Sharp Projector Pg F261x User Manual
Here you can view all the pages of manual Sharp Projector Pg F261x User Manual. The Sharp manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 61
59 Appendix OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or ERR OK or...
Page 62
60 RS-232C Specifications and Command Settings (Continued) CONTROL CONTENTSPower ONStandby mode (or 30-second startup time)COMMAND PARAMETERRETURN Auto Power Off Auto Restart STANDBY Mode PRJ Mode Language Setup Guide System Sound Internal Speaker RGB Frequency Check Fan Mode Lamp Timer Reset *3 On Off On Off Standard Eco Reverse Invert English Deutsch Español Nederlands Français Italiano Svenska Português polski Türkçe On Off On Off On Off Horizontal Vertical Normal High OK or ERR OK or ERR OK...
Page 63
61 Appendix DTV Computer Computer Compatibility Chart • Multiple signal support Horizontal Frequency: 15-70 kHz, Ve rtical Frequency: 45-85 Hz, The following is a list of modes that conform to VESA. However, this projector supports other signals that are not VESA standards. 27.0 31.5 37.5 27.0 31.5 37.9 27.0 31.5 27.0 31.5 37.9 26.2 31.5 34.7 37.9 37.5 43.3 31.4 35.1 37.9 46.6 48.1 46.9 53.7 40.3 48.4 56.5 60.0 68.7 45.0 47.7 62.7 47.6 47.8 55.0 66.2 67.5 64.0 64.0 34.9 49.7 60.2 68.7 60 70 85 60 70 85...
Page 64
62 Troubleshooting ProblemCheck •P rojector power cord is not plugged into the wall outlet. • Power to the external connected devices is off. •The selected input mode is wrong. •Cables are incorrectly connected to the projector. •Remote control battery has run out. •External output has not been set when connecting notebook computer. •The lamp unit cover is not installed correctly. • If the connected DVI digital equipment is turned on before the “DVI-D” input mode is selected on the projector, the image...
Page 65
63 Appendix Problem Maintenance indicator on the projector illuminates or blinks in red. The projector cannot be turned on or put into the standby mode using STANDBY/ON on the projector. Picture is green on COMPUTER (Component)/ DVI (Component). Picture is pink(no green) on COMPUTER (RGB)/ DVI (RGB). Picture is too bright and whitish. The cooling fan becomes noisy. The lamp does not light up even after the projector turns on. The lamp suddenly turns off during projection. The image sometimes flickers....
Page 66
64 For SHARP Assistance If you encounter any problems during setup or operation of this projector, first refer to the “Troubleshooting” section on pages 62 and 63. If this operation manual does not answer your question, please contact the SHARP Service departments listed below. U .S.A. Sharp Electronics Corporation 1-888-GO-SHARP (1-888-467-4277) [email protected] http://www.sharpusa.com Canada Sharp Electronics of Canada Ltd. (905) 568-7140 http://www.sharp.ca Mexico Sharp Electronics Corporation...
Page 67
65 Appendix Specifications As a part of policy of continuous improvement, SHARP reserves the right to make design andspecification changes for product improvement without prior notice. The performance specifica-tion figures indicated are nominal values of production units. There may be some deviations from these values in individual units. Model Display device Resolution Lens Input terminal Output terminal Control, others Speaker Projection lamp Rated voltage Rated frequency Input current Po wer...
Page 68
66 Dimensions Units: inches (mm) 10 7/16 (265) 3 33/64 (89) 1 31/64 (37.65) 2 5/8 (66.35) 2 61/64 (75) 10 41/64 (270) 2 3/8 (60) 1/4 (6) M4M4 M4M4 4 7/64 (104) 1 15/16(49) 13/32 (10)13/32 (10) 1 3/16(30) 2 61/64 (75) 1 27/64(36)
Page 69
67 Appendix Accessor ies............................................................. 10 AC soc ket................................................................ 24 Adjustment buttons ................................................. 37 Aspect ratio ............................................................. 30 A udio Input .............................................................. 43 A UDIO 1, 2 terminal ................................................ 23 AUDIO OUT terminal...
Page 70
