you can apply  
some of this cleaning...

en
15
The max. possible number of programmes is illustrated 
in this overview. 
The corresponding programmes for your appliance can be  found on the fascia.
Programme selection
You can select a suitable programme  
according to the type of utensils and  
degree of soiling.
Information for test institutes
Test institutes can request the conditions  
for running comparison tests by sending  
an e-mail to  
[email protected].  
Quote the appliance number (E­Nr.) 
and the production date (FD)...

en
16
* depending on model 
Additional options can be set with the  
buttons 
8.
Express
 W
ash
/ S
peed
 P
e
rf
ec
t (
Var
io
Speed)Ÿ  Express Wash/ Speed Perfect/
(VarioSpeed) *
This function can reduce the running time  
by approx. 20% to 50% depending on the  
selected rinse programme. To obtain  
optimum cleaning and drying results at a 
reduced running time, water and energy  
consumption are increased.
Ï  Intensive zone *Inte
ns
iv
e
 z
on e
Perfect for a mixed load. You can wash  
very soiled...

en
17
T
im
er
 p
rogramm
in
gTimer programming *
* depending on model 
You can delay the start of the programme  
by 3, 6 or 9 hours. 
–Switch on ON/OF F switch ( .
– Keep pressing the Preselected starting  time button  0 until the appropriate 
display 3h, 6h or 9h is lit.
– Press START button  h, timer 
programming is activated.
– To delete the preselected starting time,  keep pressing the Preselected starting  
time button  0 until none of the 
displays 3h, 6h or 9h is lit. 
You can change your...

en
18
Term
in
a
tin
g
 th
e
 p
r
og r
am meTerminating the programme  
(Reset)
– Open the door.
– Press START button  h for approx. 
3sec. 
The Cleaning display  X goes out.
– Close the door.
The remaining programme sequence  
lasts approx. 1 minute more. (Buzzer  
sounds.)
– Open the door. 
– Switch off ON/OFF switch  (.
– Close the door.
Changing the programme
When the START button  h has been 
pressed, the programme cannot be  
changed. 
The only way a programme can be  
changed is by Cancel programme...

en
19
Filters
The filters 1R keep large foreign objects 
in the rinsing water away from the pump.  
These foreign objects may occasionally 
block the filters. 
The filter system consists of a coarse filter,  
a flat fine filter and a microfilter. 
– After each washing cycle check the  filters for residue.
– Unscrew filter cylinder as illustrated  and take out filter system.
– Remove any residue and clean filters  under running water.
– Re-install filter system in reverse  sequence and ensure that the...

en
20
The majority of  faults which could occur in  
daily operation can be rectified by the 
user. This ensures that the appliance is  
quickly available for use again. The  
following overview will help you locating 
the causes and gives helpful advise to 
eliminate them. 
Note 
If the appliance stops during dishwashing  
or does not start for no obvious reason, 
first run the Abort programme function 
(Reset).  
(See chapter entitled “Dishwashing”)
ã=Warning
Don’t forget: Repairs may be carried out...