Sharp Fus51aw Manual

ENGLISH
FU-S51EFU-S51A
AIR PURIFIER
OPERATION MANUAL
R
Free Standing
*Plasmacluster is a trademark ofSharp Corporation.
*Plasmacluster 是聲寶公司的商標 

     Please read before operating your new Air Purifier
The air purifier draws in room air from its air intake, lets the air pass through a
Active Carbon Filter (deodorization filter) and a HEPA Filter (dust collection
filter) inside of the unit, then discharges the air from its air outlet. The air
purifier unit repeats this process by moving its internal fan.
As air passes through, a new HEPA Filter can remove 99.97% of dust parti-
cles, of as small as 0.3 microns. The Active Carbon Filter gradually...

ENGLISH
FEATURES
ION SHOWER
E-1
ENGLISH
Thank you for purchasing the SHARP Air Puri-
fier. Please read this manual carefully for the cor-
rect usage information. Before using this prod-
uct, be sure to read the section: “Important Safety
Instructions.”
After reading this manual, retain it in a conven-
ient location for future reference.
IMPORTANT SAFETY INSTRUCTIONS ....E-2
•WARNING ....................................................E-2
•CAUTIONS CONCERNING OPERATION ...E-3
•INSTALLATION GUIDELINES...

E-2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should be followed, including the
following:
WARNING - To reduce the risk of electrical shock, fire or injury to persons:
•Read all instructions before using the air purifier.
•Use only a 220 volt outlet with a polarized receptacle.
•Do not use the air purifier if the power cord or plug is damaged or the connection to the wall
outlet is loosened.
•Periodically remove dust from the power plug.
•Do not insert...

ENGLISH
E-3
CAUTIONS CONCERNING OPERATION
•Do not block the intake and air outlet.
•Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into
contact with steam.
•Do not lay the unit down when using.
•Always hold the handle on the back of the unit when moving it.
Holding the front panel when carrying may cause it to detach, thus dropping the unit and resulting in
bodily injury.
•Do not operate the unit without the filter.
•Do not wash and reuse HEPA filter .
It not...

E-4
PART NAMES
MAIN UNIT DISPLAY
ILLUSTRATIVE  DIAGRAM
Odour Sensor Date Label
Main Unit
HEPA Filter
(blue / white)
Filter Support
Front Panel
Washable Active 
Carbon Filter
AUTO Operation Indicator Light
Pollen Mode Indicator Light
Fan Speed  Indicator Lights
Plasmacluster Ion Mode 
Indicator Lights
Plasmacluster Ion Mode 
Selection Button
Mode Selection Button
ION SHOWER Indicator Light
ION SHOWER Mode Button
POWE 

ENGLISH
E-5
INCLUDED
•Operation manual
BACK
Blue light
When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmaclus-
ter Ion Mode and the air in the room is impure, the light will be activated and the
unit will operate in Clean Mode.
Green light
When the Plasmacluster ion operation is in the Ion Control  Mode during AUTO
Plasmacluster Ion Mode and the air in the room is clean, this light will be activated
and the unit will operate in Ion Control Mode.
Cycles of blue and green
When the...

PREPARATION
To maintain the quality of the filters, they are installed in the main unit and packed in
plastic bags. Be sure to remove the filters from the plastic bags before using the unit.
Remove the filters
Remove the Front Panel.
E-6
Be sure to remove the power plug from the wall outlet.
FILTER INSTALLATION
Remove the Filter Support.
Pull the Front Panel on the
lower sides, and lift up.
4 2 1
3
Front Panel
(At open)1
5
Push in the hooks on top, then pull the Filter Support.
Remove the HEPA Filter....

ENGLISH
Ta b
(blue)
E-7
2 1
3
4
5
)
2Install the filters
Place the HEPA Filter into the
main unit.
Do not install the filter backwards or the
unit will not operate properly.
Place the Filter Support
through the bands (2 places)
located at the corners of the
Active Carbon Filter.
Replace the Filter Support and Active
Carbon Filter back to the main unit.
Fill in the usage start date on the
Date Label.
Use the date as a guide for the Filter
Replacement schedule.
Replace the Front Panel.
Date Label
HEPA...

OPERATION
MAIN UNIT OPERATION
E-8
Power ON/OFF Button
•Used to start operation (short beep) and stop operation (long beep)
•Plasmacluster Indicator Light and Fan Speed Indicator Light turn on/off.
•Unless unplug the power cord, the operation starts in the previous mode the
unit was operated in.
•When stop operation during ION SHOWER Operation, the unit will back to the
prior operation of ION SHOWER Operation.
MODE Selection Button
•The operation mode can be switched.
AUTO operation
The fan speed is...