Siemens Sf 25t252 Eu Instructions For Use

en21
Maintenance
 and care
A  regular inspection and maintenance
of your machine will help to prevent faults. This saves time and prevents problems. Therefore you should occasionally have a careful look inside your dishwasher .
Overall  condition
of the machine
Check  spray arm for grease and
limescale deposits.
If you find such deposits:
Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which hasthe highest wash temperature.
Clean the appliance with...

en
22
Spray
 arms
Lime  and remnants of food in the washing
water can block the nozzles in the spray arms 
22  and 23 and the arm
mountings .
Inspect the nozzles in the spray arms for blocked holes due to remnants offood.
If necessary , pull the lower arm 23
upwards and lift it of f.
Unscrew the upper spray arm 22.
Clean both spray arms under running 
water.
Refit the spray arms. Ensure that the lower arm has locked into place and the upper one is screwed tight. Pump
 *
*  on applicable models
Larger...

en23
Fault
 finding
Resolving  minor problems
yourself Experience  has shown that you can
resolve most problems that arise during normal daily usage yourself, without having to call out a service engineer . Not
only does this save costs, but it alsomeans that the appliance is available for use again that much sooner . The following
list of common occurrences and their remedies should help you identify the causes of most problems. Problems  ...
Attention
Remember:  Repairs may be
carried out by a...

en
24
W ater remains inside appliance
after programme has ended
Blockage or kink in drainage hose.
Pump is jammed.
Filters are blocked.
The programme is still running. W ait for the programme to end
(numerical display will indicate 0).
Perform ªResetº function.
...  during washing
Unusual  amount of foam is created
Normal washing up liquid has been poured into the rinse-aid
container.
Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during the next washing cycle....

en25
Dishes, cutlery , etc. have not been
dried
Selected programme did not include drying function.
Amount of rinse-aid was set too 
low.
Items were removed from dishwasher too soon.
Glasses have a dull appearance
Amount of rinse-aid was set too 
low.
T ea stains or traces of lipstick have
not been completely removed
Detergent does not have a suf ficient bleaching ef fect.
Washing temperature was set too
low.
T races of rust on cutlery
Cutlery is not suf ficiently rustproof.
Salt content in washing water...

en
26 Information
Notes  on comparison tests
You  will find details of the conditions for
the comparison tests on the additional ºNotes on comparison testsº sheet. The consumption values for the relevant programmes are given in the introduction. General
Built-under and integrated appliances which are subsequently installed as free-standing appliances must be secured to prevent them from falling over , e.g. by screwing them to the wall
or by installing them under a continuous worktop which is screwed to...

en27
Fresh
 water connection
Using  the enclosed parts, connect the
fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection isnot kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply . The old supply hose must
not be re-used. W ater pressure:
Minimum 0,05 MPa (0,5 bar) ± maximum 1 MPa (10 bar). If the water pressure is higher , install a
pressure reducing valve. Flow rate:Minimum...

en
28
Protection
 from freezing
temperatures If  the appliance is installed in a location
where there is a risk of freezing temperatures (e.g. in a holiday home), all water must be completely drained out ofthe interior (see ªT ransporting the
dishwasherº). T urn OFF the tap, disconnect the supply
hose and allow to drain. Waste
 disposal
Disposal Old  appliances are not worthless rubbish.
V aluable raw materials can be reclaimed
by recycling old appliances. Pull out the mains plug of the redundant...

en29
Disposal
 of the packaging
Please dispose of the packaging
material in an environmentally friendly manner .
Keep children away from shipping carton and packaging components. Danger of suf focation from folding
cartons and plastic film.
 Corrugated cardboard consists mainly of wastepaper .
 The moulded polystyrene parts donot contain anychlorofluorohydrocarbons.
 The polyethylene film (PE) consistspartly of secondary raw materials.
 The wooden frames (if fitted) aremade of untreated residual wood....

en
30
en Subjekt to modification