Siemens Se 20t090 Instructions For Use

							en31
General
Built-under and integrated appliances which are subsequently installed as free-standing appliances must be secured to prevent them from fallingover
, e.g. by screwing them to the wall
or by installing them under a continuousworktop which is screwed to the adjoining units.
For Swiss version only: The appliance can be installed without dif ficulty between wooden and plastic
walls in a kitchen range. If the appliance is not connected via a plug, the installation side must feature an all-pole disconnector with a contact gap of at least 3 mm in order to satisfy the relevant safety regulations. Installation
The dishwasher must be connected bya qualified technician to ensure correctoperation. The specifications for supply ,
drainage and connected load must fulfilthe required criteria as stated in the following paragraphs or in the installation instructions. Install the appliance in the following sequence: – Check the delivery – Install the appliance – Connect the waste water – Connect the fresh water– Connect the power supply Delivery Y our dishwasher was checked at the
factory to ensure that it was in perfect working order . This may have left some
small water stains in the dishwasher .
These will disappear after the first rinse cycle. Installation The required installation dimensions can be found in the installation instructions. Using the height-adjustable feet, adjust the appliance until it is level. Ensure that the appliance is standing firmly .
Waste  water connection
See  the installation instructions for the
required connection steps. If required, attach a siphon with drainage spigot. Using the enclosed parts, connect the waste water hose to the drainage spigot of the siphon. Ensure that the drainage hose is not kinked, crushed or twisted (ensure that there is no sealing cover which prevents the waster water from flowing away!).
 
						

							en
32
Fresh
 water connection
Using  the enclosed parts, connect the
fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection isnot kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply . The old supply hose must
not be re-used. W ater pressure:
Minimum 0,05 MPa (0,5 bar) – maximum 1 MPa (10 bar). If the water pressure is higher , install a
pressure reducing valve. Flow rate:Minimum of 10 litres per minute.W ater temperature:
W e recommend that you use cold water .
If you do use hot water , the temperature
should not exceed 60  °C.
Electrical  connection
Connect  the appliance only to 230 V
alternating current via a correctly installed socket with protective conductor .
See rating plate for required fusing 
33 . 
The socket must be attached near the dishwasher and be freely accessible. The connection may be modified by an electrician only .
Use only a residual-current-operated circuit-breaker which features the 
symbol. Only this circuit breaker guarantees compliance with the currently valid regulations. Removing
 the appliance
It  is essential, when removing the
appliance, to observe the following sequence: First, disconnect the appliance from the power supply .
Pull out the mains plug. T urn of f the water supply .
Disconnect the waste water and fresh water connections. Loosen the fastening screws under the worktop. If fitted, remove the base panel. Pull out the appliance, carefully pulling the hose behind. 
Transportation Empty the dishwasher according to the following steps:
T urn on the tap.
Switch on the appliance.
Start any automatic programme and close the appliance door .
Wait until approx. 4 minutes have
elapsed.
Then open the door , terminate
the programme and close the door to drain the appliance.
W ait until the buzzer is emitted 5 times,
i.e. all the water has been drained.
Switch of f the appliance.
Turn of f the tap.
Secure loose parts prior to transportation. T ransport the appliance upright only .
Otherwise, residual water may penetrate the control and damage the appliance. Protection  from freezing
temperatures If  the appliance is installed in a location
where there is a risk of freezing temperatures (e.g. in a holiday home), all water must be completely drained out of the interior (see “T ransporting the
dishwasher”). T urn OFF the tap, disconnect the supply
hose and allow to drain.
 
