Schwinn Journey 45 Manual

							11
3. 
Connect the Cable and Attach the Console Mast to Frame Assembly
 NOTICE : 		Do	not crimp Console Cable.
18
1
12
B
D
G
6mm
X4  
						

							12 4. Attach Legs to Frame Assembly
10
16
AC
G
F
X2
X2
6mm  
						

							13
5. Attach Arm Pivot Rod and Lower Handlebar Arms to Frame Assembly
19
3
7
C
G
E
F
X2
X213 mm  
						

							14 6. Attach Left Pedal to Frame Assembly
 NOTICE :		Repeat	step	on	opposite	side	with	the	Right	Pedal	(Item	17	).
F
A
C G
8
17
C HG
A
6mm  
						

							15
7. Attach and Adjust the Upper Handlebar Arms to Frame Assembly
 
Note:			Hardware	is	pre-installed	and	not	on	the	Hardware	Card.	*
Make	sure	the	Upper	Handlebar	Arms	are	secure	before	you	exercise.
6mm
20
6
* *
*
X8  
						

							16 8. Attach Handlebar Shrouds to Frame Assembly
 Note:			Hardware	is	pre-installed	and	not	on	the	Hardware	Card.	*
15
14
15
14
I
#2
X4  
						

							17
9. Route Cables and Attach the Static Handlebar to Frame Assembly
 NOTICE :
		Do	not	crimp	the	Console	Cables.
2
*
X3
6mm
*
*  
						

							18 10. Attach Water Bottle Holder to Frame Assembly
 Note:			Hardware	is	pre-installed	and	not	on	the	Hardware	Card.	*
4
#2
*
X3  
						

							19
12. Connect Cables and Attach Console to Frame Assembly
 NOTICE :
		Align	the	clips	on	the	cable	connectors	and	make	sure	the	connectors	lock.	Do	not	crimp cables.  
11. Remove Hardware from Console
 NOTICE :		Do	not	crimp	the	cable.
  Note:			Hardware	is	pre-installed	and	not	on	the	Hardware	Card.	*5
*
X4
#2
5
*
X4  
						

							20 13. Connect the Power Cord to Frame Assembly
Connect	this	machine	to	a	properly	grounded	outlet	only	(see	Grounding	Instructions).
21
14. Final Inspection
Inspect your machine to ensure that all hardware is tight and components\
 are properly assembled.
Be sure to record the serial number in the field provided at the front\
 of this manual.
Do not use until the machine has been fully assembled and inspected for correct per formance in accordance with the Owner’s 
Manual.