Siemens Se 20t593 Eu Instructions For Use

en31
Maintenance  and care
A regular inspection and maintenance of your machine will help to prevent faults. This saves time and prevents problems. Therefore you should occasionally have 
a careful look inside your dishwasher. 
Overall  condition of the machine
Check spray arm for grease and limescale deposits.
If you find such deposits:
Fill the detergent dispenser with detergent, start the appliance without utensils in the programme which hasthe highest wash temperature.
Clean the appliance with...

en
32
Reassembly: Insert the filter system and screw down 
with the filter cylinder.Spray arms 
Lime and remnants of food in the washing water can block the nozzles in the spray arms 
23  and 24 and the arm
mountings .
Inspect the nozzles in the spray arms for blocked holes due to remnants of food.
If necessary, pull the lower arm 24
upwards and lift it off.
Unscrew the upper spray arm 23 .
Clean both spray arms under running 
water.
0
1
2
3
Refit the spray arms. Ensure that the lower arm has locked into...

en33
Pump * *
 on applicable models
Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of the dishwasher and it can be seen 
covering the filter. Proceed as follows:
First, always disconnect the appliance 
from the power supply.
Ladle out as much water as possible.
Remove the filters 26 .
Undo the screw in the cover (Torx T 20) 
and remove the cover.
Inspect the inside and remove any...

en
34
The device does not start.
A fuse in the house is defect.
The device is not properly plugged in.
The device’s door is not closed 
properly.
The device’s door was closed without first starting the programme.
Some time after the programme start a continuous acoustic signal sounds. 
The device does not draw water. When the door is opened the message “Check water supply” is displayed.
Mains water tap is not opened.  Open the tap fully and press the button M/OK 
2  of the device.
Then close the device’s...

en35
... during washing
Unusual amount of foam is created
Normal washing up liquid has been poured into the rinse-aid 
container.
Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during the next washing cycle.
Appliance stops suddenly while washing is taking place
Cut in electricity supply to appliance.
Water supply has been interrupted.
Knocking sound can be heard while washing is taking place
A spray arm is knocking against the dishes inside the appliance....

en
36
Dishes, cutlery, etc. have not been dried
Selected programme did not include drying function.
Amount of rinse-aid was set too 
low.
Items were removed from dishwasher too soon.
Glasses have a dull appearance
Amount of rinse-aid was set too 
low.
Tea stains or traces of lipstick have not been completely removed
Detergent does not have a 
sufficient bleaching effect.
Washing temperature was set too 
low.
Traces of rust on cutlery
Cutlery is not sufficiently rustproof.
Salt content in washing water is...

en37
Notes
Disposal of your old appliance 
Old appliances are not worthless rubbish. 
Valuable raw materials can be reclaimed by recycling old appliances. Pull out the mains plug of the redundant 
appliance. Cut off the power cord and discard with mains plug. 
To prevent children from locking themselves in the appliance and
suffocating, destroy the door lock and childproof lock (if fitted). 
You received your new appliance in a protective shipping carton. All packaging materials are environmentally...

en
38 Installation
The dishwasher must be connected by a qualified technician to ensure correct 
operation. The specifications for supply, drainage and connected load must fulfil the required criteria as stated in the following paragraphs or in the installation instructions. Install the appliance in the following sequence: – Check the delivery – Install the appliance – Connect the waste water – Connect the fresh water– Connect the power supply Delivery 
Your dishwasher was checked at the factory to...

en39
Removing the appliance 
It is essential, when removing the appliance, to observe the following sequence: First, disconnect the appliance 
from the power supply. Pull out the mains plug. 
Turn off the water supply. Disconnect the waste water and fresh water connections. Loosen the fastening screws under the worktop. If fitted, remove the base panel. Pull out the appliance, carefully pulling the hose behind. 
Transportation Empty the dishwasher according to the following steps:
Turn on the tap.
Switch...

en
40
Disposal of the packaging
Please dispose of the packaging material in an environmentally 
friendly manner. Keep children away from shipping carton and packaging components. 
Danger of suffocation from folding cartons and plastic film.
 Corrugated cardboard consists 
mainly of wastepaper.
 The moulded polystyrene parts donot contain any chlorofluorohydrocarbons.
 The polyethylene film (PE) consists partly of secondary raw materials.
 The wooden frames (if fitted) aremade of untreated residual wood....