Samsung Television UNES7150 User Manual

differ depending on the program 
being broadcast or the broadcast 
signal.
SPDIF Output
Menu  → Sound
 
→  SPDIF Output
SPDIF (Sony Philips Digital Interface) 
provides digital audio output to speakers 
and various digital devices such as A/V 
Receivers and Home Theaters which 
reduces interference and distortion.
 
●Audio Format 

You can select the Digital Audio output 
(SPDIF) format. The available Digital 
Audio output (SPDIF) format may differ 
depending on the input source.
 
●Audio Delay
Lets you correct timing mismatches 
between the audio track and the video 
when you are watching the TV and 
listening to digital audio output from 
the TV through an external device such 
as an AV receiver. When you select the  

Audio Delay function, a slider screen 
appears. Adjust the option value using 
your remote (0ms ~ 250ms).
Speaker Settings
Menu  → Sound
 
→  Speaker Settings
 
●Speaker Select
If you are listening to the sound track 
of a broadcast or movie through an 
external receiver, you may hear a 
sound echo caused by the difference 
in decoding speed between the TV’s  

speakers and the speakers attached to 
your audio receiver. If this occurs, set 
the TV to External Speaker .
 
NWhen Speaker Select is set to 
External Speaker , the TV’s speakers 
are turned off. You will hear sound 
through the external speakers only. 
When the Speaker Select is set to  TV 
Speaker , both the TV’s speakers and 
the external speakers are on. You 
will hear sound through both. 

 
NWhen the Speaker Select is set to 
External Speaker , the volume buttons 
and mute functions will not operate 
and the sound settings will be 
limited.
 
NIf there is no video signal, both 
the TV’s speakers and the external 
speakers will be mute.
 
●Auto Volume
Because each station has its own 
broadcasting conditions, the volume  

may fluctuate each time you change 
the channel. This feature automatically 
adjusts the volume of a channel by 
lowering the sound output when the 
modulation signal is high or by raising 
the sound output when the modulation 
signal is low.
 
NTo use the volume control of a 
connected source device, set Auto 
Volume to Off . If Auto Volume is 
set to Normal or Night , adjusting  

the volume control of a connected 
source device may have no effect.
Reset Sound
Menu  → Sound
 
→  Reset Sound
Reset all sound settings to the factory 
defaults. 

Connecting to the NetworkThe Wired Network Connection There are three ways to attach your TV 
to your LAN using cable:
 
NFor illustrations of the three kinds of 
wired network connections, see your 
paper user's manual.
 
– You can attach your TV to your 
LAN by connecting the LAN port on 
the back of your TV to an external 
modem using a LAN cable.
Preference Feature 

 
– You can attach your TV to your LAN 
by connecting the LAN port on the 
back of your TV to a router which 
is connected to an external modem. 
Use LAN cable for the connection.
 
– You may be able to attach your TV 
to your LAN by connecting the LAN 
port on the back of your TV directly 
to a network wall outlet using a 
LAN cable. Note that the wall outlet 
is attached to a modem or router  

elsewhere in your house.
 
NIf your network requires a Dynamic 
IP address, you should use an ADSL 
modem or router that supports the 
Dynamic Host Configuration Protocol 
(DHCP). Modems and routers that 
support DHCP automatically provide 
the IP address, subnet mask, 
gateway, and DNS values your TV 
needs to access the Internet so you 
do not have to enter them manually.