						

							en33
Waste
 disposal
Disposal Old  appliances are not worthless rubbish.
V aluable raw materials can be reclaimed
by recycling old appliances. Pull out the mains plug of the redundant appliance. Cut of f the power cord and
discard with mains plug.T o prevent children from locking
themselves in the appliance andsuf focating, destroy the door lock
and childproof lock (if fitted). Y ou received your new appliance in
a protective shipping carton. All packaging materials are environmentally friendly and recyclable. Please contribute to a better environmentby disposing of packaging materials in an environmentally-friendly manner . All plastic
parts of the appliance are identified byinternationally standardised symbols (e.g. >PS< polystyrene).When the appliance is being disposed of, the plastic waste can be sorted for environmentally-friendly recycling. Please ask your dealer or inquire at your local authority about current means of disposal. Disposal  of the packaging
Please dispose of the packaging
material in an environmentally friendly manner .
Keep children away from shipping carton and packaging components. Danger of suf focation from folding
cartons and plastic film.
 Corrugated cardboard consistsmainly of wastepaper .
 The moulded polystyrene parts donot contain any chlorofluorohydrocarbons.
 The polyethylene film (PE) consists partly of secondary raw materials.
 The wooden frames (if fitted) aremade of untreated residual wood.
 The hoops (if fitted) consist of polypropylene (PP). Disposal
 of redundant
appliances
Make  redundant appliances unusable
to prevent subsequent accidents.
Dispose of the appliance in an environmentally friendly manner .
Warning
Children could become locked in the appliance (risk of suf focation) or find
themselves in other dangerous situations.Therefore: Pull out the mains plug, severand dispose of the power cord. Destroy the door lock so that the door can no longer be closed.
This appliance is labelled in accordance with European Directive 2002/96/EG concerning used electrical and electronic appliances (waste electrical and electronic equipment – WEEE). The guidelinedetermines the framework for the return and recycling of used appliances as applicable throughout the EU.
  
						

							en
34
en Subjekt to modification
 
						

							40 Switch on the child-proof lock 
41 Open the door with child-proof lock switched on
42 Switch of f the child-proof lock When the door is open, the child-proof lock of
fers no protection.
Child-proof
 lock *
Large sheets or grilles and plates which have a diameter greater than 30 cm (gourmet
plates, pasta plates, dinner plates) can be cleaned with the aid of the spray head. T o do this, remove the top basket and insert the spray head as illustrated in the diagram.
T o ensure that the spray jet can reach all parts, arrange the baking sheets as illustrated
(max. 4 baking sheets and 2 grilles). Never operate the dishwasher without the top basket or baking sheet spray head!
Baking
 sheet spray head *
* some models
    
						

							&,*&,  ,,(///+!%&+ -+*,  

  
  &   
	  

 
&,  (($!$  ,  (($!&+  /!, -,  )-3,(
&  !,!&  ,  /**&,1  $!%+  !&+,  ,   +$$*  +  &  ,   +$+  *%&,  &  !&  !,!&
,  -*  (($!&  /**&,1  /  + $$  *($  ,   (($!&  -&*  ,   $$/!&  &!,!&+
	    %  !+  -+  1  /,*  -  ,    %$-&,!&    -*  )-3,(  +1+,%  /
+ $$ 
%#    ,   %  !&  ,   +    (*!.,  &+-%*+

   !+  $!!$!,1  /**&,1  !+  .$!  *  ,   +*.!  $!    ,   (($!& 
     /**&,1  $!%  !+  +-,  ,  **,  !&+,$$,!&  &  &&,!&    ,   (($!&  !& *&  /!,   -*  !&+,*-,!&+  2 !+  $+  !&$-+  **,  !&+,$$,!&    ,   )-3,( 
0,&+!&  *!!&$  ++*1  -*  /**&,1  +  &,  .*  ,!.  +-(($1  $!&+  * 
!,,!&+  -(  ,  ,   )-3,(  &&,!&  &  ,   ,(
  &  (*!&!($  !,  !+  &,  &++*1  ,  %&!,*  &  (($!&  !,,  /!,   )-3,(  -*!& (*,!&  *  ,  +-*  !,  ,*/*+  1  ,-*&!&    ,   ,(  -  + -$  &$1  ,-*&    ,   ,( 
!  1-  *  +&,  *%   %  *    (*$&  (*!    &   $!1  *  +.*$  /#+
Siemens–Electrogeräte  GmbH
Carl–W ery–Straße 34
81739 München T o contact us directly , use the tel. no or fax no. in the
enclosed customer service list.