Sanyo Lcd 32xa2 Instruction Manual

							INSTRUCTION MANUAL
LCD Colour TelevisionLCD-27XA2
LCD-32XA2
P
Please read this Instruction Manual before using your television.
We wish you many hours of pleasure from your new television.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 1
 
						

							2 2
Warnings and Cautions
Minimum Distances
5 cm
10 cm
10 cm10 cm
Warning
High voltages are used in the operation of this
television receiver. Do not remove the cabinet
back from your set. Refer servicing to quali-
fied service personnel.
Do not drop or push objects into the televi-
sion cabinet slots or openings.
Never spill any kind of liquid on the television
receiver.
Caution
Avoid exposing the television receiver to direct
sunlight and other source of the heat.
If the television is to be built into a compartment
or similarly enclosed, the minimum distances
must be maintained. Heat build-up can reduce the 
Do not block the ventilation holes in the back
cover. Adequate ventilation is essential to prevent
failure of electrical components
.
Cleaning the TV Monitor
Do not pressDo not hit
Be sure to disconnect the AC Power Cord from
AC outlet before cleaning the TV monitor.
Gently wipe the screen
and cabinet with dry soft
cloth. Screen is likely dam-
aged if it is not maintained
properly. Do not use hard
cloth or paper. Do not use
solvents or abrasive.
Do not use benzene, thin-
ner or any volatile sub-
stances to clean the TV
monitor. These chemicals
may damaged the cabinet
finish.
Caution
Care for Using TV Monitor
Screen likely damaged by external shock. When
using the TV monitor, following precautions
should be taken.
Do not press or hit the screen face.
Do not write, paint or affix anything on the screen.
Do not put anything on the TV monitor. service life of your television, and can also be
dangerous.
If the LCD panel is broken and leaks liquid
crystal, do not touch it. Moreover, never swal-
low or suck the liquid, or touch the liquid with
your skin. In case the liquid drops in your
mouth or eyes, clear it by water adequately at
once and go to see a doctor. If not, there is a
possibility causing poisoning. If the liquid
drops on skin or clothes, also clear it by water
adequately at once, if not, the skin or clothes
will be damaged. To prevent fire or electrical shock hazard, do
not expose the television receiver to rain or
moisture.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 2
 
						

							ANT.75Ω
Installation
3 3
Step 1 : Connecting the Aerial and Power Supply
•Connect your aerial cable plug to the rear of the TV set.
For further information please consult your local dealer.
•Connect the AC power plug to the wall socket (AC100-264 Volts, 50Hz/60Hz).
Note:The form of the AC code and AC plug are different with each country.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 3
 
						

							4 4
Installation
Step 3 : Switching on/Plug & Play
Use 2 “AAA” 1.5 volt batteries.
Be sure batteries are installed correctly.
Note:Do not mix old batteries with new ones or mix different type of batteries together.
Step 2 : Battery Installation of the Remote Control Transmitter
Let’s start ! Let’s start !
This TV set provides a self-automatic tuning system function called “Plug & Play”.
It automatically begins searching and storing of all available channels when switching-on the
TV set for the first time.
1 1Press the Power ON/OFFbutton to turn the TV on, and the TV set will search and store of
all available TV channels automatically.
2 2After completing Plug & Play, press the MENUbutton  to return to the normal TV mode.
✐ This procedure only appears at the first switch-on time.
Now the installation is completed ! 
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 4
 
						

							Control Panel
5 5
P
Each button listed this section has the same function as it’s corresponding button on the
Remote Control
Programme
Up/Down
Power ON/OFF
button
Remote Control
DetectorStand-by and
Power Indicator
Volume
P
360˚
Do not position hand under the screen frame
while rotating the TV.
Caution
Viewing Angle Adjustment
Swivel stand is rotated 360˚ right and left.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 5
 
						

							CS
6 6
Remote Control Transmitter
TV/AV Selector
Recall/Colour System
Numeric buttons
Digit
TEXT/TV Stereo/Mono
BASS
Power ON/OFF
Sound Mute
Wide
Alternate
Volume +/-
Picture Mode
SURROUND
MENU
To select the next or previ-
ous programme position.
Digital Shot
TIMER
DVD button
Programme Up/Down
Sound Mode
CS button
OK button
Cursors 
These buttons are not used.
VCR and DVD button
To call up the List screen of
the Digital Shot. To increase or decrease the
sound volume level.
Press repeatedly to switch to
TV, AV1, AV2, AV3, AV4 or
AV5 mode.
Red
Green
YellowBlue
To call up the Timer menu
directly.
To select half mute, full
mute or restore the sound.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 6
 
						

