Home > Siemens > Dishwasher > Siemens Se 25m276 Eu Instructions For Use

Siemens Se 25m276 Eu Instructions For Use

    Download as PDF Print this page Share this page

    Have a look at the manual Siemens Se 25m276 Eu Instructions For Use online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 428 Siemens manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							en21
    ...
     with the dishes, cutlery , etc.
    Remnants of food are stuck to the
    dishes, cutlery , etc.
    Dishwasher was not loaded properly. Jets of water could not
    reach all parts of the dishes, etc.
    T oo many items in the rack.
    Items in the rack were touching each other .
    Not enough detergent was added to dispenser .
    Selected wash programme was not intensive enough.
    Rotation of spray arm was obstructed by dish, etc.
    Nozzles in spray arm are blocked by remnants of food.
    Filters are blocked.
    Filters have been incorrectly fitted.
    Waste-water pump is jammed.
    Plastic items are discoloured
    Not enough detergent was added to dispenser .
    White stains are left on crockery ,
    glasses have a milky appearance
    Not enough detergent was added to input compartment.
    Amount of rinse-aid was set too 
    low.
    Although water is quite hard, no salt has been put in appliance.
    W ater softener was set too low .
    Lid on salt container is not screwed tight.
    If you used a phosphate-free detergent, try a detergent containing phosphates and compare results.
    Dishes, cutlery, etc. have not been
    dried
    Selected programme did not include drying function.
    Amount of rinse-aid was set too 
    low.
    Items were removed from dishwasher too soon.
    Glasses have a dull appearance
    Amount of rinse-aid was set too 
    low.
    T ea stains or traces of lipstick have
    not been completely removed
    Detergent does not have a suf ficient bleaching ef fect.
    Washing temperature was set too
    low.
    T races of rust on cutlery
    Cutlery is not suf ficiently rustproof.
    Salt content in washing water is too high.
    Lid on salt container is not screwed tight.
    Too much salt was spilt while
    filling container .
    Glasses become clouded and discoloured; coating cannot be wiped off
    Unsuitable detergent was used.
    Glasses are not dishwasher-proof.
    Smears left behind on glasses and cutlery; glasses have acquired a metallic appearance
    Amount of rinse-aid set too high.
     
    						
    							en
    22 Customer
     Service
    Please  call your local service agent, if you
    are not able to resolve any problem yourself. The name of your nearest service agent is shown in the Customer Service address list. When you call, please provide details of the model number (1) and the production (FD) number (2) which are shown on the nameplate 
    31 on the
    appliance door.
    FD
    1 2
    Attention
    Please note that a visit by the customer service technician in the event of a fault or one of the problems previously discussedis not free of charge even during the
    warranty period.
    Information
    Notes  on comparison tests
    You  will find details of the conditions for
    the comparison tests on the additional ”Notes on comparison tests” sheet. The consumption values for the relevant programmes are given in the introduction. General
    Built-under and integrated appliances which are subsequently installed as free-standing appliances must be secured to prevent them from falling over , e.g. by screwing them to the wall
    or by installing them under a continuous worktop which is screwed to the adjoining units.
    For Swiss version only: The appliance can be installed without dif ficulty between wooden and plastic
    walls in a kitchen range. If the applianceis not connected via a plug, theinstallation side must feature an all-pole disconnector with a contact gap of at least 3 mm in order to satisfy the relevant safety regulations.
     
    						
    							en23
    Installation
    The dishwasher must be connected by a qualified technician to ensure correctoperation. The specifications for supply ,
    drainage and connected load must fulfilthe required criteria as stated in the following paragraphs or in the installation instructions. Install the appliance in the following sequence: – Check the delivery – Install the appliance – Connect the waste water – Connect the fresh water– Connect the power supply Delivery Y our dishwasher was checked at the
    factory to ensure that it was in perfect working order . This may have left some
    small water stains in the dishwasher .
    These will disappear after the first rinse cycle. Installation The required installation dimensions can be found in the installation instructions. Using the height-adjustable feet, adjust the appliance until it is level. Ensure that the appliance is standing firmly .
    Waste  water connection
    See  the installation instructions for the
    required connection steps. If required, attach a siphon with drainage spigot. Using the enclosed parts, connect the waste water hose to the drainage spigot of the siphon. Ensure that the drainage hose is notkinked, crushed or twisted (ensure that there is no sealing cover which prevents the waster water from flowing away!). Fresh
     water connection
    Using  the enclosed parts, connect the
    fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection isnot kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply . The old supply hose must
    not be re-used. W ater pressure:
    Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10 bar). If the water pressure is higher , install a
    pressure reducing valve. Flow rate:Minimum of 10 litres per minute.W ater temperature:
    W e recommend that you use cold water .
    If you do use hot water , the temperature
    should not exceed 60  °C.
    Electrical  connection
    Connect  the appliance only to 230 V
    alternating current via a correctly installed socket with protective conductor .
    See rating plate for required fusing 
    31 . 
    The socket must be attached near the dishwasher and be freely accessible. The connection may be modified by an electrician only .
    Use only a residual-current-operated circuit-breaker which features the 
    symbol. Only this circuit breaker guarantees compliance with the currently valid regulations. Removing  the appliance
    It  is essential, when removing the
    appliance, to observe the following sequence: First, disconnect the appliance from the power supply .
    Pull out the mains plug.T urn of f the water supply .
     