							7 7
General Operation
Press the Power ON/OFFbutton to
turn on or off (Stand-by) the TV set.
Power ON/OFF(Stand by)  Power ON/OFF(Stand by) 
Auto Shut Of Auto Shut Of
f Function f Function
-/- -
Alter Alter
nate nate
Press the Alternatebutton, and the
programme position will alternately
select the previous position and the
present position.
Pictur Pictur
e Mode Selection e Mode Selection
Press the Picture Modebutton
repeatedly to select the following
picture modes;
Personal :Your personal preference mode.
Standard:Normal viewing mode.
Dynamic:Suitable for brightly lit room.You can turn on the TV in the standby mode
by pressing the following buttons in addition
to the Power ON/OFFbutton.
●Programme Up/Down button of the 
remote control transmitter or the TV set.
●1to 9,0 button on the remote control 
transmitter.
If the TV is left on after you have gone to
sleep, the TV set changes to the standby
mode within 10 minutes after all broadcasts
have ended.
Lighting of the Stand-by and Power Indicator
shows that there is a power supply. For shut-
ting off a power supply completely, discon-
nect the power cord from the power outlet.
Bass Expander On/Of Bass Expander On/Of
f f
Press the BASSbutton to get an 
emphasised bass sound. Press the Sound Modebutton
repeatedly to select the following 
sound modes;
Personal:
Your personal preference mode.
Music:Suitable for music programme.
Ta l k :Suitable for news programme.
Normal:Normal listening mode.
Sound Mode Selection Sound Mode Selection
Active 3D Surr Active 3D Surr
ound ound
Press the SURROUNDbutton to
switch 3D Surround on (Active)
and off.
Dir Dir
ect Pr ect Pr
ogramme Selection ogramme Selection
Example:
■Press 6button to select programme 
position 6.
■ To select programme position 27, press 
the Digitbutton, press 0, 2then 7button.
or
Press the Digitbutton, press 2, 7button 
and wait for 5 seconds.
■ To select programme position 215, press 
the DIGIT button, press 2,1then 
5button.
-/- -
-/- --/- -
-/- --/- -
-/- -
-/- -
-/- --/- -
-/- -
-/- -
-/- --/- --/- --/- -
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 7
 
						

							8 8
General Operation
Pr Pr
ogramme Infor ogramme Infor
mation Call mation Call
To display the on screen indication, press
the Recall/Colour Systembutton.
A2 Ster A2 Ster
eo, NICAM Ster eo, NICAM Ster
eo eo
and Bilingual Br and Bilingual Br
oadcast oadcast
Receiving Receiving
■A2 Stereo and NICAM Stereo sound
reception
■ Bilingual reception
If the TV receives bilingual programs, the
TV initially selects language A and displays
“A” on the screen briefly. If you want to
switch to language B or Mono (only avail-
able in NICAM reception), press the Stereo/
Monobutton.
A2 Bilingual 
When receiving NICAM stereo broadcast,
NICAMwill be displayed on the screen. For
A2 (German) stereo broadcasts, Stereowill
be displayed. When a clear stereo sound
can not be obtained during NICAM or A2
(German)  stereo broadcast due to poor 
signal reception, press the Stereo/Mono
button to select mono mode.
NICAM Stereo
A2 Stereo
NICAM Bilingual 
Sound Status
Off-timerProgramme Position
Sound System
OFF  02:00
Mono
A
NICAM
AUTO
BG
Colour System Selection Colour System Selection
If the clear picture cannot be obtained, press
the Recall/Colour System button repeated-
ly until optimum image can be produced.
SECAM
NTSC4.43
A colour system entry to the memory can
not be made during TV mode, make it
during Semi-auto tuning mode.
NTSC
PA LAUTO
Colour System
Stereo
NICAM
Mono
B
Mono
AB
03
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 8
 
						

							Auto
It automatically switches to the optimum screen mode according to the WSSsignal provided
in the receiving signal source. If the signal does not have it, the TV keeps current screen mode.
This setting may cause the picture to change when a different format is received e.g. when an
advert is received.
WSS (Wide-Screen-Signalling)
This function is to be automatically set to the optimum screen mode for the wide screen 
television according to the aspect ratio bits of the picture format (16:9, 14:9, 4:3, etc.) on 
the receiving signal source. To use this function, the picture mode should be selected to 
the “Auto” mode. This function is also effective in the AV mode. When you connect AV 
equipment which has the WSSfunction, the screen mode is automatically selected to the 
optimum screen mode.Press the Wide button to select the following screen modes;
Auto/ Natural/ Zoom 14:9/ Title-in 14:9/ Zoom 16:9/ Title-in 16:9/ Full/
Normal
General Operation
9 9
Natural
Scr Scr
een Mode Selection een Mode Selection
Today there are various transmission formats with different size ratios, e.g. 4:3, 14:9, 16:9
and video format such as letterbox. 4:3 picture sometimes have a black band at the top and
bottom of the screen. You can select a screen mode to optimise the picture display.
4:3 14:9 16:9
Letterbox Video
Stretches the picture
horizontally to fill the
screen, the picture is
more stretched at the
edges.The height is expand-
ed to fill the whole
screen.The picture fills the
screen and is propor-
tionally correct.The black bars top
and bottom remain
and the height is
compressed to fit into
the picture area.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 9
 
						

							10 10
General Operation
Title-in 14:9
Zoom 16:9 Zoom 14:9
4:3 14:9 16:9
Letterbox Video
The correct picture
width is maintained
but the top and 
bottom are cropped.Zooms in slightly
cropping the top and
bottom.Zooms in slightly
cropping the top and
bottom.The black bars top
and bottom are small-
er and the picture
height is compressed
slightly.
TITLES ON SCREENTITLES ON SCREENTITLES ON SCREENTITLES ON SCREEN
4:3 14:9 16:9
Letterbox Video
As zoom (14:9), but
bottom is compressed
even more to allow
subtitles to be seen.As zoom (14:9), but
bottom is compressed
even more to allow
subtitles to be seen.As zoom (14:9), but
bottom is compressed
even more to allow
subtitles to be seen.As zoom (14:9), but
bottom is compressed
even more to allow
subtitles to be seen.
4:3 14:9 16:9
Letterbox Video
The correct picture
width is maintained
but the top and bot-
tom are cropped.Zooms in slightly
cropping the top and
bottom.Zooms in slightly
cropping the top and
bottom.The black bars top
and bottom are small-
er and the picture
height is compressed
slightly.
Inst. Manual_N2WW(UE2-A)  5/30/05 3:08 PM  Page 10