    						
    							en
    24
    Disconnect the waste water and fresh water connections. Loosen the fastening screws under the worktop. If fitted, remove the base panel. Pull out the appliance, carefully pulling thehose behind. 
    Transporting
     the dishwasher
    Drain  water from the dishwasher . Secure
    all loose parts. The appliance should only be transported in an upright position.
    If the appliance is not kept upright during transport, any water left inside may seep into the control module andcause subsequent errors with programme functions.
    The appliance must be drained in the following sequence:
    T urn on the tap.
    Close the door .
    Set main switch to ON.
    Select the B programme. The
    programme duration in minutes is shown in the numerical display .
    Wait for approximately 4 minutes.
    Terminate the programme by
    pressing 
    A  and C
    simultaneously.
    The time display changes to .
    W ait a further minute and then
    switch the appliance of f.
    Turn of f the tap.
    Protection  from freezing
    temperatures If  the appliance is installed in a location
    where there is a risk of freezing temperatures (e.g. in a holiday home), all water must be completely drained out of the interior (see “T ransporting the
    dishwasher”). T urn OFF the tap, disconnect the supply
    hose and allow to drain. Waste
     disposal
    Disposal Old  appliances are not worthless rubbish.
    V aluable raw materials can be reclaimed
    by recycling old appliances. Pull out the mains plug of the redundant appliance. Cut of f the power cord and
    discard with mains plug.T o prevent children from locking
    themselves in the appliance and suf focating, destroy the door lock
    and childproof lock (if fitted). Y ou received your new appliance in
    a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environmentby disposing of packaging materials in an environmentally-friendly manner . All plastic
    parts of the appliance are identified byinternationally standardised symbols (e.g. >PS< polystyrene).When the appliance is being disposed of, the plastic waste can be sorted for environmentally-friendly recycling. Please ask your dealer or inquire at your local authority about current means of disposal.
      
    						
    							en25
    Disposal
     of the packaging
    Please dispose of the packaging
    material in an environmentally friendly manner .
    Keep children away from shipping carton and packaging components. Danger of suf focation from folding
    cartons and plastic film.
     Corrugated cardboard consists mainly of wastepaper .
     The moulded polystyrene parts donot contain anychlorofluorohydrocarbons.
     The polyethylene film (PE) consists partly of secondary raw materials.
     The wooden frames (if fitted) are made of untreated residual wood.
     The hoops (if fitted) consistof polypropylene (PP).
    Disposal  of redundant
    appliances
    Make  redundant appliances unusable
    to prevent subsequent accidents.
    Dispose of the appliance in an environmentally friendly manner .
    Warning
    Children could become locked in the appliance (risk of suf focation) or find
    themselves in other dangerous situations. Therefore: Pull out the mains plug, sever and dispose of the power cord. Destroy the door lock so that the door can no longer be closed.
    This appliance is labelled in accordance with European Directive 2002/96/EG concerning used electrical and electronic appliances (waste electrical and electronicequipment – WEEE). The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU.
      
    						
    							en
    26
    en Subjekt to modification
     
    						
    							40 Switch on the child-proof lock 
    41 Open the door with child-proof lock switched on
    42 Switch of f the child-proof lock When the door is open, the child-proof lock of
    fers no protection.
    Child-proof
     lock *
    Large sheets or grilles and plates which have a diameter greater than 30 cm (gourmet
    plates, pasta plates, dinner plates) can be cleaned with the aid of the spray head. T o do this, remove the top basket and insert the spray head as illustrated in the diagram.
    T o ensure that the spray jet can reach all parts, arrange the baking sheets as illustrated
    (max. 4 baking sheets and 2 grilles). Never operate the dishwasher without the top basket or baking sheet spray head!
    Baking
     sheet spray head *
    * some models
        
    						
    							-+- !--)000,&,!., +-    	
         
    	  
    
     
    (-  ))%%  -(  ))%,  0-!(.-  *.4-()
      -(  -(  0++-2  %&,   ,-  -!  ,%%+  ,  (  -!  ,%,   +&-      -(
    -(  (.+  ))%  0++-2  0  ,!%%  +)%  -!  ))%  .+  -!  (%%(0   (-(,
    	    &   ,  .,  2  0-+  .  -(    &%.-(  (  (.+  *.4-()  ,2,-&  0,!%% 
    &$   ((  -!  &     -!  ,  (  )+/-  (,.&+,
    
      !,  %%-2  0++-2  ,  /%  (+  -!  ,+/  %  (  -!  ))% 
      !  0++-2  %&  ,  ,.#-  -(  (++-  ,-%%-(    (-(  (  -!  ))%   (+  0-!  (.+  ,-+.-(,  3!,  %,(  %.,  (++-  ,-%%-(  (  -!  *.4-() 
    1-,(  (+ %  ,,(+2  .+  0++-2  (,  (-  (/+  -/  ,.))%2  %,  (+ 
    -- ,  .)  -(  -!  *.4-()  (-(  (  -!  -)
        )+)%  -  ,  (-  ,,+2  -(  &(-(+    ))%  --  0-!  *.4-()  .+  ()+-(  (+  -(  ,.+  -  -+0+,  2  -.+   (  -!  -)  (.  ,!(.%  (%2  -.+  (  -!  -) 
      2(.  +  ,-  +(&  !(&  (+    )+(%(   )+(     (  !(%2  (+  ,/+%  0$,
    Siemens–Electrogeräte  GmbH
    Carl–W ery–Straße 34
    81739 München T o contact us directly , use the tel. no or fax no. in the
    enclosed customer service list.
     
    						
    All Siemens manuals Comments (0)

    Related Manuals for Siemens Se 25m276 Eu Instructions For Use